Answered: RMS value of half-wave rectified…

Engineering

Electrical Engineering

RMS value of half-wave rectified symmetrical square-wave current of 2A is a. √2 A b. 1/√2 A c. √3 A d.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: Question 23 What is the phase ø in degrees of the resistor voltage vr (t)? Give your answers to…

Q: For the signals provided below a. Which are periodic? Give their periods. b. Which are power…

A: The signal is said to be periodic if it repeats the output after some equal time interval. The power…

Q: R1 1k V1 VOFF = 0 VAMPL = 4V FREQ = 10kHZ C1 0.1uF Figure 2 2.3 Plot the waveform v for the voltage…

Q: 2. A current source in a linear circuit has is = 8cos(500nt – 25°) %3D (a) What is the amplitude of…

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

Q: he waveform displayed on an oscilloscope is as shown in Figure . Determine: i) amplitude of waveform…

Q: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of…

A: Find the value of capacitive reactance.

Q: Part 1: Computed Values For this part of the experiment, calculate the data needed in the table…

A: When frequency increases, the inductive reatance Increases because it is directly proportional to…

Q: What is the RMS voltage? Vrms =_________V note: See Figure 13.3 below: An oscilloscope screen…

A: Given: Vertical sensitivity=20 V/div Horizontal sensitivity=10 μs/div The waveform produced by…

Q: Procedure: 1. Set the function signal generator to generate square wave at f = 650 Hz and Vs p.p = 8…

A: Supply frequency, fs= 650 Hz Peak to peak supply voltage, Vpp=8V Peak voltage, Vp=82 =4V

Q: 2) For the circuit shown in Figure 2.1 below, if the input is excited by a square wave voltage…

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Given oscilloscope peak to peak voltage is 10Vp-p at certain frequency. Hence maximum voltage Vm=5V…

Q: 4. The AC generator in the circuit shown below supplies voltage with amplitude 5.0 V at frequency…

A: Given V=5 V f=336 Hz

Q: Q3. An AM wave has the form 20 [1+1.5cos2000nt) cos 40000 xt. Calculate: I Modulation index II.…

Q: Q1/ Consider a uniform cha 17cm, 75

A: a R=12 cmRadius> 12 cmqinside=0∴ E=kqr2=0E=0

Q: Calculate the current IL b) Calculate the complex power of V1 c) How much average power is being…

Q: C=1900pF C=1900pF E= 100V E = 100 cosut Lamba 1 Lam ba 2

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: An alternate voltage signal with a root mean square value of 1.57 V, which is superimposed to a…

A: Given: Vrms=1.57 VVdc=-4 V Required: Reading of the multimeter when the ACV function is selected?

Q: Sketch the following for the device which is used in high frequency and low power applications. (i)…

Q: please show work. i will give your work a thumbs up 7. Consider the oscilloscope screen shot below:…

Q: PROBLEM 5: a In the circuit shown, Determine the following: 7 V 2 V+ A. Magnitude and direction of…

Q: 44. The equation for 60 cycles current sine wave having RMS value 30 amperes, will be __ A. 42.4…

A: The solution is given below

Q: A 10-MHz sinusoidal carrier wave of amplitude 10 mV is modulated by a 5 kHz sinusoidal audio signal…

A: Given data: fc=10 MHz fm=5 kHZ Ac=10 mV Am=6 mV

Q: 15 Ω woa юа 10j Q 10210° Awgk/rms

Q: In the AC circuit shown in the figure below, R = 70.0 2 and the output voltage of the AC source is…

Q: A) An RLC series circuit, R=20 Q, a capacitor (C) and an inductor (L) , is connected across a…

A: As per the guidelines of Bartleby we have answer 1st question since others questions are not related…

Q: Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the…

Q: A coil has a resistance of 50 ohms and an inductance of 0.5 Henry. What is the RMS value of current…

A: In this question, A coil has a resistance R= 50 ohms And inductance L=0.5 Henry. What is the RMS…

Q: 5. For the questions below, use the following AC circuit from EveryCircuit:| 4 V 2V OV -2 V 2 us -4…

A: In this question, We need to calculate the peak to peak voltage, Peak voltage rms voltage and time…

Q: The rms value of any periodic triangular wave having the formdepicted in (a) is independent of ta…

A: The given data from the figure b) is depicted below: ta=0.2 stb=0.6 svoltage expression is as…

Q: Part 1: Computed Values For this part of the experiment, calculate the data needed in the table…

A: As frequency increases , Capacitive reactance decreases because it is inversely proportional to…

Q: Please help me please

Q: QUESTION 24 An inductor of inductance 40 ohms in series with a 30-ohm resistor is connected to an AC…

A: For Questions number 14 to 17, kindly mention the "previous question". Here we are solving question…

Q: The waveform displayed on an oscilloscope is as shown in Figure . Determine: (i) amplitude of…

Q: HW # 7.1 Vp = 50 sin(@t), R1 = 1kN , If the firing angle is 30°, draw %3D Vp=Vm sinot R Vo the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: An alternating voltage e= 100 sin 314t is applied to a circuit in which an ohmic resistance of 30…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 1. Set the function signal generator to generate square wave at f = 650 Hz and Vs p.p = 8 V. 2.…

Q: deduce the equivalent circuit of the coil

A: If the supply is applied to coil with iron core, then the power is observed for meet the core…

Q: Calculate the R value in ohms, since the 13kHz frequency sinusoidal sign is observed at the output…

A: C= 10nF Frequency, f= 13 kHz R=?

Q: signal is equal to its RMS value. Which of the following is the correct mathematical representation…

Q: A Parallel Yesonont in verter De liver lood 5000W. Resonont f requency is 20kHz R= 202 A). Sketch…

A: Given: For a parallel resonant inverter power delivered PL=5000 W, resonant frequency f0=20 kHz,…

Q: In the figure, R = 13.0 Ω, C = 6.26 μF, and L = 50.0 mH, and the ideal battery has emf = 33.0 V. The…

A: If the switch is kept in a position 'a' for a long time then capacitor acts as a open circuit so the…

Q: Given V, = 20 sin(@t + 60°) and V, = 60 cos(wt – 10°) . What is the phase angle %3D between the…

A: To solve above problem, one should have clear understanding of phasor quantities: In practical…

Q: B)The signal Vin(t)-2Cos(2nfit)+2Ces(2mfat), passes through a square-law device where the output…

Q: b) Two circuits connected in series which voltage drop across at each circuit can be expressed in…

Q: What is the peak factor of 169sin 377t?

Q: 1. Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage…

A: As per bartleby policy there are multiple questions so we have to solve only one question.

Question

Ihe RMS value of half-wave rectified symmetrical square-wave current of 2A is

√2 A

1/√2 A

√3 A

1 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Concept

VIEW

Solution

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How do I determine both the rms voltage and peak voltage for an ac waveform that has a vpp = 2.828sin(367t). Including the sketch of a labeled impedance diagram with every detail include ZT and and the angle Xc = 68 ohms, XL = 136 ohms and a 492 ohm resistor.
What is RMS voltage in a factory from an outlet that has a nominal voltage of 230 VAC
NEED ASAP. ANSWERS MUST BE IN 4 DECIMAL PLACES Power brightness of a 104) W, 110 V lamp is to be varied by controlling firing angle of SCR full-wave circuit; the rms value of ac voltage appearing across each scr being 110 V. Find the (a) rms voltage and (b) rms current in the lamp at firingangle of 60o .
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by π/3 radians and the total line current is 23.4 amp. (rms), determine the current in B.
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by pi/3 radians and the line current is 23.4 amp, determine the current in B. Ans:12 amps
(a) What is the frequency in Hertz and rad/s of the voltage waveform shown on Figure Q1? (b) Calculate the average voltage and rms ac voltage of the waveform shown on Figure Q1. (c) Calculate the total rms voltage of the waveform shown on Figure Q1. (d) The voltage on Figure Q1 is connected across a 0.15 2 resistive load. Calculate the power dissipated in this resistor.
Consider the following equation: v (t) = 110 sin(78.5 t) Calculate: Frequency (f) = ? Time period (T) = ? Peak Voltage (Vp) = ? Average voltage (VAVG) = ? RMS voltage (VRMS) = ? Sketch the labelled waveform showing Peak voltage, full cycle and half-cycle times.
Determine the RMS values of each waveform below: (full-wave sinusoids, square-wave, sawtooth, and triangle) Please all subpart is compulsory please Please in typing format Please all subpart is compulsory in short explanation
The voltage in your home is 120 Vac effective (rms), what is the peak value? Voltage specified as 100 Vac is understood to be what value? rms, peak or peak-to-peak? Convert 280V peak-to-peak, to its rms value. Assume a sine wave. What peak-to-peak value of ac sine wave would do the same work as 50 Vdc? Oscilloscope can display which value? (peak or rms)
Calculate the rms value of a sinusoidal current of maximum value 20A.
1) 169sin 377t a) What is the RMS value? b) What is the Average value?
A coil with an iron core absorbs a current of 0.5 A when a sinusoidal voltage of 220 V rms is applied to its terminals. If the power absorbed was 30 W, deduce the equivalent circuit of the coil. Ans: RFe = 1,617.64 Ω and Xμ = 457.38 Ω. (I need the procedure)