Section II: Problems Page 3 Problem 1: Newton's Laws A 11300 kg car is held in place by a light cable on a very smooth (frictionless ramp). The cable makes an angle of ß = 31° above the surface of the ramp, and the ramp itself rises 0 = 25° above the horizontal, as shown in the figure below. (a) Draw a free body diagram of the car. Be sure to label all forces clearly and to place the angles 6 and ß in your diagram. 31.0° 25,0° b) Find the tension in the cable FT = c) How hard does the surface of the ramp push on the car? Framp Cable

Section II: Problems Page 3 Problem 1: Newton's Laws A 11300 kg car is held in place by a light cable on a very smooth (frictionless ramp). The cable makes an angle of ß = 31° above the surface of the ramp, and the ramp itself rises 0 = 25° above the horizontal, as shown in the figure below. (a) Draw a free body diagram of the car. Be sure to label all forces clearly and to place the angles 6 and ß in your diagram. 31.0° 25,0° b) Find the tension in the cable FT = c) How hard does the surface of the ramp push on the car? Framp Cable

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter4: The Laws Of Motion

Section4.5: Applications Of Newton's Laws

Problem 4.6QQ: For the woman being pulled forward on the toboggan in Figure 4.33, is the magnitude of the normal...

See similar textbooks

Similar questions

Consider the figure below, where M 2 = 4.0 kg is stacked on top of M 1 = 12.0 kg, which is accelerating along ahorizontal, icy, frictionless surface at a = 5.0 m/s 2 . (a) What’s the minimum static coefficient of friction between the blocks that will prevent M 2 from sliding off? Draw a free-body diagram for each block (b) What’s the force acting on the bottom block given the condition in (a)?(c) If the coefficient of kinetic friction is half the amount you solved in (a) find the acceleration of block M 2 , where the acceleration of the bottom block remains the same.(d) What’s the force acting on the bottom block given the condition in (c)?
Given a 15 foot tall wall that is loaded as indicted. (F = 100 pounds) Determine the point where the force F will intersect the base measured from the wall. (please include a free body diagram if applicable) choices: a)13.33 ft b)20 ft c)3/4 ft d)15 ft e)10 ft f)7.5 ft g)12.5 ft h)11.25 ft
There are two forces on the 1.19 kg box in the overhead view of the figure but only one is shown. For F1 = 15.7 N, a = 14.7 m/s2, and θ = 34.1°, find the second force (a) in unit-vector notation and as (b) a magnitude and (c) a direction. (State the direction as a negative angle measured from the +x direction.)
I contestant in a Winter games event polls a 59.0 KG block of ice across a frozen Lake with a rope over shoulder the coefficient of static friction 0.1 and the coefficient of kinetic friction is 0.03 calculate the minimum force F he must expert to get the black moving? What is its acceleration once it starts to move if that force is maintained?
A block of mass 20kg is pushed against a vertical wall by force P. The coefficient of friction between the surface and the block is 0.2. If theta = 30 degrees, what is the minimum magnitude of P to hold the block still?I understand that in order for the block to sit motionless, the net forces acting on the block must be zero. I set my equation to be Net Force = 0 = Psin(theta) + Force Friction - Force Gravity.Which I rearranged as P = (Force Gravity - Force Friction)/sin(theta) or P = (mg-μ(mg))/sin(theta)Doing this gives me a value of 313.6N rather than 202.9N which I should be getting. What am I doing wrong?
Two blocks are connected by a string passing over a pulley. if the coefficient of kinetic friction between block 1 and the ramp is uk is 0.160 and m1=3kg what mass m2 would allow blcok 1 to slide down the ramp at constant velocoty? first determine the direction of friction force on block 1
Three pictures of equal weight (20 N) are hung by wires in three different orientations. In which orientation are the wires least likely to break? _______ Explain why.
I don't understand why Fs <= Fk. What does the F in (1) and (2) stand for? If it's force applied, wouldn't F = Fs + Fk for box 2, and (F - Fs - Fk) = Fs for box 1? My thinking is that the Force applied on box 2 minus the force of kinetic friction and the force of static friction applied by Box 1 on 2 would equal to the net force. Then the net force of box 2 would cause the same netforce on box 1, if box 1 isn't moving, then it's Fs should be equal to that net force applied on box 1. Therefore Force applied wouldn't be equal to Static Friction Force, and shouldn't it be bigger than the Kinetic Friction Force since it's moving in the direction of Force applied?
A student is trying to find the force on a person at the top of an inverted roller coaster, where the person is upside down at the top, and writes the equation S + mg = mv 2/r. What would you say about that? A Yes, that’s correct. B Close, but it should be written S - mg = mv2/r. C Close, but it should be written mg - S = mv2/r.
A contestant in a winter sporting event pulls a 43 kg block of ice in the positive horizontal direction with a rope over his shoulders across a frozen lake as shown in the figure. Assume the coefficients of static and kinetic friction are µs=0.1 and µk=0.03. Calculate the minimum force F he must exert to get the block sliding in newtons? What is its acceleration in m/s2 once it starts to move, if that force is maintained?
If the normal force exerted by the track on the car when it is at the top of the track (point B) is 6.00 N, what is the normal force on the car when it is at the bottom of the track (point A)?
The tension in a violin string is2.7 N. When pushed down against the neck of the violin, the stringmakes an angle of 4.1° with the horizontal. (a) With what forcemust you push down on the string to bring it into contact with theneck? (b) If the angle were less than 4.1°, would the required forcebe greater than, less than, or the same as in part (a)? Explain.