Since Vcc = 12 V, Vin = 690 mV, RB = 780 kΩ, RC1 = 27.9 Ω, RC2 = 25.4 Ω, RE = 470 Ω, RL = 47 Ω and β1 = β2 = 100 in the circuit in the figure Find the current (IL) flowing through RL? NOTE-1: VBE1 = VBE2 = 0.7 V will be taken. NOTE-2: Output impedances of transistors (r0) will be neglected. a. 16,56 mA b. 23,46 mA c. 8,28 mA d. 17,94 mA e. 20,70 mA f. 13,80 mA g. 26,22 mA h. 11,04 mA

Q: QUESTION 1 Assume Vcc = 15 V, ß =150, V3e = 0.7 V, RE = 1 k2, Rc = 4.7 kQ, R1 = 47 k2, R2 = 10 k2,…

A:

Q: VGSQ = 7 V, C1 = 64 nF and C2 = 33 nF in the circuit in the figure, what is the low cut-off…

A:

Q: Vcc = 10 V B = 200 Rc =2 k2 + RB = 220 k2 VBB = 4 Vo- VCE + IB VBE

A: Given: Consider the following circuit: To find: Load line intersection.

Q: A piezoelectric system having 500mV output for pressure measurement, design an inverting amplifier…

A: Solution: According to the given condition, the circuit diagram is, Gain=VoutVin=2500×10-3=4…

Q: (a) What is the ratio iC/iE as shown for vI =0.8 V? If needed, you may use the parameters inTable…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: H.W.t,;- For the civcuit shown, calcubeke Ave, Rips mel Rof &what is the feedback topology- Vec Vo…

A: Voltage gain, input impedance and output impedance of the above circuit can be calculated from small…

Q: Q3 Refer to Figure Q3. Given the amplifier parameters: IcQ=3 mA, B = 150, V₁ = 26 mV, and VA = 00.…

A:

Q: For the circuit in the figure, find the ones requested in the questions by using the following…

A:

Q: For the amplifier in the figure below, the circuit parameters are: Vcc = 15 V, VEE = 15 V, VA3 = 75…

A:

Q: 5) For the feedback pair of circuits below: a. Calculate the de voltages VB- VB VC Vc; VE, and VE b.…

A: Answer -

Q: QUESTIONS (a) Figure Q.1 (a) represents a common emitter amplifier. Given ß-100, VON-0.7V, Vaq-1.7…

A:

Q: For the circuit shown below, calculate: - 1. The input impedances (Z;), (Zif). 2. the loaded output…

A: First we will do dc analysis to calculate transconductance then we will find out gain and input and…

Q: Q-4: A- Calculate the common-mode output voltage and A, voltage gain for the circuit below, where V…

A:

Q: Q3 Refer to Figure Q3. Given the amplifier parameters: IcQ=3 mA, B = 150, V₁ = 26 mV, and VA = 00.…

A: For the above given question we need draw hybrid π model of the given common collector amplifier.

Q: QI:- For the multistage amplifier of figure (1), assume rel 6.1 2 and rel 12.84 2, hrel hre2 = 0,…

A:

Q: 10 V Va -10 V Vb The difference amplifier is shown in (Figure 1). Suppose Ra = 1 k2, R = 50 k2, Re =…

A: Using Superposition theorem, the value of the output of the differential amplifier circuit can be…

Q: Q1) For the circuit, exactly find:- VCEQ and ICa respectively are equal? At ICQ [IC(sat)]/2, so VEE…

A:

Q: Voc= +20V R, B=100 Please analyze the circuit and determine the voltage gain of both (Av,dc = Vc/Vb…

A: We will perform  dc and ac analysis , we wil find out ac parameters.

Q: Q \ In the circuit shown in determine VC, IC, IB, if B=50.

A:

Q: A- Calculate the common-mode output voltage and Ac voltage gain for the circuit below, where V; =…

A:

Q: Q: For circuit shown below, find rd then calculate Zi, Zo and Av. Where VDD-20 V, IDSS - 10 mA and…

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: Vec +10V Ist stage 2nd stage 47 kn 4.7 kn I uF Vo- C. 100 F 10 kn LOKA T100 F 10 kn 10 k Boc =B- 150…

A: Plot of gain vs frequency

Q: Voc= +20V B=100 Please analyze the circuit and determine the voltage gain of both (Av,dc = Vc/vb for…

A: We will do DC analysis and AC analysis for given circuit , we will find out DC current then ac…

Q: Figure 1 shows a well-known circuit configuration with the bypassed source resistor using an…

A:

Q: For the circuit given below, and find the formulas for: Vout a. Output voltage gain, which is…

A: for our policy, i can solve first three parts

Q: The target output impedance value for the degenerated current source circuit with MOSFET is Rout=…

A: We need to calculate Rs , we will calculate it by putting all other value in given Ro formula .

Q: Problem 5. For the cascaded system below with two identical stages, determine: (d) How Zo is…

A: We need to find out output impedance and phase shift between input and output.

Q: e circuit shown in figure beside, find the total ave ?delivered to

A:

Q: 0.1 For the circuit shown, calculate the Av and RE that required to get 5KHZ lower critical…

A:

Q: For the amplifier circuit given in figure below with Rr (Rc = 2.7 k2, REI = 0.4 k2, RE2 = 0.6 k2, Cy…

A:

Q: the input and output impedances : amplifier configuration in Figure below is Al = 175,000 Zin = 10…

A:

Q: Calculate the closed loop gain for the following circuit. Assume A = 0 for both transistors and R,+…

A: The small signal equivalent of the given circuit is

Q: Q1) For the circuit, exactly find:- VCEQ and ICQ respectively are equal? At ICQ = [IC(sat)]/2, so…

A:

Q: Q2. Given the circuit configuration below, Vcc=VEE=6V, R = 2kn Rc = 6kn, Re = 5kn, Rb = 0, Rw = 2002…

A: The circuit is given as Diffential voltage gainAd=α2R+RC2re+RW2

Q: Q1: For the circuit shown in figure. Derive the stability factors S(Ico), S(VBE) and S(B). RB www…

A: For the given circuit calculation of Stability factor expression. SICo=∂IC∂ICoSVBE=∂IC∂VBESβ=∂IC∂β

Q: b) An input voltage source Vs of 130mV RMS and an internal resistance Rs of 100 is connected to an…

A:

Q: For the amplifier network shown in the figure, neglect the le 012 sin(2m*1000t-180°) Ob8…

A: We need to find out the output voltage for given circuit

Q: is P Vo P 0.8 pf lagging 0.9 pf lagging ?For the circuit shown above, what is the input power factor…

A: Power factor- It is the ratio of the total power and the utilized power which means it indicate that…

Q: Lhat the T00, and the vCE n ngui collector current. Şekildeki devre için VBE =710 mV, B = 100 ve VA…

A:

Q: For the opamp circuit shown below figure, calculate the followings by assuming Ao=D00, 1. What is…

A: Op amplifier  Pole frequency =0.7MHz Zero frequency =0.7MHz/20 R1 = 3.1Kohm R2?  C?

Q: 1. Given a circuit in figure 1.1 where an amplifier model is proposed courant source with values…

A:

Q: Q1) For the circuit, exactly find:- VCEQ and ICQ respectively are equal? At ICQ = [IC(sat)]/2, so…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: 3) With reference to the switching conditions given below develop an appropriate circuitry that can…

A: Introduction: Diode converters AC (Alternating current) supply in DC (Direct current) supply. This…

Q: Consider the following step up converter with a resistive load of value RS ohms. it is supplied by a…

A:

Q: Q1. Find the input impedance Zn(S) of each of the circuit in Figure Q1.

A:

Q: Perform the following steps for the given circuit in below. a) Find the Vo, if the Vs = 120mV_peak,…

A: ID = IDSS 1-VGSVp2 ID = 121-1.1ID42 ID = 12164-1.1ID2 I =0.75(16-8.8ID+1.21ID2) ID…

Q: Design a transistor amplifier to supply a LED. The LED is required to turn on and off following the…

A:

Q: Given a feedback uniy GCs) = k(s+4) Cs+x) (S-1) (s-8) find out following: ystem cwith %3D i) Sketah…

A: " Since you have posted a question with multiple subparts, we will solve the first three subparts…