Pls help Shear Strength of SoilThe following are the results of two consolidated-drained triaxial tests on a clay:Test I: 03 = 140 kN /m2;o,(failure) = 368 kN /m?Test Il: 03 = 286 kN /m²; 01(failure)= 701 kN /m?Determine the shear strength parameters; that is, c' and o'.(Enter your answers to three significant figures.)

To Determine Shear strength parameters of the soil.

Shear Strength of Soil The following are the results of two consolidated-drained triaxial tests on a clay: Test I: 03 = 140 kN /m2; o,(failure) = 368 kN /m? Test II: 03 = 286 kN /m²; 01(failure) 701 kN /m2 Determine the shear strength parameters; that is, c' and o'. (Enter your answers to three significant figures.)

Shear Strength of Soil The following are the results of two consolidated-drained triaxial tests on a clay: Test I: 03 = 140 kN /m2; o,(failure) = 368 kN /m? Test II: 03 = 286 kN /m²; 01(failure) 701 kN /m2 Determine the shear strength parameters; that is, c' and o'. (Enter your answers to three significant figures.)

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.24P

See similar textbooks

Similar questions

For a normally consolidated soil, the following is given: Determine the following: a. The compression index, Cc. b. The void ratio corresponding to pressure of 200 kN/m2
Solve it completely....Determine the average horizontal and vertical permeabilities of a soil mass made up of three horizontal strata, each 1 m thick, if the coefficients of permeability are 1 × 10–1 mm/s, 3 × 10–1 mm/s, and 8 × 10–2 mm/s for the three layers.
Determine the average horizontal and vertical permeabilities of a soil mass made up of three horizontal strata, each 1 m thick, if the coefficients of permeability are 1 × 10–1 mm/s, 3 × 10–1 mm/s, and 8 × 10–2 mm/s for the three layers.
Question-3: A soil profile is shown in Figure 3.1. If a uniformly distributed load, ∆σ, is applied at the ground surface, calculate the settlement of the clay layer caused by primary consolidation, if Cc = 0.27 and Cr = 0.045 and a. The clay is normally consolidated b. The preconsolidation pressure, σ′c = 190 kN/m2 c. σ′c = 170 kN/m2
A square footing supporting a column applies a uniform pressure of 100 kPa on top of a deep clay deposit. Based on the bulbs of pressure developed below the footing shown in the following figure, which of the following statements are correct (select all that apply)? A.Immediately after construction, the excess pore water pressure (∆u) developed at Point A remains lower than ∆u developed at Point B B.Immediately after construction, the excess pore water pressures (∆u) developed at Points B and C are the same C.Since the clay layer is homogeneous, one-dimensional Terzaghi’s theory of consolidation can be applied to provide an accurate estimate of the rate of consolidation at Points A, B, and C. D.After construction, three-dimensional seepage occurs below the foundation as the excess pore water pressures dissipate.
In a drained triaxial test on consolidated clay the stress and angle are as follows: Deviator stress is 20 1b/in2 and friction angle is 210 . Calculate the effective confining pressure at failure.? A) 21 1b/in2 B) 22.2 1b/in2 C) 25.4 1b/in2 D) 17.9 1b/in2
For the layered soil shown in the figure, H1 = 5 m, H2 = 5 m, and H3 = 20 m. The soil densities are ρ1=2040kg/m3, ρ2=1940kg/m3, and ρ3′=1020kg/m3. What is the effective stress at the bottom of soil 3 when h' = 15 meters? CHOICES A. 142.7 kPa B. 150.1 kPa C. 163.8 kPa D. 136.8 kPa
The following technical data are given below: Overburden pressure = 180KPa Increase in pressure = 140KPa Clay thickness = 8m Compression Index = 0.315 Void ratio = 1.132 What is the total settlement in clay?
A layered soil has the following details: H₁ = 3ft, k₁ = 10-4 cm/sec : H ₂ = 4ft, k₂ = 3.2x10ˉ² cm/sec: H₃ = 6 ft, k₃ = 4.1x10ˉ⁵ cm/sec. What is the equivalent vertical permeability? a. 5.14 x 10ˉ⁵ b. 7.37 x 10ˉ⁵ c. 6.23 x 10ˉ⁵ d. 9.81 x 10ˉ⁵
If a representative clay specimen 20 mm thick, under double drainage, took 121 minutes for 90% primary compression, estimate the time in days required for 50% primary compression of a field layer 2 m thick, bounded by impervious boundary at the bottom and sand at the top. a.679 b.781 c.650 d.725
Q#3: For a normally consolidated clay layer in the field, the following values are given. Thickness of clay layer = 2.6 m Compression index = 0.28 Average effective pressure on clay layer 127 KN/m² Secondary compression index = 0.02 Δσ’ = 46.5 KN/m² Void ratio = 0.8 Time of Primary settlement = 1.5 years What is the total consolidation of the clay layer five years after the primary consolidation settlement?
Subject Geotechnical engineering : soil mechanics A layer soil shown has the following data H1= 3m. K1= 2x10^-2 cm/sec H2= 4m K2= 3.2x10^-2 cm/sec H3= 6m K3= 4.1 x 10^ -2 cm/sec Compute the equivalent coefficient of permeability in vertical direction. Compute the velocity if h= 4m