Resistors, 10 ohms and 15 ohms, are connected in series. The power being consumed by the 10-ohm resistor is 22.5 watts. Determine the following: the value of the voltage source energizing the circuit; (5 points) the power being dissipated by the 15-ohm resistor if the two resistors were to be connected in parallel using the same source; (5 points)

Resistors, 10 ohms and 15 ohms, are connected in series. The power being consumed by the 10-ohm resistor is 22.5 watts. Determine the following: the value of the voltage source energizing the circuit; (5 points) the power being dissipated by the 15-ohm resistor if the two resistors were to be connected in parallel using the same source; (5 points)

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter15: Residential Air-conditioning Control Systems

Section: Chapter Questions

Problem 23RQ

See similar textbooks

Similar questions

Resistors, 10 ohms and 15 ohms, are connected in series. The power being consumed by the 10-ohm resistor is 22.5 watts. Determine the following: the value of the voltage source energizing the circuit; the power being dissipated by the 15-ohm resistor if the two resistors were to be connected in parallel using the same source; NOTE Use the appropriate unit of measurement; observe the best applicable engineering notation and Greek prefix. Wrong unit of measurement will make the final answer wrong. Box your final answers. Express your answers accurate to four decimal places.
If they are defined as Vs=2V and Is=12A, respectively, in the circuit given below, how many volts will the Vx node voltage be? TIP: You might consider solving it with the Node Method. NOTE: Please enter your answer as 1 digit after the comma. Help me please... Thank you so much.
construct the circuit with resistor nominal value of 91ohms, 220ohms, 330ohms, and 470 ohms.
Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C what is the answer? VD?
A 30-volt source battery is connected in series with the 6-load resistors namely 1 ohm, 2 ohms, 3 ohms, R ohms, 5 ohms, and 6 ohms respectively. If the total power is 30 watts, find the value of R in resistance and its current drawn as well as the total resistance (a) provide solution (b) provide circuit diagram
Voltage Drop! Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C. what is the Voltage Drop ? Answer?
Find all the currents, voltages and delivered/ consumed powers of each circuit element.
Using nodal analysis, what is the power absorbed by the 2-ohms resistor?
Using a circuit analysis technique of your choosing, calculate the mesh currents of the system at midday, when the solar panel delivers its rated current. Show all working. Calculate the voltage across and the power generated by the solar panel. Calculate the power delivered to the battery (including internal resistance), and the LED lights including their series resistors. What power is dissipated in the wiring? Check the power balances in your circuit.
An electric boiler has two heating elements each of 230V, 3.5kW rating and contains 8L of water at 30 deg C. Assuming 10%loss of heat from the boiler, find how long after switching on the heater circuit, will the water boil a atmospheric pressure if the two elements of the heaters are in series.
A house has the following specifications for a circuit. Determine the size of the circuit breaker, wire, and size of pipe to be used for each circuit and the service entrance. Show computation and tabulate final answer.1. 15 lighting outlets2. 1 kitchen range3. 12 lighting outlets4. 1 water heater at 1500 watts5. 12 convenience outlet6. 8 convenience outlet7. 9 convenience outlet8. 12 lighting outlet9. 3 convenience outlet10. spare-1500 watts11. spare- 1500 watts
Please show a complete step-by-step solution. Thank youGive your final answers in at least 2 decimal places - make it 3 or 4 decimal places whenever required in the problem. If you are doing a step by step calculation, maintain 6 decimal places in your in-between calculations to hit good accuracy in your final answers. Use 1 hp = 746 Watts in your conversion whenever necessary. A 110-hp, three-phase, wye-connected, 50-Hz, 460-V, four-pole, cylindrical-rotor synchronous motor is operating at rated conditions and 88 percent power-factor leading. The efficiency, excluding field and stator losses, is 95 percent, and the synchronous reactance is 2.81 Ohms/phase. Determine the developed torque in lb-ft. Give your final answer in 2 decimal places. Correct Answer: 405.42 ± 0.01