Sometimes in lab we collect the gas formed by a chemical reaction over water (see sketch at right). This makes it easy to isolate and measure the amount of gas produced. Suppose the CO gas evolved by a certain chemical reaction taking place at 40.0 °C is collected over water, using an apparatus something like that in the sketch, and the final volume of gas in the collection tube is measured to be 63.9 mL. 0 U Sketch of a gas-collection apparatus x10 collected gas water Calculate the mass of CO that is in the collection tube. Round your answer to 2 significant digits. You can make any normal and reasonable assumption about the reaction conditions and the nature of the gases. 1 g chemical reaction

Sometimes in lab we collect the gas formed by a chemical reaction over water (see sketch at right). This makes it easy to isolate and measure the amount of gas produced. Suppose the CO gas evolved by a certain chemical reaction taking place at 40.0 °C is collected over water, using an apparatus something like that in the sketch, and the final volume of gas in the collection tube is measured to be 63.9 mL. 0 U Sketch of a gas-collection apparatus x10 collected gas water Calculate the mass of CO that is in the collection tube. Round your answer to 2 significant digits. You can make any normal and reasonable assumption about the reaction conditions and the nature of the gases. 1 g chemical reaction

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter5: Gases

Section: Chapter Questions

Problem 162CP

See similar textbooks

Similar questions

What is the value of FP for a sample of gas whose temperature is -33.0 C and volume is 0.0250 L? What temperature is required to change the volume to 66.9 cm3?
Explain why the plot of PV for CO2 differs from that of an ideal gas.
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
5-39 An 8.00-g sample of a gas occupies 22.4 L at 2.00 atm and 273 K. What is the molar mass of the gas?
97 Homes in rural areas where natural gas service is not available often rely on propane to fuel kitchen ranges. The propane is stored as a liquid, and the gas to be burned is produced as the liquid evaporates. Suppose an architect has hired you to consult on the choice of a propane tank for such a new home. The propane gas consumed in 1.0 hour by a typical range burner at high power would occupy roughly 165 L at 25°C and 1.0 atm, and the range chosen by the client will have six burners. If the tank under consideration holds 500.0 gallons of liquid propane, what is the minimum number of hours it would take for the range to consume an entire tankful of propane? The density of liquid propane is 0.5077 kg/L.
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
Calculate U when 1.00 mol of H2 goes from 1.00 atm, 10.0 L, and 295 K to 0.793 atm, 15.0 L, and 350 K.
Methane (CH4) gas flows into a combustion chamber at a rate of 200. L/min at 1.50 atm and ambient temperature. Air is added to the chamber at 1.00 atm and the same temperature, and the gases are ignited. a. To ensure complete combustion of CH4 to CO2(g) and H2O(g), three times as much oxygen as is necessary is reacted. Assuming air is 21 mole percent O2 and 79 mole percent N2, calculate the flow rate of air necessary to deliver the required amount of oxygen. b. Under the conditions in part a, combustion of methane was not complete as a mixture of CO2(g) and CO(g) was produced. It was determined that 95.0% of the carbon in the exhaust gas was present in CO2. The remainder was present as carbon in CO. Calculate the composition of the exhaust gas in terms of mole fraction of CO, CO2, O2, N2, and H2O. Assume CH4 is completely reacted and N2 is unreacted.