Resonance in an AC circuit is uniquely characterized by which of the following? A. Minimum resistance B. Minimum reactance C. Minimum impedance D. Minimum power output Unpolarized light passes through a polarization filter oriented at 20° relative to the vertical. It then passes through a second polarization filter, oriented at 80° from the vertical, in the same direction as the first. The intensity of light leaving the second filter in terms of the initial intensity I, is A. 1o B. 10/2

Resonance in an AC circuit is uniquely characterized by which of the following? A. Minimum resistance B. Minimum reactance C. Minimum impedance D. Minimum power output Unpolarized light passes through a polarization filter oriented at 20° relative to the vertical. It then passes through a second polarization filter, oriented at 80° from the vertical, in the same direction as the first. The intensity of light leaving the second filter in terms of the initial intensity I, is A. 1o B. 10/2

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 76PQ: In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating...

See similar textbooks

Similar questions

An RLC series circuit has a 200 (resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is 45.0°. (a) What is the impedance? (b) Find the circuit’s capacitance. (c) If Vrms = 408 V is applied, what is the average power supplied?
A 60.0-ft resistor is connected in series with a 30.0-F capacitor and a source whose maximum voltage is 120 V, operating at 60.0 Hz. Find (a) the capacitive reactance of the circuit, (b) the impedance of the circuit, and (c) the maximum current in the circuit. (d) Does the voltage lead or lag the current? (e) How will adding an inductor in series with the existing resistor and capacitor affect the current? Explain.
Review. A radar transmitter contains an LC circuit oscillating at 1.00 1010 Hz. (a) For a one-turn loop having an inductance of 400 pH to resonate at this frequency, what capacitance is required in series with the loop? (b) The capacitor has square, parallel plates separated by 1.00 mm of air. What should the edge length of the plates be? (c) What is the common reactance of the loop and capacitor at resonance?
An RLC circuit connected across an AC voltage source at frequency f has resistance R, capacitive reactance XG and inductive reactance XL. If the frequency is doubled so that fnew = 2f, find the ratios (a) Rnew/R, (b) XC,new/XC, and (c) XL,new/XL.
A transformer may be used to provide maximum power transfer between two AC circuits that have different impedances Z1 and Z2. This process is called impedance matching. (a) Show that the ratio of turns N1/N2 for this transformer is N1N2=Z1Z2 (b) Suppose you want to use a transformer as an impedance-matching device between an audio amplifier that has an output impedance of 8.00 k and a speaker that has an input impedance of 8.00 . What should your N1/N2 ratio be?
An 80.0- resistor and a 200-mH inductor are connected in parallel across a 100-V (rms), 60.0-Hz source. (a) What is the rms current in the resistor? (b) By what angle does the total current lead or lag behind the voltage?
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
The lowest frequency in the FM radio band is 88.0 MHz. (a) What inductance is needed to produce this resonant frequency if it is connected to a 2.50 pF capacitor? (b) The capacitor is variable, to allow the resonant frequency to be adjusted to as high as 108 MHz. What must the capacitance be at this frequency?
An RLC series circuit hag a 1.00 k(register, a 150 (H inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) It the voltage source has Vrms = 408 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
The following statements are related to an RLC circuit connected across an AC power source. Choose the words that make each statement true. (i) The voltage across the [(a) capacitor; (b) inductor] leads the current by 90. (ii) The voltage across the [(c) capacitor; (d) resistor] is in phase with the current. (iii) At resonance, the phase angle between the current and the voltage [(e) is 0; (f) depends on frequency f]. (iv) The maximum and rms voltages from the power source are related by [(g) Vmax = 2 Vrms,; (h) Vmax = Vrms/2].
In addition to phasor diagrams showing voltages such as in Figure 32.15, we can draw phasor diagrams with resistance and reactances. The resultant of adding the phasors is the impedance. Draw to scale a phasor diagram showing Z, XL, XC, and for an AC series circuit for which R = 300 , C = 11.0 F, L = 0.200 H, and f = 500/ Hz.
The following statements are related to an RLC circuit connected across an AC power source. Choose the words that make each statement true. (i) The voltage across the [(a) capacitor; (b) inductor] leads the current by 90. (ii) The voltage across the [(c) capacitor; (d) resistor] is in phase with the current. (iii) At resonance, the phase angle between the current and the voltage [(e) is 0; (f) depends on frequency f]. (iv) The maximum and rms voltages from the power source are related by [(g) Vmax = 2 Vrms,; (h) Vmax = Vrms/2].