Rf Rx Vin W D2 本 Ry V1- ZRL

Q: An inductive circuit of resistance of 2 ohms and inductance 0.01 H is connected to a 250 V, 50 Hz su...

A:

Q: An analog voltage in the range 0 to 10.2 V is divided in 16 equal intervals for conversion to 4-bit ...

A: Given, Analog voltage range has, Vmax=10.2 VVmin=0 V It is divided into 16 equal intervals for conve...

Q: A B Vo R4 R5 6 ko 2 ko 11 R1 R2 R3 8 mA 3 ka 6 kQ 1 ka

A: Circuit is given as:

Q: Gsina Laplace find the current of iolt) In IF 2n Yu Ct)v E e ultlu

A:

Q: 3) a) What is the logic function that is implemented by the gate in the below figure? b) What are th...

A:

Q: Find the average value of the voltage signal v(t), such that Vm = 4.5 V and time period T = 3.2 s. v...

A: Given, Voltage signal, Vm=4.5 VVT=3.2 s

Q: Figure Q2, shows a circuit used for an amplifier system. The circuit contains dependent current sour...

A: Given data:  

Q: 1. A 4 pole, long-shunt lap wound generator supplies 20 kw at terminal voltage of 300 v. The armatur...

A: This problem comes under electrical machine . It is related to dc generator . It is based on the con...

Q: Write the Observability tests for Continuous time invariant systems.

A: The solution is given below

Q: A 205 V shunt motor is rated at 5 HP and 1000 rpm. At rated output it draws 29 A of line current. Th...

A: This question belongs to electrical machine . It is based on the concept of dc shunt motor . Have a ...

Q: 45. The average power absorbed by an inductor is zero. Neither True False Either

A:

Q: 32. A time domain circuit with  v(t) = 100 sin(377t) in 5mS, what is the effective current if the lo...

A: 32. v(t) = 100 sin(377t) v(t) = vm sin(wt) Where vm = 100 v Load R = 10 ohm Vrms = 0.707 vm   = 0.70...

Q: Two alternating voltages are represented by vị = 50 sin wt volts and v2 = 100 sin(wt - -). Draw the ...

A: The solution is given below

Q: 4.37 Consider the process control system with the plant transfer function G(s) = G+0,4)(s+1.2)* 0.9 ...

A: A transfer function (usually in the s-domain) denotes the relationship between an input signal and t...

Q: 4.41 Find the Thevenin and Norton equivalents at terminals a-b of the circuit shown in Fig. 4.108.

A:

Q: Me Rs 52 E2

A: Given Circuit shown 

Q: 4) a) What are the rise time, fall time, and average propagation delay of the NMOS gate in the below...

A:

Q: 3. Simplify the following expression in sum-of-products form using a 4-variable gh map. f (w, x, y, ...

A: Given Boolean expression  f(w,x,y,z)=w¯ x¯ y¯ z¯+w¯ x y¯+xy¯z+w¯yz¯

Q: An FM signal expressed as S(t)-1000cos[2*z*10°t+0.5cos(2* x*10*t)] is measured in an 50 N antenna. D...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: 2. With re' = 10 Mohms, determine VDi (voltage across Si diode), Vo2 (voltage across Ge diode) VR, V...

A: Consider the first model where the diodes are replaced by the resistances. The forward biased diode ...

Q: Design and write a truth table using the Karnoff map What is the name of the resulting circle?

A:

Q: 10. Two resistances are connected in parallel. R1= 24Q, R2=24 Q, and IT=6 A. Find the current in eac...

A: This question belongs to circuit theory . It is based on the concept of the current division in para...

Q: An 11 kV feeding power system shown in Figure 1. Data of the system is provided in Table 1. Consider...

A:

Q: Find the phase inductance of the three-phase circuit shown in the figure, if the separation between ...

A:

Q: 15. Find the missing values in Fig. 5-35. R, = 500 N R,32 kn R, 2 kn Flg. 5-35

A: If R1 ,R2 and R3 are in parallel and Rt is the total resistance of the circuit  Then relation betwee...

Q: A 50HZ, 60MVA synchronous generator stored its kinetic energy of 560MJ. What is the moment of inerti...

A: Given: Kinetic energy, K.E.=560 MJ Frequency, f = 50 Hz Moment of inertia, J =?

Q: = 79.265 + j56.586 = 97.39Z35.52°V or 97.39Z0.620 V What is the formula or process to get this kind ...

A: Consider the formula to convert the polar form to rectangular. r∠θ=x2+y2∠tan-1yx

Q: A capacitor is connected in parallel with a coil having L = 5. 52 mH and R = 10 ohms to a 100 V, 50 ...

A:

Q: 9. What resistance must be connected in parallel with a 20-N and a 600 resistor in parallel in order...

A: The solution is given below

Q: D 5.5 An NMOS transistor fabricated in a technology for which k.= 511 µA/V² and V;= 0.4 V is require...

A:   Given - K'n = 511 micro A/V2 Vt= 0 4 V Rds = 250 ohms to 1000 ohms Lmin = 0.13 micro Vgs= 1.3 V To...

Q: 0-10mAdc mA IK 1K 0-3ovde 1.5K R, 10K Fig. 9-2 c) Turn on the power source and adjust to 30Vdc. d) A...

A:

Q: A communication equipment has 2 stages with voltage gains / attenuations of 0.03 (ratio), and 30dB. ...

A: We need to find out overall gain for given system .

Q: 50. It is the resistance of a material when there is no supply. Hot Resistance Infinite Resistance ...

A:

Q: The one-line diagram of an unloaded power system is shown below. T | 1000 T Reactances of the two se...

A:

Q: An air core solenoid has a length of 10 cm and a cross-sectional area of 5 cm?. If it is wound with ...

A:

Q: 28. The following complex voltages are written in a combination of rectangular and polar form. Rewri...

A:

Q: With a neat block diagram representations discuss Cassade decomposition.

A:

Q: 502 ww 10.4: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? 202 200 502 ...

A: Given  

Q: Calculate the value of the source voltage in the circuit shown below and the equivalent resistance? ...

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per ...

Q: 502 ww 10.4: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? 202 V2 202 n...

A:

Q: Given the following second-order difference equation: уп] + 1.4у[n — 1] + 0.45у|n — 2] — г(п] — г[п ...

A:

Q: R1 Rg 30 V R9 R11 R10 R12 R3 R,4 Fig. 3.1 Table 3.5 Resistances of Fig. 3.1 R8 25 Q R1 50 Q R9 50 Q ...

A: We need to find out current and voltage for given circuit

Q: Three point charges are located as shown in the figure 9-5 x 10-12 IC) and di 6 lem] -4 x 10-12 IC] ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks. T...

A:

Q: Given three resistors, each having a resistance of 1 ohm, how many different values of equivalent re...

A: This question belongs to circuit theory . It is based on the concept of series and parallel combinat...

Q: Which component in an IoT device can take electrical input and transform it to physical action? a. ...

A: Which component in an IoT device can take electrical input and transform it to physical action? a. A...

Q: Implement the following functions using PLA Y,-Em(0, 1, 7) Y, -Em(0, 3, 6, 7) Y,-Em(0, 1, 3, 5, 7)

A:

Q: (2) ylbäi :The current I in the circuit shown is 16 V 5.6 k2 V. Si -4 V 1.95 mA 5.73 mA O 3.44 mA 8....

A: Given circuit,  

Q: Two electric field lines can cross each other Select one: True False

A: Electric field lines depend on the charge. They are imaginary lines drawn on the electric field.

Q: Q2 : Suppose you have the following modulated signal with the output wave changes of ± 5.5 Vp: Va ) ...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.