Shown below is a mass haul diagram. Determine the free haul volume. a) 1000 m³ c) 2000 m² b) 2500 m² d) 4500 m² 20. Determine a) 1000 m² the volume of waste in item 19. a) 1000 m² b) 2500 m² c) 2000 m² d) 4500 m³

Q: Situation 1 Given spot levels determine the total amount of trucks with capacity of 20 cubic meters…

A:

Q: Net Volume (m') Fill (-) Cut (+) Mass Diagram Sta. Prob. 3 Ordinate 0+00 Determine mass diagram…

A: Given:- The net fill and cut volumes are given  The free haul distance = 250 m  To determine:- The…

Q: A rain event generates an average flow of 0.11 m2/s for 15 minutes. The average suspended solids…

A:

Q: 1.5 1.7 2.3 3.0 2.5 1.4 2.0 1.0 1.1 2.6 1.8 2.0 3.2 1.4 0.9

A: ASKED: To determine the number of trucks (of given capacity) required to fill the given grid. Given,…

Q: What is the aim of Jar test? And how can we choose the best coagulants?

A: Answer Introduction In the coagulation and flocculation process, the coagulant is added to the water…

Q: A detention basin has dimensions as follows: width, 20 m; length, 85 m; maximum height, 4m. The…

A:

Q: A sack slides off the ramp with a horizontal velocity of 12 m/s. If the height of the ramp is 6 m…

A:

Q: If a 1.0 m3/s flow wastewater treatment plant uses 4 parallel sedimentation basins with an overflow…

A:

Q: During scheduling for a project, you determine Activity E to have an early finish of 7 days (EF=7)…

A: Total FLoat=LFE-EFEFree float=ESsucceed-EFEInterfering fload=TF-FF

Q: Determine mass diagram ordinates given is the net fill and cut volumes and calculate overhaul…

A: Solution: Given data: The net fills and cut volumes are given: The free haul distance=250 m

Q: 5. For preliminary planning purposes, estimate the required landfill area for a community with a…

A: Population = 31000Solid waste generaation = 6.4lbcapita.dayCompacted weight of solid waste in…

Q: 2: Determine the area required for a new landfill site with a projected life of 20 years for a…

A:

Q: In a certain portion of a road construction, the following data were taken; Cost of haul = P30 per…

A: Introduction- A haul road, also known as a haulage road or a haul track, is a type of road used in…

Q: e. List three principal factors that influence the amount of consumptive use and the diversion…

A: Consumptive use can be defined as the total water loss from an area due to plant growth and that…

Q: Assuming a hydraulic loading rate of 25 m/m² -day. Determine the surface area and diameter of a…

A: Given:- A hydraulic loading rate = 25 m3/m2-day The flow of wastewater for a treatment = 0.5 MLD To…

Q: (i) Calculate and evaluate the detention time loading in compliance with standard practice given…

A:

Q: The Sibzianna landfill serves a population of 253,000. Each week 325 trucks bring a total of 2180 t…

A:

Q: Assume two truckloads, 4.02 hours of actual collection per day, the truck be if it has a compaction…

A: Speed= 5mph = {5*1609/0.3048}/{60*60}ft/s   = 7.332 feet/s

Q: Choose the most economical alternative in disposing non-hazardous chemical sludge using (a) PW…

A:

Q: A detention basin has dimensions as follows: width, 20 m; length, 85 m; maximum height, 4 m. The…

A:

Q: - On the basis of a detention period of 24 hrs, determine the size (assuming length to width ratilo…

A:

Q: 3 B K 1. Complete the arrow diagram shown, find the total project duration and 3 E 12 H define the…

A: The given arrow diagram is completed as shown below.

Q: If the conveyance efficiency is 80%, field losses are 15% and the actual depth of watering is 17 cm,…

A: We know that the trapezoidal channel is always best for the open channel as it is most economical…

Q: Design a rectangular sedimentation tank to treat 2.4 million litres of raw water per day. The…

A:

Q: How important is the implementation ofaSanitary Landfill in the economy ofacountry? And how vital is…

A: It is asked importance of Sanitary Landfill in economy of a country and involvement of society in…

Q: Problem mentioned in the attached file ?

A: Given Cc, coefficient of compression index=0.3 e0,initial void ratio=0.76 CV, coefficient of…

Q: What effect do such losses have on your initial analysis of full-flow discharge?  What other loss…

A: Given, L = 3.34 km or 3340 m  D = 1000 mm or 1 m Q = 0.99 m3/s

Q: The following represents infiltration data; Calculate the following 1. Infiltration rate for all…

A: "Since you have asked multiple sub-parts. We will solve the first two sub-parts for you. To get the…

Q: 1. Transportation and moving How many 5-ton LCY dump trucks will it take to support a wheel loader…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: make the logic network and perform the CPM calculations to find free float and Total float for each…

A: Solution: Activity Pre Duration ES EF LS LF Total float Free float A - 5 0 5 0 5 0 0 B A 6 5…

Q: Choose the most economical alternative in disposing non-hazardous chemical sludge using (c) Annual…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: 3) In the choice of a factory site many factors are to be considered, among which are the cost of…

A:

Q: Determine the area required for a new landfill site with a projected life span of 35 years, for a…

A: Life span of landfill =35 years.Population =200000Generation of waste =2.02Kg/percapita/day.The…

Q: Use the suggested ACTUAL fixity factor recommended by the AISC k =0.8. What is rhe Demand capacity…

A:

Q: Determine the area (m2) required for a new landfill site with a projected life of 10 years for a…

A:

Q: Estimate the hourly production in bank measures of a hydraulic shovel loading sand and gravel into…

A: Answer We are given Sand and gravel load Front dump bucket Heaped bucket capacity = 5.2 LCM Average…

Q: O For a flow of 5.7 MLD and a detention of 2 hour, what is the surface area of a rectangular…

A: Given data, Flow rate for rectangular sedimentation tank,  Q= 5.7 MLD = 5.7×10³m³/day Detention…

Q: For grit chamber, if the recommended velocity of flow is 0.2 m/sec and detention period is 2…

A: Calculate the length of the grid tank by using the formula             length of the tank= velocity…

Q: There is a need to transfer 120 m3 of soil within 1 day by trucks for a distance of 10 km. Each…

A: Total volume of soil to be transferred = 120 m3 distance between transfer points = 10Km Capacity of…

Q: A 6-storey building, 24-m high, has a total of 420 DFU's (70 per floor). If the building drain is…

A: From table 902.1 standard vent pipe size  For 420Dfu and developed length of 24m we get  Min vent…

Q: Explain  a hydraulic trap in landfill design? What is the difference between a natural hydraulic…

A: Hydraulic traps, the other type of natural solution where instead of leachate migrating outwards…

Q: n a certain portion of a road construction, the following data were taken; Cost of haul = P30 per…

A: GIVEN: Cost of haul = 30 per cum Cost of borrow = 360 cum

Q: 3.1 Estimate the maximum number of residences it can be served per week by a typical compactor truck…

A: We will divide total Ib by Ib/residence/wk

Q: Draw the arrow diagram for the following activities and show the critical path. activity duration…

A:

Q: Given the following Mass-Haul Diagram: Mass Diagram 5000 4000 3,500 3000 2,100 6.0 2,100 7.0 2000…

A:

Q: Required to prepare the action plan for the events by (A.O.N). method, show in table below and…

A:

Q: A mass haul diagram shows a free-haul distance of 50 m, cost of excavation of Php 6.00/m³ and a…

A: Solution: Given: Free haul distance = 50 m Cost of excavation = 6/m3 Price of over haul = 0.10/m3

Q: Explain the difference between a natural hydraulic trap and an engineered    hydraulic trap…

A: Hydraulic traps are a natural solution to hydrogeological situations in which groundwater…

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.