Replace with mA=20 kg and mB=10kg for part a and b FIGURE 4-53 Problems 32 and 33. mB Mass ma rests on a smooth horizontal surface; mg hangs vertically. . (II) (a) If mA determine the acceleration of each block. (b) If initially ma is at rest 1.250 m from the edge of the table, how long does it take to reach the edge of the table if the system is allowed to move freely? (c) If mB must ma be if the acceleration of the system is to be kept at 100 8? 13.0 kg and mB = 5.0 kg in Fig. 4-53, %3D 1.0 kg, how large %3D

Replace with mA=20 kg and mB=10kg for part a and b FIGURE 4-53 Problems 32 and 33. mB Mass ma rests on a smooth horizontal surface; mg hangs vertically. . (II) (a) If mA determine the acceleration of each block. (b) If initially ma is at rest 1.250 m from the edge of the table, how long does it take to reach the edge of the table if the system is allowed to move freely? (c) If mB must ma be if the acceleration of the system is to be kept at 100 8? 13.0 kg and mB = 5.0 kg in Fig. 4-53, %3D 1.0 kg, how large %3D

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter5: Newton's Law Of Motion

Section: Chapter Questions

Problem 62P: Consider Figure 5.28. The driver attempts to get the car out of the mud by exerting a perpendicular...

See similar textbooks

Similar questions

A uniform push of 150 N, applied at an angle of 30 deg to a 20 kg block which rests on a horizontal surface, gives the block a velocity of 6.5 m/s in 4 s. Find the coefficient of kinetic friction.
In the design of a supermarket, there are to be several rampsconnecting different parts of the store. Customers will haveto push grocery carts up the ramps and it is desirable thatthis not be too difficult. The engineer has done a survey andfound that almost no one complains if the force requiredis no more than 18 N. Ignoring friction, at what maximumangle θ should the ramps be built, assuming a full 25-kg cart?
A 10.0 kg block on a table is connected by a string to a 63 kg mass, which is hanging overthe edge of the table. Assuming that frictional forces may be neglected, what is themagnitude of acceleration of the 10.0 kg block when the other block is released?
How long would it take a 2.30 × 10 3 kg truck to gofrom 22.2 m/s to a complete stop if acted on by a forceof -1.26 × 10 4 N?
A small package rest on the horizontal dashboard of a car. If us= 0.332, what the minimum acceleration of the car that will cause the package to slip off assuming that the is on a level read?
A ball of mass m = 1.6 kg hangs by a thread from the roof of an elevator. Thethread can withstand only a tension force of 20 N. When the system acceleratesupwards, see Fig. 5.43, the thread breaks. Within what range is the elevatoraccelerating?
Show that the acceleration of any object down an incline where friction behaves simply (that is, where fk=kN ) is a=g(sinkcos). Note that the acceleration is independent of mass and reduces to the expression found in the previous problem when friction becomes negligibly small (k=0).
A block is given an initial velocity of 5.00 m/s up a frictionless incline of angle = 20.0 (Fig. P5.47). How far up the incline does the block slide before coining to rest?
Calculate the maximum acceleration of a car that is heading up a 4.00slope (one that makes an angle of 4.00with the horizontal) under the following road conditions. Assume that only half the weight of the car is supported by the two drive wheels and that the coefficient of static friction is involved—that is, the tires are not allowed to slip during the acceleration. (Ignore rolling.) (a) On wet concrete. (b) On wet concrete. (C) On ice, assuming that s=0.100 , the same as for shoes on ice.
Check Your Understanding One end of a 3.0-m rope is tied to a tree; the other, end is tied to a car stuck in the mud. The motorist pulls sideways on the midpoint of the rope, displacing it a distance of 0.25 m. If he exerts a force of 200.0 N under these conditions, determine the force exerted on the car.
Why does an ordinary rifle recoil (kick backward) when fired? The barrel of a recoilless rifle is open at both ends. Describe how Newton's third law applies when one is fired. Can you safely stand close behind one when it is fired?
Paleontologists estimate that if a Tyrannosaurus rex had tripped and fallen, the ground would have exerted anormal force of approximately 260,000 N on its torso as it landed.Assuming the torso has a mass of 3800 kg, (a) find the magnitudeof the torso’s upward acceleration as it comes to rest. (For comparison, humans lose consciousness with an acceleration of about 7g.)(b) Assuming the torso of a T. rex is in free fall for a distance of 1.46m as it falls to the ground, how much time is required for the torsoto come to rest once it contacts the ground?