Answered: نقطة واحدة Shunt generator running at…

Engineering

Electrical Engineering

نقطة واحدة Shunt generator running at 1500 rpm, if flux is reduced by half, then what is the new * speed

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 12RQ

See similar textbooks

Related questions

Q: A 4 pole, lap wounded, de generator has 42 coils with 8 turns per coil. It is driven at 1200 R.P.M.…

A: Given, P=4N=1200 rpmϕ=21 mWb

Q: 2. The adjustable resistor, Radj can be adjusted from 50 2 to 350 2. Figure 1 shows the motor's…

A: GIVEN: a circuit diagram RA=0.7ΩRF=100ΩRadj=50 to 500Ω FIND: (a) two main difference…

Q: The resistance of the field coils with copper conductor of a dynamo is 120 Ohms at 25 o C. After…

A: Write the resistance in terms of temperature coefficient of resistance and temperature and than find…

Q: Q5 A 20 KW, 250 V d.c. shunt generator has armature and field resistance of 0.1 2 and 125 O…

Q: A D.C series motor hoists a load at 4 m/sec while taking 30 A at 300 V from D.C mains. The total…

Q: Q2. Suggest a suitable method to raise the speed of a de shunt motor 1 Add file

Q: 11. When an aluminum conductor is installed on a screw terminal, the screw should be tightened to a…

A: According to the question we have to discuss, When an aluminum conductor is installed on a screw…

Q: A Click Submit to complete this assessment. Question 7 Critical resistance of a self-excited…

A: To analyse the given statement

Q: A 500 KVA,3.3 KV,50 Hz,600 rpm,3 phase salient pole alternator has 180 turns/phase. Calculate the…

Q: The diagrams show three generators. Which are alternating current Generators? coil rotation soft…

A: In a DC machine, the permanent magnet is used to generate the magnetic flux and a conductor is…

Q: Example 16.2. A moving-coil ammeter has springs giving a control constant of 0-3 × 106 Nm per…

A: Given a moving coil ammeter has, Springs giving a control constant, K=0.3×10-6 Nmdegree Deflecting…

Q: c) The O.C.C. of a DC shunt generator running at 300 rpm is as follows. 4 6. 7 Ir (A) Eo (V) 2 92…

A: It is given that: N=300rpm OCC Table:

Q: 3. Calculate the reactance voltage for a machine having the following particulars. Number of…

Q: In DC motor, if speed decreases then the Supply voltgae increases O Flux increases Flux decreases O…

A: Choose the correct option In DC motor, if speed decrease then?

Q: A 4-pole shunt generator with lap connected armature having field and armature resistance of 50 'N…

A: Given: Shunt generator, Poles, P=4 Lap wound, A=P=4 Armature resistance is Ra=0.10 Ω Field…

Q: Q2. A coil with an inductance of 8.5H and number of turns is 1500. Calculate: a. The flux linked…

A: In this question we need to find a flux and voltage of the coil at given condition.

Q: 7. The commercial efficiency of a shunt generator is maximum when its variable loss equals . . loss.…

A: Commercial Efficiency of shunt generator- It is defined a ration of generator output to mechanical…

Q: 14.1 H.P. is equivalent to a) 0.746 W b) 0.746 kW c) 7.46 W d) 7.46 kW 15 The difference between…

A: As per the guidelines of Bartley we supposed to answer first three mcq question only.

Q: 5. The following figures give the O.C.C. of d.c. Shunt generator driven at a constant speed of 700…

A: The following table is shown below: The graph is shown below:

Q: A- The benefit for the following: Stroboscope, Tachometer, Prime mover, Torqometer. B-Discuss the…

A: Stroboscopes are versatile equipment that can be used to visualize extremely fast motions. They are…

Q: A speed indicating device consist of a 2pole permanent magnet DC generator with a 2000 ohm DC…

A: The power system consists of power generation, transmission, and distribution. The transmission…

Q: D. Scientists plan to do a third experiment in order to find a generator with the greatest useful…

A: Current through a conductor generates a magnetic field which is circular in nature around a…

Q: 3. A shunt machine connected to 250V mains has an armature resistance (including brushes) of 0.120…

Q: A 2 pole, 50 Hz, 11 kV, 100 MW alternator has a moment of inertia of 10,000 kg.m2. The value of…

Q: A short composite motor draw or pulls stream a current of 50 A at a voltage of 220 V it rotates at…

A: A short composite motor is nothing but a short shunt compound motor. The given parameters for a…

Q: Can you explain the given questions in an original way? Compound Generators

A: As per Bartleby guidelines we are allowed to solve only one question, since these parts are…

Q: If the inertia constant is 6 MJ/MVA, and the rating of the generator is 10 MVA, find the energy of…

Q: 3. Calculate the reactance voltage for a machine having the following particulars. Number of…

Q: 1. A 1500KW, 550v, 16 pole generator runs at 150 rpm. What must be the useful flux if there are 2500…

Q: The voltage induced in a generator is 110 V when the armature rotates at 1100 r/min. What will the…

Q: Calculate the value of wind rotor Efficiency(Cp) for the following Wind speeds: Upward wind…

A: The tip speed ratio =4515 = 3

Q: The coefficient of coupling between two coils is 60%. The excited coil produces a flux og 0.2 Wb.…

A: As per the guidelines of Bartleby we supposed to answer first question only for solution of…

Q: Calculate the energy required for a geared dc motor to lift a 2200-1b load through 50ft in 10…

Q: Q.5 Explain why are some parts of electrical machines laminated? [CO-1; CO-3]

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Q: Q4-) A dc generator rotate at 300 r/min. The stator is designed for 6 pole. Total produced magnetic…

A: Given that N=300 rpmP=6 Total flux=0.18 Wb Although formula for induced emf is given by…

Q: 3. Determine and evaluate the motor electrical time constant Te. This is done by assuming that the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The first question: An induction motor rotates at a speed that gives a slip factor of 20 percent.…

Q: The DC voltage is generated in the Field winding of DC Generator. Select one: True False

Q: 1. Calculate the demagnetising amp-turns of a 4-pole, lap-wound generator with 720 turns, giving 50…

A: As per guidelines we are supposed to do only 1st question when multiple questions are given. So…

Q: The diagrams show three generators. Which are alternating current Generators? coil rotation soft…

Q: a) A stepper motor has a step angle of 1.8° and it is driven at 6500 pps. i) Calculate the shaft…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: b) An electric motor has 50 turns of rectangular coil with dimension of 15 cm x 30 cm, rotating at…

A: Given, the electrical motor has (T) = 50 turns Speed of rotation (N) = 18 Rps Flux density (B) = 25…

Q: .A 110-V dc motor draws a current of 30A and is located 500 ft from the power source. What is the…

A: In this question, Choose the correct option What is value of source voltage Vs?

Q: The emf generated by a dc generator depends upon both the flux and speed. Select one: O True O False

A: emf equation of the dc generator is as follows Eg = ∅ZPN60A

Q: The motor rotates quickly, giving a slip factor of 20 percent. The output power is 36.8 kW and the…

A: Rotor cupper losses = developed power - rotor input. Stator input = rotor input +stator losses.…

Q: A compound motor short draw a current of 50 A at a voltage of 220 V it rotates at a speed of 1200…

A: Emf induced = terminal voltage- voltage drop in armature and series field winding resistance.…

Q: 7. The commercial efficiency of a shunt generator is maximum when its variable loss equals . . loss.…

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: A coil has 480 turns and flux in it changes from 0.24 mWb to 1.2mWb in 0.24 seconds. Calculate the…

A: When the flux changes through the coil, a emf is induced in the coil.

Q: Q1: A d.c. shunt-wound generator running at constant speed generates a voltage of 150 V at a certain…

A: In this question dc shukr generator is given..We have to find out change in generated voltage when…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

100%

نقطة واحدة
Shunt generator running at
1500 rpm, if flux is reduced
by half, then what is the new
* speed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

4.) A two-pole three-phase 50-Hz Y-connected AC generator has 9 slots per pole and 6 conductors per slot. What is the flux per pole if the voltage on open circuit is 1.1 kV. Assume a coil span of unity Subject Electrical machine 2
the coil of a two-pole (one south pole and one north pole) generator is rotating at a speed of 1600 t/min. the flux per pole is 5.5x10^3 maxwells. calculate the voltage induced in the coil if it has 400 turns.
1. The resistance of the field coils with copper conductor of a dynamo is 120 Ohms at 25 o C.After working for 6 hours on full load, the resistance of the coil increases to 148 Ohms.Calculate the mean temperature rise of the field coil. Take the temperature coefficient of theconductor material as 0.0042 at 0 o C. 2. The resistance of the field coil of a 400 kW, 230-Volt shunt generator is measured after themachine has been standing for some time in a room temperature of which is 21 o C and isfound to be 14.6 Ohms. After the generator has been in operation for three hours, theresistance is again measured and found out to be 18.2 Ohms. Determine (a) averagetemperature of field coils after 3-hours; (b) temperature rise. 3. A certain copper winding has a resistance of 0.25 Ohm @ a temperature of 18 o C.Calculate the temperature rise in the winding, when after the period of operation theresistance increases to 0.81 Ohm.
A 25kW series generator has an efficiency of 85% when operating at ratedload. If the stray power loss is 20% of the full load loss, calculate theefficiency of the generator when it is delivering a load of 15kW.
the coil of a four-pole (two north pole and two south pole) generator is rotating at a speed of 1800 t/min. the flux per pole is 8.5x10^3 maxwells. calculate the voltage induced in the coil if it has 400 turns.
How to calculate to continues power of 500KVA generator at 60hz, 440v, pf 0.8?
The ohmmeter registers the value of the resistances as follows: Ra= 0.02 ohms; Rf= 80 ohms; Rse=0.03 ohms. The emf induced by the generator is 510 V while the terminal voltage is 500 V. Determine the load current delivered assuming that the generator is a short shunt compound generator.
Determine the main dimensions and Turns per phase (T ph )of 1 3000 kVA 6.6 kV, 50 Hz, 187 r.p.m., 3-phase, star connected alternator. Assume average flux density 0.58 Wb/m², ac = 35000. Assume pole arc/pole pitch = 0.7.
Find the no load line voltage of a star connected 4 pole alternator from the following: Flux per pole = 0.12 Wb Slots per pole per phase = 4 Conductors/ slot = 4 Two layer winding, with coil span = 150°
3. In watt meter both voltage & current coils are energized to produce bidirectional torque. Select one: True False
A 500 KVA,3.3 KV,50 Hz,600 rpm,3 phase salient pole alternator has 180 turns/phase. Calculate the length of the air gap ,if the average flux density is 0.54 Wb/m2;ratio of pole arc to pole pitch is 0.66;SCR is 1.2; the gap contraction factor is 1.15 and winding factor is 0.955.The mmf required for air gap is 80% of no load field mmf.. ..
A 30kW series generator has an efficiency of 88% when operating at rated load. If the stray power loss is 15%of the full load losses, calculate the maximum efficiency of the generator. Assume that the stray power loss isconstant and the other losses vary as the square of the load,