signal are equal. The function of positive portion of the baseband signal is f(t)=t2 while the negative portion is of rectangular shape. If the units of the signal are volts and the maximum instantaneous power is 12W while the total signal cycle time is 12Sec, calculate the minimum instantaneous power and the average power of the modulated signal.

signal are equal. The function of positive portion of the baseband signal is f(t)=t2 while the negative portion is of rectangular shape. If the units of the signal are volts and the maximum instantaneous power is 12W while the total signal cycle time is 12Sec, calculate the minimum instantaneous power and the average power of the modulated signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Problem1 A baseband signal with frequency components from near dc to 15 kHz frequency modulates a 200-kHz carrier, andthe frequency deviation is ±3 kHz. The signal is applied as the input to a cascade of two frequency triplers and onefrequency doubler. Determine the output (a) center frequency, (b) frequency deviation, and (c) deviation ratio (d) A VCO has an unmodulated carrier frequency of 100 MHz and sensitivity of −12 kHz#V. Determine thefrequency when the input signal is set at 5 V.
Type your question here The modulating signal ?(?) = 2 cos 100 ?? + ??? 400?? is applied at the input of a DSB/ SC modulator operating at a carrier frequency of 1 ???. Sketch the spectral density of ?(?) and the resulting AM-DSB/SC waveform identifying the upper and lower sidebands.
Consider the AM modulated waveform shown below: Find the modulating signal frequency, and the carrier frquency Calculate the sidebands power, the carrier power, and the power efficiency sketch the amplitude spectrum of the waveform.
A baseband signal with a spectrum occupying frequencies from 0 up to 4 kHz is DSBSC-modulated using a 240 kHz carrier frequency and is undersampled at 10 kHz. Which harmonic of the sampling train’s spectrum achieves the direct conversion of the so modulated signal?
Write the equation for the Power Spectral Density of the filtered signal ?
Which of the following is the result when the lower band components of the double sideband signal given the spectrum in the figure are multiplied by cos (Wct) in the signal time space obtained by suppressing the lower band components with a filter?
An analog signal is given as?(?) = 5 + 2 cos(20??) + 3 cos(400??)a) What is the bandwidth of ?(?)? Determine the Nyquist sampling frequency for ?(?), both in radian/sec (?? ), and in Hz (?? ).b) Formulate ?? (??), the signal sampled with the Nyquist frequency.c) Plot frequency spectrum of the sampled signal, ?? (??).d) Determine the filter to reconstruct the signal ?(?).e) Is it possible to reconstruct the signal ?(?) for ?? = 0.004 [s]? State that if aliasing error occurs or not.
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
For an FM modulator with a modulation index mf = 1, a modulating signalVm(t) = Vm sin(2π1000t) and unmodulated carrier Vc(t) = 10 sin(2π500kt),determinea) Number of sets of significant sidebandb) Their amplitudec) Then draw the frequency spectrum showing their relative amplitudesd) Determine the unmodulated carrier power for the FM modulator(assume a load resistance RL = 50 Ω)e) Determine the power in the modulated carrier and each side frequency,and sketch the power spectrum for the modulated wave.
-MCQ- FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The frequency deviation constant kf = 25 Hz/V, the carrier is a cosine sign with an amplitude of 10V and a frequency of 2000Hz. The FM modulated signal is passed through a bandpass filter and 90% of the power of the modulated signal remains. What is the bandwidth of the FM modulated signal in this case? a) 240hz b) 20hz c) 100hz d)200hz
Chose the correct answer 6- The bandwidth required for a modulated carrier depends on: a) The carrier frequency b) the signal-to-noise ratio c) the signal-plus-noise to noise ratio d) The baseband frequency range
What are the advantages and disadvantages of single-sideband transmission? Briefly describe each.