signal has the form u(t) = 100 cos[27 f.t +4 sin 27 fmt] %3D where f. = 10 MHz and fm = 1000 Hz. 1. Assuming that this is an FM signal, determine the modulation index and the transmitted signal bandwidth. 2. Repeat part 1 if fm is doubled. 3. Assuming that this is a PM signal determine the modulation index and the transmitted signal bandwidth. 4. Repeat part 3 if fm is doubled.

signal has the form u(t) = 100 cos[27 f.t +4 sin 27 fmt] %3D where f. = 10 MHz and fm = 1000 Hz. 1. Assuming that this is an FM signal, determine the modulation index and the transmitted signal bandwidth. 2. Repeat part 1 if fm is doubled. 3. Assuming that this is a PM signal determine the modulation index and the transmitted signal bandwidth. 4. Repeat part 3 if fm is doubled.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A.) An FM signal , 2000 sin(2π x 108t + 2sin πx 104t), is applied to a 50 ohms antenna. Determine: (a) The carrier frequency. (b) The transmitter power. (c) The modulating index. (d) The intelligence signal frequency. (e) The bandwidth (using the two methods) (f) The power in the largest and smallest side bands.
Q2 (B) Given m(t) = sin 2000 πt, kf = 200,000π, and kp = 8000 π.Find frequency deviation, Δf, for(i) Frequency Modulated (FM) signal(ii) Phase Modulated (PM) signal.
An FM signal, eFM = 50 sin [2π(800k)t - 4 sin 2π(5k)t] is produced by a frequency modulator with -500Hz/V frequency deviation constant. Determine (a)Determine the equation of the carrier signal (b) What is the equation of the modulating signal (c) Determine the approximate bandwidth of the FM signal (use Carson’s Approximation)
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
-The modulating signal 2cos (2 π×103 t) is used to modulate a carrier signal 40cos (2 π×104t). Evaluate the modulation index, percentage modulation, frequency of side band components and their amplitudes .What is the bandwidth of a modulating signal.
Given the AM wave equation: eAM = 40 sin 20000πt + 10 cos 16000πt – 10 cos 24000πt, calculate the modulation index, percent modulation, amplitude of the modulating signal and the frequency of the carrier and modulating signal.
A frequency modulated signal is generated by modulating the carrier signal c(t) = 40 cos(2pi fc t),with fc = 106 MHz.The phase function of the FM modulated signal is known to be phase(t) = 10 sin(12,000pi t).Determine1. the average transmitted power of the FM modulated signal u(t),2. the peak-phase deviation,3. the peak-frequency deviation,4. the bandwidth of the FM modulated signal.
Obtaining broadband FM signal from narrowband frequency modulated (FM) signal is shown below. The narrowband FM signal has a maximum frequency deviation of 100 Hz. The frequency of the local oscillator is f0=100 kHz. Since the sign at point A is Ac(cos 2πf0t+θ(t)), express the signs at points B and C. Ac is a constant and θ(t) is a function of m(t).
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
In an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495MHz, 1200 times/sec by a 5V sinusoid. a. determine the carrier frequency and intelligence signal frequency b. calculate percent modulation c. determine the amplitude of the modulating signal necessary to deviate the carrier between 103.507 and 103.493 MHZ, calculate the intelligence signal amplitude
A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplitude of 20 V. a. Sketch the audio signal. b. Sketch the carrier. c. Construct the modulated wave. For a, b and c - label your diagram d. Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves. Kindly answer a-f. Please have mercy. Thanks!
The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos( 20000πt), where f.= 100MHz. The peak-frequency deviation is 20 kHz. The modulated signal is a wide-band FM.1. Determine the amplitude and frequency of all signal components that have a power level of at least 10% of the power of the unmodulated carrier component.2. From Carson's rule, determine the approximate bandwidth of the FM signal.