Quiq plz A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt]whereVc = 11 VwC = 618.893753MHZ%3Dmf = 63%3Dwm= 6465 HzFind the following:(i) expression of carrier ((i1) expression of message [(ii) modulation index mf [(iv) frequency deviation Af(v) deviation sensitivity if the maximum amplitude of the message is 5V [(vi) power dissipated in 1460 resistor [(vii) Bandwidth of the FM Wave[

A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt] where Vc = 11 V wC = 618.893753MHZ %3D mf = 63 %3D wm= 6465 Hz Find the following: (i) expression of carrier ( (i1) expression of message [ (iii) modulation index mf [ (iv) frequency deviation Af (v) deviation sensitivity if the maximum amplitude of the message is 5V [ (vi) power dissipated in 1460 resistor [ (vii) Bandwidth of the FM Wave[

A radio station transmits the signal s(t) = Vc sin [wct + mf sin wmt] where Vc = 11 V wC = 618.893753MHZ %3D mf = 63 %3D wm= 6465 Hz Find the following: (i) expression of carrier ( (i1) expression of message [ (iii) modulation index mf [ (iv) frequency deviation Af (v) deviation sensitivity if the maximum amplitude of the message is 5V [ (vi) power dissipated in 1460 resistor [ (vii) Bandwidth of the FM Wave[

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Want to see the full answer?

Check out a sample Q&A here

See Solution

Knowledge Booster

Pulse Analog Modulation (Pulse Amplitude Modulation [PAM], Pulse Width Modulation [PWM], Pulse Position Modulation [PPM])

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An FM transmitter is determined to have a transmitter sensitivity of 498.716Hz/V. If the modulating signal is designed to be 15.998V, and the modulation index is kept to be at 1.5, solve for the highest upper sideband frequency in MHz considering that the carrier signal has a frequency equal to 172.255MHz.
1.An FM transmitter is determined to have a transmitter sensitivity of 203.314Hz/V. If the modulating signal is designed to be 13.158V, and the modulation index is kept to be at 5, solve for the peak voltage of the 1st sideband. if the carrier signal is determined to be Vc(t)=25sin(2π160000000t) 2.An FM transmitter is determined to have a modulation index of 5. If the carrier voltage is determined to have a peak voltage of 24.800Vp. Solve for the power transmitted in dBrnC of the highest sideband considering a transmitter antenna resistance of 116.204Ohms.
An FM transmitter is determined to have a transmitter sensitivity of 287.874Hz/V. If the modulating signal is designed to be 20.232V, determine the frequency iof this modulating signal if the modulation index is kept to be at 1.
An FM transmitter is determined to have a transmitter sensitivity of 203.314Hz/V. If the modulating signal is designed to be 13.158V, and the modulation index is kept to be at 5, solve for the peak voltage of the 1st sideband. if the carrier signal is determined to be Vc(t)=25sin(2π160000000t) An FM transmitter is determined to have a modulation index of 5. If the carrier voltage is determined to have a peak voltage of 24.800Vp. Solve for the power transmitted in dBrnC of the highest sideband considering a transmitter antenna resistance of 116.204Ohms. An FM transmitter is determined to have a transmitter sensitivity of 728.832Hz/V. Determine the percent modulation of the system if the modulating signal is determined to be Vm(t)=25sin(12566.3706t)Vm(t)=25sin⁡(12566.3706t).
1.Select the correct statement(s) regarding the FM Index. a. Δf represents the amount of frequency that the carrier wave can change in order to represent the baseband (information/message) signal b. β=(KvcoAm)/fm is a ratio that has no units c. the larger the FM index, the greater the frequency bandwidth d. all statements are correct 2. Select the correct statement(s) regarding viewing an information signal in time and/or frequency domains. a. only the viewing a signal in the time domain is important since the transmission/carrier frequency is an assigned parameter b. observing the signal in the time domain does not give you information regarding the capacity or bandwidth of the signal c. a signal observed in the frequency domain provides information regarding signal amplitude and the periodic or non-periodic nature of the signal d. all of the above are correct 3. Select the…
An audio signal described as 25 sin 2π (5 X 103 )t amplitude modulates a carrier which is described as 40 sin 2π (1 X 106 )t Determine the modulation factor, percent modulation and the upper and lower sideband frequencies and write the AM equation.
What is the bandwidth of an AM signal whose carrier is 2.1 MHz modulated by a 1.5-kHz square wave with significant harmonics up to the fifth? Calculate all the upper and lower sidebands produced? (Our lesson is AMPLITUDE MODULATION FUNDAMENTALS) (Please box the answer )
2. From the expression of a frequency modulated signal given asΦFM(t)=8cos(109πt + 7sin104πt); find the values of Δf, carrier frequency,modulation index.
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
In a broadcast superheterodyne receiver having no RF amplifier, the loaded Q of the antenna coupling circuit (at the input to the mixer) is 100. If the intermediate frequency is 455 kHz, calculate the image frequency and its rejection at 25 MHz.
The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos( 20000πt), where f.= 100MHz. The peak-frequency deviation is 20 kHz. The modulated signal is a wide-band FM.1. Determine the amplitude and frequency of all signal components that have a power level of at least 10% of the power of the unmodulated carrier component.2. From Carson's rule, determine the approximate bandwidth of the FM signal.
A) The effective aperture of a 144.0cm-diameter parabolic reflector antenna is 6m of the physical aperture area. Compute the gain in dB at 10GHz. b) Vodafone decides to use a digital TDMA scheme that can tolerate a Signal-to-Interference Ratio of 17dB in the worst case. Find the optimal value of the path lost exponent for an omnidirectional antenna; assuming i=3 and j=2. Assume that there are six co-channel cells in the first tier, and all of them are at same distance from the mobile. Use suitable approximations. c) Draw the table of frequency assignments and system layouts for a seven-cell repeat pattern and three-sectored antenna per cell site, using E-GSM 900MHz in which the total number of channels needs to be divided, assuming that the full spectrum is available from the operator of the system is used. In the sixth (6th) cluster, list all the possible channels that will be assigned to the cells in sector B?