Answered: Rubber has a Young's modiles of 1.5 x…

Rubber has a Young's modiles of 1.5 x 10^8 Pa. If someone were to apply a force of 3 x 10^10 N to the side of a 12 m^3 cube, what would the strain on the cube of rubber be

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 19CQ: Can Young’s modulus have a negative value? What about the bulk modulus?

See similar textbooks

Related questions

Q: A skier leaves a ski jump with a horizontal velocity of 18.1 m/s. The instant before she lands 4.5…

Q: Electric charge is distributed is o(x, y) = 2xy, measured U 5 4 3 2- over the triang in coulumbs per

Q: What is the theoretical explanation for the observed phenomenon of superconductivity, and how does…

Q: janae has an experiment where she is evaluating the data of her ramp experiment where she is asked…

Q: 13. An interference pattern is formed by a single slit, and the distance between adjacent dark…

Q: A clinical technician finds that the activity of a sodium-24 sample is 136 cpm. What will be the…

Q: A proton with a kinetic energy of 1.91 keV (1eV=1.602.10-19 J), that is at height 21.9 cm above a…

A: Proton kinetic energy- K=1.91 keV= 1.91×103×1.6×10-19 J =3.06×1016 J Surface charge density= -4.35…

Q: x (m) 4 2 -2 1 2 3 4 (a) 0 to 1.0 s m/s (b) 0 to 4.0 s m/s (c) 1.0 s to 5.0 s m/s (d) 0 to 5.0 s m/s…

Q: The boy of mass 40 kg is sliding down the spiral slide at a constant speed such that his position,…

Q: 14) The thin, uniformly charged rod shown in Figure has a linear charge density A. Find an…

Q: A 0.30-kg object attached to the end of a string swings in a vertical circle (radius = 60 cm). At…

A: The mass of the object is 0.3 kg.The length of the string is 60 cm = 0.6 m.The speed of the object…

Q: A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the…

Q: Find the current through a person and identify the likely effect on her if she touches a 120 V AC…

A: Ohm's law states that the current (I) through a conductor between two points is directly…

Q: At the lowest point in a vertical dive (radius = 0.45 km), an airplane has a speed of 200 km/h which…

Q: A long silver rod of radius 3.0 cm has a charge of 5 microcoulombs per meter on its surface. Find…

A: Given Data:Radius Linear charge density To Determine:(a). The magnitude of the electric ﬁeld at a…

Q: 4) Figure shows a rigid structure consisting of a circular hoop of radius R and mass m, and a square…

Q: What is the resistance (in Ω) of a 35.0 m long piece of 13 gauge copper wire having a 1.828 mm…

A: Copper wire Length L = 35 mDiameter d = 1.828 mmRadius of wire r = d/2 = 0.914 x10-3 mDensity of…

Q: Three masses (m1 = 3 kg, m2 = 9 kg and m3 = 6) hang from three identical springs in a motionless…

Q: A spring with spring constant 10.5 N/m hangs from the ceiling. A 420 g ball is attached to the…

Q: 7.43 A block with mass 0.50 kg is forced against a horizontal spring of negligible mass, compressing…

A: Mass of the block (m)=0.50 kgSpring constant (k)= 100 N/mCompression (x)= 0.20 mDisplacement before…

Q: Two large charged plates of charge density ±18μC/m² face each other at a separation of 7 mm. Choose…

A: Two large charged plates of charge density=±18μC/m² face each other at a separation of 7 mm. Choose…

Q: is stretched with tension Ts. The rope has mass per length μ. Wanting to shake the ant off the rope,…

Q: During takeoff, the sound intensity level of a jet engine is 160 dB at a distance of 34 m. Part A…

Q: A glass rod like the one in the lab kit is uniformly charged on its surface. Draw the electric field…

Q: using the information down below generate graphs of the position-time, velocity-time, and…

Q: Determine the equivalent capacitance Ceq of the capacitor combination shown below when the…

A: The three capacitors areThe equivalent capacitance of the combination of capacitors.

Q: A knee joint flexes at an average rate of 150 degrees/sec during the swing phase of running. If the…

A: Given Data:Radius Arc length To Determine:The length of the time of the swing phase.

Q: 100 mL of water at 20.0 °C is placed in the freezer compartment of a refrigerator with a coefficient…

Q: A 6.0-cm-diameter cylinder of nitrogen gas has a 4.0-cm-thick movable copper piston. The cylinder is…

Q: Pretend you are doing an experiment, where you are told to incline a 1.5-2 meterramp to different…

A: As mentioned in the questions, assume the value of the distance between 1.5m to 2 m. (length of the…

Q: Calculate the smallest thickness of a soap film (n = 1.33) on glass (n = 1.52) capable of producing…

Q: An isolated charged point particle produces an electric field with magnitude 100 N/C at a point 2 m…

A: Magnitude of electric field at point is Find:Magnitude of electric field at point

Q: A friend of yours is loudly singing a single note at 391 Hz while racing toward you at 23.8 m/s on a…

Q: 13. Which is the correct connection of Ammeters and Voltmeter? a) 1&3-Ammeter and 2 & 4-Voltmeter b)…

A: We know that, the Ammeter (zero resistance, ideally) is connected in series and voltmeter (Infinite…

Q: A 62-kg person consumes a small order of French fries (297 Calories) and wishes to "work off" the…

A: Solution:Given:1 Calorie = 4184 Jm = mass of person = 62 kgQ1 = energy in French fried she has eaten…

Q: me that Q₁ = -15.0 J and Q2 = -80.0 J in (Figure 1). help with math skills, you may want to review:…

Q: A block with mass m1 = 8.7 kg is on an incline with an angle θ = 37° with respect to the horizontal.…

A: Given Data:Mass of block 1 Angle of block 1 Coefficient of kinetic friction Coefficient of static…

Q: Two large parallel conducting plates carrying opposite charges of equal magnitude are separated by…

A: The seperation between plates is 2.2 cm = 0.022 m.The charge density on the plate is 47 nC/m2.

Q: 50... Predict/Calculate A soccer ball is kicked with an initial speed of 10.2 m/s in a direction…

Q: A ray of light strikes a flat, 3.5-cm-thick block of glass (n = 2.5) at an angle of 15° with the…

A: The angle of incidence with the normal at top of glass, The refractive index of glass, ng=2.5The…

Q: A 1.0-m-tall vertical tube is filled with 20 °C water. A tuning fork vibrating at 573 Hz is held…

A: Page 1

Q: Find the charge on the capacitor in an LRC-series circuit at t = 0.05 s when L = 0.05 h, R = 4 Ω, C…

Q: ard hemisphere, dB sound t of and 2.5 m

Q: ake a photograph or obtain an image of a situation in which the fact that in a static fluid yje…

Q: Nuclear matter is extremely dense. (a) Calculate the density, in kg/m³, of A neutrons in a sphere of…

A: Note: “Since you have posted multiple questions, we will provide the solutiononly to the first…

Q: The two most prominent wavelengths in the light emitted by a hydrogen discharge lamp are 656 nm(red)…

A: Given thatRed wavelength =656 nmBlue wavelength =486 nmLight is observed from distance L…

Q: A proton with a kinetic energy of 6 MeV enters a homogeneous magnetic field of 1 Tesla at an angle…

A: See below

Q: (Figure 1) shows a snapshot graph of a sinusoidal wave traveling to the right. Figure D (cm)

Q: 25 V 6502 8402 10 Ω mm 7302 a) Find the total resistance RT b) Find the total current IT

A: Part a:The expression for the equivalent resistance when n resistors are conneceted in series is;In…

Q: Find the acceleration of the block if its mass is 8.0 kg. Two forces acting on a block on a…

A: Forces, F1 = 10 N ; F2 = 12 NMass, m = 8 kgFrictional coefficient, μ = 0

Concept explainers

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).

Question

100%

Rubber has a Young's modiles of 1.5 x 10^8 Pa. If someone were to apply a force of 3 x 10^10 N to the side of a 12 m^3 cube, what would the strain on the cube of rubber be

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Determine strain

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod stretches by 0.15mm under some stress, how much does the steel rod stretch under the same stress?
Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m long and has cross-sectional area 9.1mm2 . If a 10,000N tensile force is applied at each end of the combination, find: (a) stress in each rod; (b) strain in each rod; and, (c) elongation of each rod.
A steel cable 2.00 m in length and with cross-sectional radius 0.350 mm is used to suspend from the ceiling a 10.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.00 rad/s. What is the strain produced in the cable?
A uniform wire (Y = 2.0 1011 N/m2) is subjected to a longitudinal tensile stress of 4.0 107 N/m2. What is the fractional change in the length of the wire?
A brass wire and a steel wire, both of the same length, are extended by 1.0 mm under the same force. Is the cross-sectional radius of the brass wire more, less, or equal to the cross-sectional radius of the steel wire? Explain. Youngs moduli for brass and steel are 1.0 1010 N/m2 and 2.0 1011 N/m2, respectively.
Assume Youngs modulus for bone is 1.50 1010 N/m2. The bone breaks if stress greater than 1.50 108 N/m2 is imposed on it. (a) What is the maximum force that can be exerted on the femur bone in the leg if it has a minimum effective diameter of 2.50 cm? (b) If this much force is applied compressively, by how much does the 25.0-cm-long bone shorten?
Review the relationship between stress and strain. Can you find any similarities between the two quantities?
A disk between vertebrae in the spine is subjected to a shearing force of 600 N. Find its shear deformation, taking it to have the shear modulus of 1109 N /m2. The disk is equivalent to a solid cylinder 0.700 cm high and 4.00 cm in diameter.
Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
Normal forces of magnitude 1.0106N are applied uniformly to a spherical surface enclosing a volume of a liquid. This causes the radius of the surface to decrease from 50.000 cm to 49.995 cm. What is the bulk modulus of the liquid?
A company is testing a new material made of recycled plastic for use in construction. Figure P14.48 is a graph of the stress as a function of strain for this material. Find Youngs modulus for this material and compare your result with the data for conventional building materials listed in Table 14.1.
A 100-N weight is attached to a free end of a metallic wire that hangs from the ceiling. When a second 100-N weight is added to the wire, it stretches 3.0 mm. The diameter and the length of the wire are 1.0 mm and2.0 m, respectively. What is Young’s modulus of the metal used to manufacture the wire?