sand layer 5m thick is underlain with a thick layer of clay. the sand has a void ratio of 0.52 and specific gravity 2.64. The clay has a water content of 42% and specific gravity of 2.64. The ground water table is located 3 m below the ground surface. The sand above the water table is 30% saturated. a.) Determine the unit weight of the clay b.) Determine the total stress at a depth of 10 m below the ground surface.

sand layer 5m thick is underlain with a thick layer of clay. the sand has a void ratio of 0.52 and specific gravity 2.64. The clay has a water content of 42% and specific gravity of 2.64. The ground water table is located 3 m below the ground surface. The sand above the water table is 30% saturated. a.) Determine the unit weight of the clay b.) Determine the total stress at a depth of 10 m below the ground surface.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.11P

See similar textbooks

Similar questions

Refer to Figure 10.48. If R = 4 m and hw = height of water = 5 m, determine the vertical stress increases 2 m below the loaded area at radial distances where r = 0, 2, 4, 6, and 8 m. Circular contact area of radius R on the ground surface Figure 10.48
A 5m thick clay layer lies between two layers of sand each 4m thick, the top upper layer being at ground level. The water table is 2m below the ground level but the lower layer of sand is under artesian pressure, the piezometric head being 4m above ground level. The saturated density of clay is 20kN/m3 and that of sand is 19kN/m3 . Above the water table, unit weight of sand is 16.5kN/m3 . Calculate the effective vertical stress at the top and bottom of the clay layer.
The soil profile consists of 5m sand underlain by 13 m layer of clay. The ground water table is at a depth 2.8 m below the surface. The sand has a unit weight of 19 kN per cu. Meter above the ground water table and the saturated unit weight below was 20 kN per cu. meter. The saturated unit weight of the clay is 15.7 kN per cu. meter. At a depth of 11 m determine the following:a. Total stressb. Pore water pressurec. Effective stress.....
A 6m thick layer of clay underlies a sand formation having a thickness of 4m. The ground water is located 2m below the ground surface. The specific gravity of sand and clay is 2.70 with sand having an average void ratio of 0.40. The clay has a water content of 20%. Determine the new height of ground water table from the bottom of the clay layer IF that the effective stress at the bottom of the clay layer has increased by 10 kPa.
A soil profile consists of sand (5-m thick) which overlies a layer of clay (4-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.75, Degree of Saturation = 0.76 For clay layer: Void Ratio = 1.09, Specific gravity = 2.76
Problem 1 A ground profile consists of 2 m of silty sand underlain by 3 m of clay. The ground water table is 3 m below the ground surface. The sand has a unit weight of 14 kN/m3. The clay has unit weight of 16 kN/m3 above the water table and 20 kN/m3 below the water table. a. Determine the total stress at bottom of the clay b. Determine the pore water pressure at the bottom of the clay c. Determine the effective stress at the bottom of the clay Problem 2 50 ft thick sand is underlain by 25 ft clay. The ground water table, initially at the ground surface, was lowered to a depth of 25 ft below the ground. After such lowering, the degree of saturation of the sand above water table was lowered to 20%. Saturated and dry unit weight of sand are 135 pcf and 116 pcf respectively. The saturated unit weight of clay is 120 pcf. a. What is the vertical effective pressure at the midheight of the clay layer before lowering of the water table in psf? b. What is the vertical effective pressure at the…
A soil profile consists of sand (7-m thick) which overlies a layer of clay (9-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.75, Specific gravity = 2.62, Degree of Saturation = 0.77 For clay layer: Void Ratio = 0.87, Specific gravity = 2.85 Round off to two decimal places.
The ground water level in a thick very fine sand deposit is located 1.20 meters below the ground surface. Above the free water line the sand is saturated by capillary action. The unit weight of the saturated sand is 21.7 kN per cubic meter, determine the effective stress located 3.60 meters below the ground surface
In a deposit of fine sand the water table is 3.5m below the surface but sand to a height of 1.0 above the water table is saturated by capillary water, above this height, the sand maybe assumed to be dry.The saturated and dry unit weights respectively are 20kN/M3 and 16KN/M3. Calculate the effective vertical stress in the sand 8m below the surface.
A layer of soil has the following properties: void ratio = 0.44, effective diameter = 12 μm, capillary constant C = 0.18 cm2 . Groundwater table is 10 m below the ground surface. (a) Find the height of capillary rise in the soil in mm. (b) What is the effective stress in kPa at 7 m depth if unit weight of solids is 25.55 kN/m3 and soil above the capillary zone is 40 % saturated? (c) What is the effective stress in kPa at 14 m depth?
1.A layer of saturated clay 4m thick is overlain by sand 5m deep, the water table being 3m below the surface. The saturated unit weights of the clay and sand are 19 and 20 kN/cu.m., respectively. Above the water table, the dry unit weight of the sand is 17 kN/cu.m. 1.1 Find the total stress at the bottom of the clay layer 1.2 Find the pore water pressure at the bottom of the clay layer 1.3 Find the effective stress at the bottom of the clay later
The soil profile shown consists of dry sand (7-m thick) which overlies a layer of clay (6-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water taable rises to the top of the ground surface, what is the change in effective stress (kpa) at the bottom of the clay layer? For sand layer: Void Ratio= 0.89 SG= 2.67 Degree of Saturation= 0.62 For claylayer: Void Ratio= 0.92 SG=2.72