schematic of wind blowing on a traffic barrier drum (A 55-gallon drum painted orange). Estimate the wind speed needed to tip the drum over. The empty mass of the drum is 24 lbm, the diameter is 22.5 inches, and the height is 34.5 inches. Traffic Barrier Drum What volume of water is required to keep the drum from tipping over in a wind with sustained gusts of 90 miles/hour? Assume the wall thickness is small, so the dimensions above closely approximate the inside dimensions of the drum.

schematic of wind blowing on a traffic barrier drum (A 55-gallon drum painted orange). Estimate the wind speed needed to tip the drum over. The empty mass of the drum is 24 lbm, the diameter is 22.5 inches, and the height is 34.5 inches. Traffic Barrier Drum What volume of water is required to keep the drum from tipping over in a wind with sustained gusts of 90 miles/hour? Assume the wall thickness is small, so the dimensions above closely approximate the inside dimensions of the drum.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In gliding (unpowered) flight, the lift and drag are in equilibriumwith the weight. Show that if there is no wind, theaircraft sinks at an angletan θ ≈drag/liftFor a sailplane of mass 200 kg, wing area 12 m2, and aspectratio 11, with an NACA 0009 airfoil, estimate (a) the stallspeed, (b) the minimum gliding angle, and (c) the maximumthe distance it can glide in still air when it is 1200 mabove level ground.
For those who think electric cars are sissy, Keio University inJapan has tested a 22-ft-long prototype whose eight electricmotors generate a total of 590 horsepower. The “Kaz” cruisesat 180 mi/h (see Popular Science, August 2001, p. 15). If thedrag coefficient is 0.35 and the frontal area is 26 ft2, what percentageof this power is expended against sea-level air drag?
Air at 20°C and 1 atm flows at 3 m/s past a sharp flat plate2 m wide and 1 m long. (a) What is the wall shear stress atthe end of the plate? (b) What is the air velocity at a point4.5 mm normal to the end of the plate? (c) What is the totalfriction drag on the plate?
Water at 20 ° C fl ows steadily through the tank in Fig.P3.101. Known conditions are D 1 = 8 cm, V 1 = 6 m/s, andD 2 = 4 cm. A rightward force F = 70 N is required to keepthe tank fi xed. ( a ) What is the velocity leaving section 2?( b ) If the tank cross section is 1.2 m 2 , how fast is the watersurface h ( t ) rising or falling?
A water jet 7.6 cm diameter strikes concrete (SG=2.3) slab which rests freely on a lever floor. If the slab is 30.5 cm wide into a paper, calculate the jet velocity which will just begin to tip the slab over.
The model car in Fig. P3.82 weighs 17 N and is to beaccelerated from rest by a 1-cm-diameter water jet moving at 75 m/s. Neglecting air drag and wheel friction, estimatethe velocity of the car after it has moved forward 1 m.
Consider two different flows over geometrically similar airfoil shapes,one airfoil being twice the size of the other. The flow over the smallerairfoil has freestream properties given by T∞ = 200 K, ρ∞ = 1.23 kg/m3,and V∞ = 100 m/s. The flow over the larger airfoil is described byT∞ = 800 K, ρ∞ = 1.739 kg/m3, and V∞ = 200 m/s. Assume thatboth μ and a are proportional to T 1/2. Are the two flows dynamicallysimilar?
The drag of an airfoil (Fig.) increases considerably ifyou turn the sharp edge around 180° to face the stream. Canyou explain this?
Aerodynamics NACA 747A415, chord is 180 cm 1) What is the location of favorable pressure gradient of the upper surface, measured from LE? 2) What is the location favorable pressure gradient of the upper surface, measured from TE?
A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at 90 mi/h. How much power (in ft-lb/s) is required to overcome aerodynamic drag if air density is 0.002378 slugs/ft?
A Savonius rotor can be approximatedby the two open half-tubes in Fig mounted ona central axis. If the drag of each tube is similar to thatin Table 7.2, derive an approximate formula for therotation rate Ω, as a function of U, D, L, and the fluidproperties (ρ, μ).
Consider the Gulfstream IV flying at Mach = 0.35. Calculate thrust required given an altitude of 30,000-ft, assuming weight of 73,000-lb. Airplane data: S = 950 ft2, AR = 5.92, ??? = 0.015, and K = 0.08 a. The thrust required at 30,000-ft. (in pounds)