Requir nation NOTE: This isa multi-part question. Once an answer is submitted, you will be unable to return to this part. A 20-kg cabinet is mounted on casters that allow It to move freely (u- 0) on the floor. %3! 0.9 m -0,6 m If a 190-N force is appled as shown, determine the range of values of h for which the cabinet will not tip. Range of values of h mshs

Requir nation NOTE: This isa multi-part question. Once an answer is submitted, you will be unable to return to this part. A 20-kg cabinet is mounted on casters that allow It to move freely (u- 0) on the floor. %3! 0.9 m -0,6 m If a 190-N force is appled as shown, determine the range of values of h for which the cabinet will not tip. Range of values of h mshs

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.66P: A uniform 80-ft pipe that weighs 960 lb is supported entirely by a cable AB of negligible weight....

See similar textbooks

Similar questions

The homogeneous 240-lb bar is supported by a rough horizontal surface at A, a smooth vertical surface at B, and the cable BC. Draw the FBD of the bar and count the unknowns.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
The 80-kg crate has its center of gravity at G. Determine the smallest force P that will initiate motion if =35.
The spring attached to the homogenous bar of weight W is undeformed when =0. Determine the smallest spring stiffness k for which the =0 equilibrium position will be stable. Use W = 10 lb, a = 24 in., and b = 6 in. Assume that the spring remains horizontal, which is a valid approximation if is small.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
Draw the FBD for the bar described in Prob. 5.1 if the bar is homogeneous of mass 50 kg. Count the unknowns.
The 14-kN weight is suspended from a small pulley that is free to roll on the cable. The length of the cable ABC is 20 m. Determine the horizontal force P that would hold the pulley in equilibrium in the position x=5m.
A uniform 80-ft pipe that weighs 960 lb is supported entirely by a cable AB of negligible weight. Determine the length of the cable and the maximum force in the cable. (Hint: First locate the point O where the cable is tangent to the pipe.)
The 180-lb homogeneous bar is supported by a ball-and-socket joint at A and two cables attached to B. Determine the forces in the cables.
The device shown is an overload prevention mechanism. When the force acting on the smooth peg at D reaches 1.2 kN, the peg will be sheared, allowing the jaws at C to open and thereby releasing the eye-bolt. Determine the maximum value of the tension P that can be applied without causing the eyebolt to be released. Neglect friction.