Answered: response. Quèstion 3 In half wave…

response. Quèstion 3 In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True False Moving to another question will save this response.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter22: Resistive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1PP

See similar textbooks

Related questions

Q: Full-Wave Rectifier We can analyze the behavior of the half-wave rectifier and full-wave rectifier…

Q: Identify the type of diode, which is having the reverse recovery times t, and ts are equal value. O…

A: Schottky diode is a majority carrier device. It is a higher frequency device due to no diffusion…

Q: Q7/ Assuming an ideal diode, sketch vi, va, and ia for the half-wave rectifier in the figure below.…

A: The solution is given below

Q: For the resistive inductive load and free welling diode single phase fully controlled half wave…

A: Half-wave rectifier: Half-wave rectifier allows one half cycle and blocks other half cycle of the…

Q: 5) For a single phase full wave bridge rectifier with a resistive load if the input voltage is 125…

Q: For the resistive inductive load and free welling diode single phase fully controlled half-wave…

A: Half-wave rectifier: Half-wave rectifier allows one half cycle and blocks other half cycle of the…

Q: For the half-wave rectifier, the source is a sinusoid of 120 V rms at a frequency of 60 Hz. The load…

Q: Q3Design a controlled half wave rectifier circuit to produce an average voltage of 30 V across a…

Q: Q explain briefly with drawing the principal of zener region operation and the applications of zener…

A: consider the given circuit;

Q: A single phase fully controlled rectifier has RL load. Write the following a) Draw its circuit…

A: Figure below shows the circuit diagram and the waveforms of a single phase fully controlled halfwave…

Q: A full-wave rectifier is connected to a single-phase source and supplying an inductive load. For the…

A: Part (1): For the full-wave rectifier, four diodes are required in the bridge connection. To remove…

Q: By comparing other diodes, reverse recovery time of general purpose diode is higher. Select one:…

Q: A full Wave rectifier shown in the circuit has 120V (rms) 50 Hz input through a transformer. RL = 2k…

A: Given: Input at primary of transformer, Vprms=120 V RL=2 kΩ

Q: Complete design an electronic circuit to produce bridge full wave rectifier with decrement…

A: Given Vin = 50 sin(wt) We have to design an best electronic circuit to produce bridge full wave…

Q: Q3) If one of the diodes for the single-phase rectifier is damaged as shown, the output voltage will…

Q: How many diodes conduct in the Full-Wave Bridge Rectifier with filter, while the capacitor is being…

A: An device which convert alternating signal in to pulsating direct signal. The half wave rectifier…

Q: Q12. In center-tapped rectifier, there are more stresses on the diodes compared to half wave single…

A: As per BARTLEBY GUIDELINES, I answered three questions (Q-12, Q-13, Q-14) and repost other…

Q: Problem 1. Consider a half-wave rectifier circuit with a resistive load of 25 Ωand a 60 Hz ac…

Q: The voltage signal coming out of the capacitor is with small ripples compare to the voltage signal…

A: Yup,the statement is true. The capacitor smoothes the voltage waveform

Q: Q4) Attempt to answer ONE branch only: a) Regarding ripple vector parameter, What are the…

Q: Prove that the RMS output voltage of Half-wave rectifier with resistive load Vrms = Vs/2

Q: You are presented with the following controlled rectifier configurations: Configuration Тоpology…

A: We have to determine smallest firing angle that result in discontinuous current flow in load for…

Q: Determine the a.c. ripple voltage across the load of full wave rectifier which delivers 40 W to a…

Q: 3. Bridge type Power Supply with Capacitor 12V AC Ripple D₂ C Charges Bridge Rectifier D₁ (a) Output…

A: It is given that:

Q: Full-wave rectified sine wave circuit is used to measure the RMS value of a half square wave with…

Q: d) A three-phase rectifier can operate with different load types at the output. One possibility is…

A: Given & to find: d) A three-phase rectifier can operate with different load types at the output.…

Q: Bypass diodes are connected in parallel with a solar cell to prevent the discharge of current from…

A: Given data:

Q: A sinusoidal voltage v,(t) = 20 sin wt is passed through half wave rectifier. Find 1) The period T.…

Q: A PMMC meter rated at 50µA is used in a rectifier type of instrument which uses full wave…

Q: A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 kΩ. Find the…

A: Determine the value of the peak voltage at the input. Vrms=Vm2 Substitute the value and solve as,…

Q: A half-wave rectifier is connected to a 8910 load in parallel with a capacitor, if the supply…

A: Given : In the given question they have mentioned a half wave rectifier with a RC filter. Here…

Q: 2. A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…

Q: The diode that has a metal-to-semiconductor junction and used in fast-switching is: Select one: a.…

A: Schottky diode is a semiconductor diode formed by the junction of a semiconductor with a metal. It…

Q: Implement the following function using diodes, pull up resistors and pull down resistors. F2(A, B,…

A: The given expression is in POS form (product of sum). It is seen that in order to implement the…

Q: A. Explain the difference between charging current and faradaic current.

A: As per bartleby guideline for more than one question asked only first is to be answered. Please…

Q: Half-Wave Rectifier We can analyze the behavior of the half-wave rectifier and full-wave rectifier…

Q: For the half wave rectifier shown, determine input power factor & ripple factor for a firing angle a…

A: Solution: For α=90°Input pf=π-α+sin2α2π=π-π2+0π=12 lagging Average value of output voltage for…

Q: Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the…

A: Given Output voltage = Vdc=20V Current=0.5A Resistance=R= 20/0.5 = 40 ohm Frequency= 50 Hz Ripple…

Q: General Purpose Diodes are mostly preferred in chopper circuits. Is it True? Justify. ( short…

Q: A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 250 mA.…

A: Given, Half wave rectifier having Average load current IL=250 mA Peak to peak ripple required Vr=0.2…

Q: Find the average and rms values of the sinusoidal voltage measured at the output of full-wave…

A: Given: Full wave rectifier output To do: we have to compute the average and rms values of the…

Q: A single-phase rectifier has a resistive load of 15 Q. Determine the rms current and the peak…

Q: During the positive input loop shown in the figure, which diodes does the conduction path pass…

A: Fig: Given full wave bridge rectifier

Q: In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases.…

A: In this question we need to verify the given statement is true or false

Q: Three Phase Uncontrolled Half Wave Rectifiers find the value of Voltage and Currents (output de and…

A: For the Three Phase Uncontrolled Half Wave Rectifiers find the value of Voltage and Currents (output…

Q: 2. A Half-Wave rectifier with a capacitor filter (capacitance is 4700 uF) supplies to a load an…

A: The given information about a half-wave rectifier with a capacitor filter: Average load voltage is…

Q: By comparing other diodes, reverse recovery time of general purpose diode is higher. Select one:…

A: There are many types of diodes namely, 1. General Purpose Diodes. 2. Fast Recovery Diodes. 3.…

Q: In a full wave rectifier ac voltmeter the meter movement has an internal resistance of 250 Ω and…

Q: A Half-Wave rectifier with a capacitor filter (capacitance is 4700 µF ) supplies to a load an…

Q: A single phase uncontrolled half wave rectifier with a highly inductive load has an RL load. It has…

A: In the question, A single phase uncontrolled half wave rectifier with a highly inductive load has an…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is not a requirement for an electric circuit? a. a source b. a path c. a load d. a signal light
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Electronics circuits Pls show the solution step by step. Thank you. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak value of 48 V. If the load is 500 Q and the ripple factor is no more than 8%, which of the following capacitors can be used? Support your choice(s)a) 0.68 µF, 50 V b) 680 mF, 25 V c) 62 µF, 75 V d) 560 µF, 75 V
This is a half-wave rectifier with a filter capacitor & a 60Hz ACE line input of R = 120Ω, C = 470µF. 1.) Where does the resistor comes from in segment 1 and 2? a. Capacitor, Diode b. Diode, Diode c. Diode, Capacitor d. Capacitor, Capacitor 2.) Assuming that the peak voltage Vmax across the capacitor is 16V and the capacitor discharges into the resistor for 12msec. (1) Determine the time constant of the circuit (in ms) during the discharge? (2) Determine the voltage Vmin (in volts) across the capacitor.
For the input voltage Vi in the figure, we calculate the output voltage as Show by drawing over the period. (Note: used diode is silicon diode, ideally will not be evaluated.)
For a half-wave rectifier that converts 60Hz AC to 12V DC voltage with no more than 1% ripple at a load current of 1A, the required capacitance of the filter capacitor should be at least ________F.
2. Connecting a capacitor at the output of a rectifier will serve as a a) Filter b) Charge storage device c) Bypass capacitor d) non of the above 3. In a half-wave rectifier , peak value of the output waveform is always a) Equal to the input wave b) Higher than the input wave c) Less than the input wave d) it depends upon diode 4. RMS value calculation involves which of the foolowing steps. a) Square root of all the values, taking mean, and then squaring b) Squaring all the values, taking means and then square root c) Squaring all the values, sqauare root them,and then taking means d) none of these 5. In full-wave rectifier, peak value of the output wave is always. a) Equal to the input wave b) Higher than the input wave c) Less than the input wave d) it depends upon the diodes