Sketch within a cubic unit cell the following planes: (a) (011) (b) (112) (c) (102) (d) (131)

Q: A solar pond power plant produced power output at 350 kW and thermal efficiency of 4%.Sketch the…

A:

Q: Air enters the compressor of an ideal air-standard Brayton cycle at P1-98 kPa and T1-320 K, with a…

A:

Q: Given: The bucket shown below is lifted with 3 forces. Determine the force F2 such that the…

A:

Q: The viscosity of a light mineral oil is tested by the settlings sphere method given the following…

A:

Q: An insulated piston- cylinder contains ammonia at 1000 kPa, 50°C. Ammonia is expanded in a…

A:

Q: 5.23. Refer to Fig. 5-24. The body A weighs 32.8 lb and rests on a smooth surface. The body B weighs…

A: The FBD of the system is as follows-

Q: 500 kN/m 500 kN/m [M 3 3 3 F 1000 kN/m F w onsider the spring assemblage shown in the figure above.…

A: The force is

Q: a) 0.2% offset yield strength b) Tensile strength

A:

Q: 3.113 The piston/cylinder in Fig. P3.113 contains 0.1 kg water at 500°C, 1000 kPa. The piston has a…

A: The objective of the question is to understand the thermodynamic process of water in a…

Q: Two couples act on the beam. If the resultant couple is to be zero, determine the magnitudes of P…

A: Find out-Magnitude of P and F and distance d.

Q: 3.6 WP SS For H₂O, determine the specified property at the in cated state. Locate the state on a…

A:

Q: (a) The height of the sand layer at the onset of fluidisation (b) The pressure drop in the fluidised…

A: DefinitionFluidization:Fluidization is a fascinating process where solid particles behave like a…

Q: A single-piece bicycle crank is shown below under the following load: the rider pedals forward with…

A:

Q: A two floor building has two faucets, one in the basement and one in the first floor. The maximum…

A: To find:(a) Maximum velocity at the first floor faucet, when the basement faucet is closed?(b)…

Q: A cord supported at A and B carries a load of 20kN at D and a load of W at C as shown in Figure(5).…

A:

Q: During Extension of vertical cylinder Pressure Reading PSI 140 Flow Meter Reading 500 GPM 2.8 Time…

A:

Q: Determine the acceleration of Block A Determine the acceleration of Block B Determine the tension of…

A:

Q: The 3.9-lb force is applied at point A of the crank assembly. Determine the moment of this force…

A: Given ,The 3.9-Ib force is applied at point A of the crank assembly. To find -   moment of the force…

Q: Water at 30°C flows down a vertical pipe with no pressure drop.

A: Given:Temperature of the water, The pressure drop,

Q: Convert into engineering notation using si prefixes or si symbols with 3 significant digits…

A: Values are given as 0.0000035674 amps176234.178 volts

Q: A special sensor is designed to sense the percent vapor present in a liquid vapor mixture. If during…

A: Find out the sensitivity of the sensor.

Q: Assuming specific weight of air to be constant at 12 N/m3, what is the approximate height of a…

A:

Q: The fireman wishes to direct the flow of water from his hose to the fire at B (Eigure 1) Y D Part A…

A:

Q: The instruction booklet for your pressure cooker indicates that its highest setting is 12.7 psi. You…

A:

Q: Determine the position of the centre of gravity y.

A: Given datathe side of the larger cube a = 32 mmthe side of the smaller cube b =19 mmFind Outthe…

Q: Three metal rods are firmly attached to the walls and the middle rigid plate. Rod AB is made from…

A: The stress of a bar is the ratio of internal force to cross-sectional area.Mathematically,

Q: 76. In the drawing view, use a notation to identify a datum feature reference and another notation…

A: The datum is defined as the locus surfaces or the starting points for the location and orientation…

Q: In the figure below, a lug wrench is subjected to loads as shown. The tool body is a hollow cylinder…

A:

Q: k=1000 lb/in. k = 1000 lb/in. f(1) 2x = Consider the spring assemblage shown in the figure above.…

A:

Q: 5. Two couples act on the beam. If the resultant couple is to be zero, determine the magnitudes of P…

A: Find out-Magnitude of P and F and distance d.

Q: Exercise 1 - stiffness matrix of a simple frame. Find the stiffness matrix for the problem on the…

A: The value of E is The value of A is The length is

Q: 4. A stunt plane flying at the Reno Air Races is moving through the sky. The rectangular coordinates…

A: The rectangular coordinates decribing the motion is

Q: 2.103 A gate having the cross section shown in Fig. P2.103 is 4 ft wide and is hinged at C. The gate…

A: Find outDetermine the vertical reaction at A on the gate when the water level is 3 ft above the…

Q: A bicycle racer sprints at the end of a race to clinch a victory. The racer has an initial velocity…

A:

Q: 250 N 200 mm 20 mm E 40 mm 100 mm 50 N 160 mm 300 N Four forces are applied to the machine component…

A:

Q: (6) If a room is to be heated to 70° F. when it is 10° F. outside, (a) what will be the design…

A:

Q: In the context of a Spark Ignition (SI) engine, consider a moment during combustion when there is a…

A: Given:Heat flux through the wall of the combustion chamber, The gas temperature within the cylinder,…

Q: Home Work: Determine whether the block shown is in equilibrium and find the magnitude and direction…

A:

Q: flow rate of water in the pipe which is con ed to tank B is the flow rate in the other two pipes and…

A:

Q: Q1). Sketch the [102] direction in a simple cubic lattice h e h Q2). Find the Miller indices of the…

A:

Q: Question 1 (Type B) Given the figure shown below, what is the mass of block B on the smooth incline…

A:

Q: (Dynamics Question 4): Ball A comes at an angle of 45 degrees and a speed of 2 m/s and hits ball B,…

A: Given:The speed of the marble A before collision, Marble B is at rest before the collision, so the…

Q: The hoist consists of a single rope and an arrangement of frictionless pulleys as shown. If the…

A:

Q: Two 4.5-\mu F capacitors, two 2.5 k\Omega resistors, and a 20.0 - V source are connected in series.…

A: Capacitance of the capacitor C = 4.5 x10-6 FResistor connected in series with the capacitor R = 2…

Q: 2.128 An open tank containing water has a bulge in its verti- cal side that is semicircular in shape…

A:

Q: Draw a sketch of the (111) plane of the FCC unit cell. Are these atoms close packed? Draw a sketch…

A: Introduction to concepts involved:Crystal Lattices: Imagine points in space that represent atom…

Q: 76. In the drawing view, use a notation to identify a datum feature reference and another notation…

A: The datum is defined as the locus surfaces or the starting points for the location and orientation…

Q: What is the velocity profile from the center of the pipe (r=0 cm) to the pipe wall (r; = 2.9 cm)?…

A: Velocity profile will be parabolic in nature, governed by equation mentioned above.

Q: Is there the range of pipe diameters D for which the flow is definitely laminar? O No O Yes, the…

A: DefinitionLaminar flow:The fluid particles which move in smooth, parallel layers without mixing…

Q: Consider the spring assemblage shown in the figure above. Use the direct stiffness method. Suppose…

A:

The Space Lattice and Unit Cells

Every matter consists of atoms, molecules, and ions. If these atoms, molecules, and ions (micro-particles) are represented in a three-dimensional space-occupying certain specific points in space, then these arrangements are termed as space lattices and the specific points which are being occupied by atoms, molecules and ions are termed as lattice points. The atoms, molecules, and ions at the lattice points are generally grouped in a regular fashion and repeat periodically at the three-dimensional space.