Answered: Show that for a circuit with (n) nodes…

Show that for a circuit with (n) nodes it is sufficient to write the K.C.L. for (n-1) nodes and that the K.C.L. for Nth node is not independent (support your answer with an example).

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 12PP: In an R-L parallel circuit, ET=480 volts, R=16, and XL=24. Find PF.

See similar textbooks

Related questions

Q: Design the given circuit using only NOR gates. Explain the steps in detail MUX

Q: Find the value of i and V0 in the circuit given

Q: What is thevenin equivalent resistance in the circuit shown

Q: Find the Norton's equivalent of the following circuit. Consider, the resistor R as the load.

Q: With regard to the circuit represented in the following circuit, first transform both voltage…

A: In the circuit given data is- V1=2 vR1=6 ΩR2=3 ΩR3=2 ΩI1=4v3V2=2v3 Calculating series resistance-…

Q: R1 R5 1k0 1kn V1 R6 1k R2 S6kn R3 3k E12V R4 1kn What can be said about the equivalent resistance…

Q: 1. In which one of Kirchhoff's Laws does Mesh Analysis rely on? Give a detailed explanation for your…

A: which one of Kirchhoff's Laws does Mesh Analysis rely on? Give a detailed explanation for your…

Q: During the 'Introduction to Nanotechnology class', a student argues that CNFETS are better than the…

A: The dedicated branch of science which deals at nanometer scale for designing and producing…

Q: Obtain the generalized node equations for the circuit given in the figure.

Q: Using the applicable Kirchhoff's Laws, determine the values of i2, i4, v2 , v3 and v6 in the…

Q: Design a value for R,, R, and Rcs such that 0.5 mA can be delivered to loads up to 18k

Q: What is the maximum power that can be transferred to the load Rx

Q: The Thevenin’s Voltage, Vth equivalent of the circuit shown in the figure, external to R2 is

A: The Thevenin voltage can be calculated by removing the resistor R2 and finding the voltage across…

Q: Let a circuit with an open-circuit voltage of 101V be given. 1V voltage is measured on a 1Ω resistor…

A: According to the question we have to calculate short-circuit current ofthe circuit.

Q: 1. Design the network that will maintain Vị at 12 V for a load current of 200 mA. That is determine…

Q: Find the value of i and V0 in the circuit given

Q: The maximum power transfer to the load resistor occurs when the the load resistor equal to the…

A: The statement is True. The power transferred to the load resistor is maximum when its value is equal…

Q: In the single-node-pair circuit below I1 = 6 A, 12 = 3 A, R1 = 5.5 N, R2 = 16 N, R3 = 9 N, R4 = 12.5…

A: Redrawing the circuit by marking the node V as shown below:

Q: Find h-parameters of the circuit as shown in the Figures

Q: Q2 – For the circuit shown in the Figure below, use superposition to find “" in terms of R's and…

A: It is given that:

Q: Glven the circuit below, Find the current IA

A: Given- Current flow,= 2 A, 4 A, - 2A and 9 A To find- Current value, IA = ?

Q: Define Thevenin's theorem and Explain in detail with suitable circuit diagrams. Describe the step to…

A: Thevenin's theorem states that a linear two-terminal circuit can be replaced by an equivalent…

Q: Consider a circuit given below. Find and plot v(t) for all times.

A: first draw the circuit for t < 0 and find the current through the inductor then find t > 0…

Q: Derive an equation for the relation between Vs(t)and Vo(t) in the circuit

Q: 4. Find the value of the load resistor RL shown in the circuit below that gives maximum power…

Q: The circuit above has been used by countless of Biology and Network Engineering students to study…

Q: If we would like to use Superposition to solve for Vo in the circuit shown above, we must find the…

A: The superposition theorem is sum of individual response of sources acting alone. The response due to…

Q: If the rightmost resistor, 10 ohms, is the load, find the Thevenin Resistance, Thevenin Voltage and…

A: Given: For the above question we need to calculate the value of thevenin voltage and the load…

Q: What is the function of the following circuit? Give your answer in minimized Sum of Products (SOP)…

A: The given circuit is shown below. Here Y is the output which will be a function of A, B, C. The…

Q: Draw the relationship graphically that shows the relationship of current and voltage for the two…

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: Given the circuit below, what must be the load resistance to achieve the maximum power transfer?

A: To solve above problem one should have idea about maximum power transfer theorem : Maximum power…

Q: For the circuits below, find the Thevenin and Norton equivalent

Q: With regard to the circuit represented in the following circuit, first transform both voltage…

A: Determine V3 ? using voltage source to current source conversation?

Q: Q2/ For the below circuit, if you know that V,(t) is input (unit step) and v.(t) is an output, show…

Q: For the following circuit find the range of values of K for which the network remains stable.

Q: Construct and draw a lumped-element circuit that best approximates the behaviour of the “real"…

A: We have assume medium transmission line as example for lumped circuit.

Q: Use network conversion to find the equivalent or total resistance RT between a and d in a bridge…

A: The solution can be achieved as follows.

Q: Find the Thevenin equivalent when viewed from the ab-ends of the circuit given below. What is the…

A: Thevenin's Theorem: In a linear active bilateral network consisting no. of energy sources,…

Q: For the value of RL for which the maximum will be delivered to the load. Also, find the val maximum…

Q: The equivalent conductance for the --S * circuit in Fig. below is ----- 5 S Gea 6 S 8 S 12 S ww ww…

Q: ctual Vo in the circuit in Figure below by using linearity property on that Vo= 1 V. 56 V) 4 k2 2 k2…

A: Kirchhoff's current law- The algebraic sum of current at any node of circuit is zero. KCL…

Q: 0.2 For the circuit shown; Find the source voltage (V) and the total resistance (Req) of the circuit…

A: Given, current flows through resistor 9 ohm is 3 A.

Q: 4. Use open-circuit test and short-circuit test to find the Thevenin and Norton equivalent circuit.

A: The thevenins and Norton equivalent circuit can be obtain by using kirchhoff's current law and node…

Q: 200 t. SAS. 4.

A: The solution is given below

Q: Q2/ For the below circuit, if you know that V,(t) is input (unit step) and v.(t) is an output, show…

Q: Suppose you have a voltage signal x and you want to produce another voltage signal y such that y =…

A: According to the question, we need to design a circuit that performs the following operation shown…

Q: Draw and label the values for the norton equivalent of the given circuit

A: According to Norton theorem, any circuit can be converted into a parallel combination of a current…

Q: Find the Vth voltage and Rth resistance of the thevenin equivalent circuit seen from the a-b ends in…

Q: 1.How to determine the Thevenin Equivalent circuit? What are the steps in determining the Thevenin…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Show that for a circuit with (n) nodes it is sufficient to write the
K.C.L. for (n-1) nodes and that the K.C.L. for Nth node is not
independent (support your answer with an example).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an R-L parallel circuit, ET=480 volts, R=16, and XL=24. Find PF.
Find the Voltage Output of the Circuit below using the 2nd Approximation. Find the Voltage Drop across the Resistor R1 of the Circuit below using the 2nd Approximation.
What is thevenin equivalent resistance in the circuit shown
Find and graph the work current in the circuit below.
Use only the node-voltage method for the circuit & setup the equations needed to solve for V1, V2, &V3. Also include an expression to solve for the dependent source Va.
. Let a circuit with an open-circuit voltage of 101V be given. 1V voltage is measured on a 1Ω resistor connected to the terminals of the circuit. What is short-circuit current of the circuit?Note: The formal procedure to find the Thevenin and Norton equivalents of a given circuit is to compute the open-circuit voltage (Voc) and the short-circuit current (Isc) at the terminals. Open-circuit voltage is the voltage between the open-circuited terminals and the short-circuit current is the current through the short-circuited terminals.Then the voltage of the source at the Thevenin equivalent is Voc and the current of the source at the Norton equivalent is Isc. The value of the resistance in both cases is the ratio of Voc to Isc (i.e. Rth= Voc / Isc). Another method to find Rth is killing all independent sources and computing the equivalent resistance between the terminals, provided that there is no dependent source in the circuit.
Use the Rule of Conservation of Power to show that the power is conserved within the circuit. Write the equation first symbolically then insert the found values. Use Units! Is the power conserved?
Find the Norton equivalent circuit for the circuit shown in Figure. Solve for ISC and RN.
Use Millman's theorem to find the voltage across and current through the load resistor RL in the circuit
If the rightmost resistor, 10 ohms, is the load, find the Thevenin Resistance, Thevenin Voltage and Load Voltage, Vo.Note: In solving for Rth, voltage sources are shorted and current sources are opened. When looking for Vth, consider the current and voltage source connected.
Use Norton Theorem to get the equivalent circuit and solve for Norton's current and resistance.
R1=560Ω, R2=1000Ω, R3=470Ω, R4=2200Ω, R5=1000Ω V1 =12V and V2 = 5V Calculate every current in the given circuit by using the superposition principle. ( IR1C=?, IR2C=?, IR3C=?, IR4C=?, and IR5C=?)