S. iz R2 R1 L 0.5 H and negli gible resistance is connected 50 and R2 An inductor with inductance L to a battery, a switch S, and two resistors, R, Figure. The battery has emf 160 V and negligible internal resistance. Sis closed at t = 0. What is the value of t for which i, has half of the final value that it can obtain after switch S has been closed for a long time? 10 N as seen in %3D A) 17.3 ms B) 13.8 ms C) 46.2 ms D) 9.24 ms E) 34.6 ms sese

S. iz R2 R1 L 0.5 H and negli gible resistance is connected 50 and R2 An inductor with inductance L to a battery, a switch S, and two resistors, R, Figure. The battery has emf 160 V and negligible internal resistance. Sis closed at t = 0. What is the value of t for which i, has half of the final value that it can obtain after switch S has been closed for a long time? 10 N as seen in %3D A) 17.3 ms B) 13.8 ms C) 46.2 ms D) 9.24 ms E) 34.6 ms sese

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 70PE: Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What...

See similar textbooks

Similar questions

To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 (H inductor connected to a variable capacitor. What range of capacitance is needed?
A series RLC circuit consists of an 8.00- resistor, 5.00-F capacitor, and a 50.0-mH inductor. A variable frequency source applies an emf of 400 V (rms) across the combination. Assuming the frequency is equal to one-half the resonance frequency, determine the power delivered to the circuit.
An LC circuit consists of a 3.00 mH inductor and a 5.00 (F capacitor. (a) Find its impedance at 60.00 Hz and 10.0 kHz. (b) Compare these values of Z with those found in Example 23.12 in which there was also a resistor.
A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the inductance?
A precision laboratory resistor is made of a coil of wire 1.50 cm in diameter and 4.00 cm long, and it has 500 turns. (a) What is its self-inductance? (b) What average emf is induced it the 12.0 A current through it is turned on in 5.00 ms (one-fourth of a cycle for 50 Hz AC)? (c) What is its inductance if it is shortened to half its length and counter-wound (two layers of 250 turns in opposite directions)?
An RL circuit consists of a 40.0 (resistor and a 3.00 mH inductor. (a) Find its impedance Z at l60.0 Hz and 10.0 kHz. (b) Compare these values of Z with mouse found in Example 23.12 in which there was also a capacitor.
A device is turned on and 3.00 A flows through it 0.100 ms later. What is the self-inductance of the device if an induced 150 V emf opposes this?
After the switch is dosed in the LC circuit shown in Figure CQ32.8, the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible? Figure CQ32.8 Conceptual Question 8 and Problems 52, 54, and. 15.
A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. It you want current through it to be adjustable with a 1.00 s characteristic time constant, what is the minimum resistance of system?
A 10-H inductor carries a current of 20 A. Describe bow a 50-V emf can be induced across it.
What capacitance should be used to produce a 2.00 M(reactance at 60.0 Hz?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.