Replace the force system acting on the frame by an equivalent resultant force, and specify where the resultant's line of action intersects member AB (Figure 1). Suppose that F₁ = 30 lb, F2 = 50 lb, and F3 = 60 lb. Figure F₂ 2 ft F₁ "H 5 ft 5 ft 1 of 1 Determine the magnitude of the resultant force. Express your answer in pounds to three significant figures. FR = Submit Part B 0 = Submit Determine the angle between the resultant force and the x axis. Express your answer in degrees to three significant figures. Π| ΑΣΦ | 11 | vec Part C 197| ΑΣΦ Request Answer y = vec Request Answer ? ? ? lb Specify where the resultant's line of action intersects member AB, measured from point A. Express your answer in feet to three significant figures. —| ΑΣΦ | 11 | vec| °, measured counterclockwise from the positive axis ft above A

Replace the force system acting on the frame by an equivalent resultant force, and specify where the resultant's line of action intersects member AB (Figure 1). Suppose that F₁ = 30 lb, F2 = 50 lb, and F3 = 60 lb. Figure F₂ 2 ft F₁ "H 5 ft 5 ft 1 of 1 Determine the magnitude of the resultant force. Express your answer in pounds to three significant figures. FR = Submit Part B 0 = Submit Determine the angle between the resultant force and the x axis. Express your answer in degrees to three significant figures. Π| ΑΣΦ | 11 | vec Part C 197| ΑΣΦ Request Answer y = vec Request Answer ? ? ? lb Specify where the resultant's line of action intersects member AB, measured from point A. Express your answer in feet to three significant figures. —| ΑΣΦ | 11 | vec| °, measured counterclockwise from the positive axis ft above A

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The forklift supports the engine. Determine the force that this load generates on element FB. Write your answer in Newtons. Consider Engine mass = 148 kg a = 1.47 m b = 2.21 m
The forklift supports the engine. Determine the force that generates this load on element DB. Write your answer in Newtons. Consider Engine mass = 114 kg a = 1.47 m b = 1.81 m
The figure below illustrates a hydraulic jack.a) Calculate the force F1 exerted by the operator to lift a load F2 of 104N, knowing that the diameter of the pump piston is 6 mm while the diameter of the load cylinder is equal to 25 mm. Answer: 576 N b) Determine the diameter of the load cylinder so that the force F1 is equal to 100 N. Answer: 0.06m
In a hydraulic press the large piston has a cross sectional area A1=200 sq. cm and the small piston has a cross sectional area A2=5 sq. cm. If the force is 250 N to the small piston. Compute the force acting on the large piston. a. 10 kN b. 12 kN c. 21 kN d. 20 kN
1. A museum of modern art is displaying an irregular 426-N sculpture by hanging it from two thin vertical wires, A and B, that are 1.25 m apart. The center of gravity of this piece of art is 48.0 cm from its extreme right tip. a). Find the tension in each wire. Show the step by step and complete solution. Draw also the complete FBD (as seen in the figure).
Given: F1=5 kN F2=12 kN F3=4 kN F4= 11 kN L=8 m Determine the force in member CF by the method of sections.
A. Three cable tensions T1, T2, and T3 act at the top of the flagpole. Given that the resultant force for the three tensions is R = 400 N downward, find the magnitude of the cable tension T3 in N. Answer: 220.34 B. Three cable tensions T1, T2, and T3 act at the top of the flagpole. Given that the resultant force for the three tensions is R = 400 N downward, find the magnitude of the cable tension T2 in N. Answer: 151.59 I need a solution
In the system shown, take F1 = 20kN, F2 = 40kN. a-) Calculate the force P that will keep the system in balance b-) Calculate the resultant force at the C point.
Three professional wrestlers are fighting over a champion’s belt, and each exerts a force on the belt. Wrestler 1 exerts a force F1 = 40.0 N in the +x-direction, wrestler 2 exerts a force F2 = 80.0 N in the -y-direction, and wrestler 3 exerts a force F3 = 60.0 N at an angle of 36.9° counterclockwise from the +x-direction. Find the xand y-components of the net external force on the belt, and find the force’s magnitude and direction.
Please specify which of the following forces are not conservative forces______. a. Reaction normal force b. Reaction friction force c. Linear Spring Force d. Weight
Show complete solutions and figures The diameters of the two cylinders A and B in the figure shown are 80 mm and 750 mm, respectively. The face of the piston is 1.2 m above the face of the weight platform. The space in between the piston and the weight is filled with oil (s.g.=0.80). If F=75 N, Determine the following: the value of Wrequired to maintain equilibrium. a) 38.6 N b) 86.3 N c) 63.8N d) 83.6 N e) None
The motorcycle weighs 151 kg and the driver weighs 64 kg. Dimensions l1 = 0,31 m ja l2 = 0,23 m Determine the support force on the rear tire.