Isosceles triangular gate AB, as shown in the figure, is hinged at A. The horizontal force ( P)is required at point B for equilibrium. The weight of the gate is negligible, and C = 4 mJ = 3 mE = 2 mO = 60°S.G. of Oil = 0.82!!Oil, SG = 0.82Gate1.

Answered: Image /qna-images/answer/cfab2868-c694-4acf-8bb6-dde848495a36.jpg

Answered: sosceles triangular gate AB, as shown…

sosceles triangular gate AB, as shown in the figure, is hinged at A. The horizontal force (P s required at point B for equilibrium. The weight of the gate is negligible. and C = 4 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 4000 N 1.0m 2.0 m 20m 2000 N

A: ∑Fx=0Fcosθ+4000=0Fcosθ=-4000N .....(1)∑Fy=0Fsinθ-2000=0Fsinθ=2000 ........(2)

Q: Q| As shown in figure below, determine the weight of concrete cylinder, for equilibrium the gate AB.…

Q: 30 cm- Go 20 cm E 8 cm 30 cm- 25 cm- e P6.55 and P6.56 HE The elevation and tilt angle of table AB…

Q: Question 4 The prismatic bar AC is supported by a hinge at C and cable ADB that runs through a…

Q: Q.2) A plate supported by a rope and two hinges as shown in figure. Assume that hinges do not exert…

A: Given structure:

Q: Based on the following figure and its description, answer Q1, Q2, Q3, Q4 and Q5. Isosceles…

Q: The gate in the figure shown is 1.5 m wide, hinged at point A, and rests Problem 3-14 seawater, (b)…

A: Given data as per question width of gate =1.5 m The specific gravity of seawater =1.03 Considering…

Q: The box shown in fig weighs 40O N, in equilibrium Determine the tension in the cords AB and BC

A: Consider the diagram shown below for the given system.

Q: Poles 4500 g

A: Level h:

Q: . Determine the angle 0 of the 12-ft bar in the figure given where its position is in equilibrium…

A: Let RA and RB are the reactions at the point A and B respectively. And 'α' be the angle marked as…

Q: A member ABCD is subjected to point loads P,, P, P3 and P̟ as shown in Fig. the force P, necessary…

Q: Qg: If the weightless half- cylindrical gate, show in figure below, is in equilibrium, what is the…

A: Given data: The density of the fluid in the left part is, γ1 The density of the fluid in the right…

Q: A) A mass of 15.0 kg 10 pc suspended by wires in two sides as shown in the figure. Find the tension…

A: Given : Mass = 15kg Acceleration due to gravity g = 10 m/s2 its weight = ( m * g) = 15*10=150 N we…

Q: Consider the force P applied at point A on the plate of the figure shown (image 1). Assuming that…

A: Given data: Force P=332N Both the options as mentioned above are similar, however the correct…

Q: For the system shown in Figure , calculate the tension AB, mass m, and applied force P to keep the…

Q: Hello, can you give at least 1 example problems and the solutions for equilibrium of rigid bodies.…

Q: Gate AB in the figure is semicircular with a radius of 2m and is hinged at side B. Determine the…

A: Force acting on submerged body = ρgA h ρ = densityg= acceleration due to gravityA = area h =…

Q: Determine the maximum height h of a right circular cylinder mounted on a hemispherical base as shown…

Q: 300 K- 15 KN/m 3 KN 8 kN

Q: Isosceles triangular gate AB, as shown in the figure, is hinged at A. The horizontal force (P) is…

A: Given Data: The vertical distance between point A and free surface is, C=4 m. The vertical distance…

Q: When a motor is set on a pivoted mount seen below, its weight can be used to maintain tension in the…

A: Given data Totam mass of the motor and the platform m = 100kg Diameter of the pulley d = 16cm = 0.6m…

Q: Gate AB 7.5 ft wide into the paper, hinged at A, and restrained by a stop at B. The water is at…

A: Any action that attempts to keep or change the motion of a body, or to deform it. The magnitude of…

Q: 5osceles triangle gate AB in the figure below is hinged at A and weighs 1500N What horizontal force…

Q: Question 3 When the structure shown in figure (3) below is supported at point P, it is in…

Q: The system in the figure is in equilibrium. Determine the forces F, F, and F. y F2 (2m, 3m,-4m)…

A: Use the above figure to determine the position of force F1. Determine force F1 vector using its…

Q: A 7-ft boom is held by a ball and socket at A and by two cables EBFand DC; cable EBFpasses around a…

A: Given: The length of boom, L = 7 ft The force acting at C, P = 390 lb

Q: 4. The mobile shown in the figure below hangs at equilibrium. It consists of objects held by…

A: From linear equilibrium, Net upward force= Net Downward force From rotational equilibrium, Total…

Q: The prismatic bar AC is supported by a hinge at C and cable ADB that runs through a frictionless…

Q: A uniform, 200N board of length L has two weights hanging from it, 300 N at L/3 from one end and 400…

Q: Q2. The system shown below is in equilibrium. Find the reactions at A (hinge support) and the force…

A: find the reaction at point A and force at B.

Q: Q4: An inclined circular gate (AB) with hinge support at (B) and the weight of gate (12KN).…

Q: When the structure shown in figure (3) below is supported at point P, it is in equilibrium. If the…

A: Given weight of structure is negligible For equilibrium conditions Summation of horizontal forces…

Q: A sign consists of a uniform rectangular lamina of weight 50 N. It is suspended in equilibrium in a…

Q: J: the roof truss in Fig. 3, is supported by a roller at A and B. Find the value of the reactions.…

Q: A crane with a mass of 1200 kg is lifting a 2100 kg crate. There is a pin at A and a roller at B.…

A: To find: The magnitude of the support reactions at A and B. Given data: Mass of crane m=1200 kg.…

Q: Determine the reactions at A and B shown in Figure below, neglect the weight of beam 400 Ib/ft 200…

A: Given:

Q: The gate AB of shape isosceles triangle is hinged at location A. The gate weighs 1000 N. For the…

A: Gate weight = 1000 N Density of oil = 9700 kg/m3

Q: QI As shown in figure below, determine the weight of concrete cylinder, for equilibrium the gate AB.…

A: Given data: - The weight of the gate is W = 20 kN. The width of the gate is b = 3 m. The submerged…

Q: A bag of cement weighing 475 N hangs in equilibrium from three wires es suggested in the figure…

Q: 1. Isosceles triangular gate AB in the figure is hinged at A. Compute the horizontal force F…

Q: Isosceles triangle gate AB in the figure below is hinged at A and weighs 1500 N. What horizontal…

Q: In the simple cage system in the figure, which of the following is the absolute value of the force…

Q: Q4// As in figure below, calculate the magnitude of the force (R which required to maintain the gate…

Q: justify the answer 3. Gate AB in figure below is semicircular, hinged at B and held by a horizontal…

Q: A semicircular floodgate is 4.0 m long and 3.0 m radius. It is articulated at its lower point and…

Q: e prismatic bar AC is supported by a hinge at C and cable ADB that runs through a frictionless…

Q: Q2: For the system shown in figure, all chains are of negligible weight, if the tensile force in…

Q: Two smooth spheres of weight W and radius r each are in equilibrium in a horizontal channel of A and…

Q: A rectangular gate (6m x 4m) is e hinged at A and supported by a stopper as shown. Find the reaction…

A: Given: The area of gate, A = 24 m2 The centre of pressure measured from A, yp = 3+0.4641 = 3.4641 m…

Q: If the value of P in the above figure is 180-lb, determine the angle θ at which it must be inclined…

A: Given :- W = 300 lb P = 180 lb To Find:- angle θ

Question

Isosceles triangular gate AB, as shown in the figure, is hinged at A. The horizontal force ( P)
is required at point B for equilibrium. The weight of the gate is negligible, and C = 4 m
J = 3 m
E = 2 m
O = 60°
S.G. of Oil = 0.82
!!
Oil, SG = 0.82
Gate
1.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 0.5-m diameter helium (Density of He = 0.18 kg/m3) balloon is attached by a rope to the bottom of a 10-m deep freshwater lake (Fig. 1). Given that the rope can sustain a maximum tensile force of 300 N, would it be able to secure the balloon? Please clearly illustrate your free-body diagram.
Thank you in advance!! A rectangular gate AB (3mx10m), hinged at B, held by a horizontal force F2, at point A. What horizontal force F2 is required at point A for equilibrium?
A gate AB 4 ft long and 2 ft wide is held in position shown due to the spring whose constant is 96.0 Ibf/in. The spring is located compressed 1.5 ft in such a way as to keep the gate in equilibrium. Assume that on the gate (which moves through a circular sector BD as shown in Fig. figure), the force due to the spring is always horizontal. Determine the height d of the water.
Gate AB in Fig. is semicircular, hinged at B , and heldby a horizontal force P at A . What force P is required forequilibrium?
A cylindrical buoy 1.8 m in diameter, 1.2 m high and weighing 10kN floatsin salt water of density 1025kg m−3. Its centre of gravity is 0.45 m from the bottom. Ifa load of 2 kN is placed on the top, find the maximum height of the centre of gravityof this load above the bottom if the buoy is to remain in stable equilibrium.
A cube with edges of length L = 0.23 m and density ρc = 3.4×103 kg/m3 is totally submerged in water, with a density of ρw = 1.00×103 kg/m3, and oil, with a density of ρo = 0.82×103 kg/m3, as shown in the figure. The cube is submerged in the water to a depth of d = 0.065 m, while the rest of the cube is in oil. The cube is suspended by a taut string and is in static equilibrium. a) Calculate the magnitude of the buoyant force, in newtons. b) Enter an expression for the tension in the string, in terms of the defined quantities and g.
Rectangle Gate AB has length L and width b into the paper is hinged at B and has negligible weight. The liquid level, water, h does not reach the top of the gate for an angle theta. Find an equation for the force P, required to keep the gate in equilibrium. Solve for width, b. In the figure. (hint: draw a free-body diagram for the left and right side of the gate separately)
Gate AB retains water as shown in the figure. The gate is supported every 2 m (perpendicular to the plane of view) by member BC, which is attached to a 2000 kg mass at point C. What minimum static coefficient of friction μs, along the contact surface between the mass and its base, is needed for the gatestructure to be in equilibrium? There are pins at pointsA, B, andC.
In the simple cage system in the figure, which of the following is the absolute value of the force carried by the CE element in kN?
In the Figure below, the cover gate AB closesa circular opening 80 cm in diameter. The gate is held closed by a 200-kg mass as shown. Assume standard gravity at 20 °C. At what water level (h) will the gate be dislodged? Neglect the weight of the gate. Specific weight of water 9790 N/m3
Find a) the total force on gate AB in KN and b) the position of the center of pressure in m with respect to the bottom of the pond. Assume that the gate is 8 feet wide, that 1ft = 0.3048m, and that 1 psi = 6897.1 Pa. Relative density salt water 1.025.
A cube with edges of length L = 0.19 m and density ρc = 2.8×103 kg/m3 is totally submerged in water, with a density of ρw = 1.00×103 kg/m3, and oil, with a density of ρo = 0.93×103 kg/m3, as shown in the figure. The cube is submerged in the water to a depth of d = 0.055 m, while the rest of the cube is in oil. The cube is suspended by a taut string and is in static equilibrium. 1) Enter an expression for the magnitude of the buoyant force acting on the cube, in terms of ρw, ρo, L, d, and g. 2) Calculate the magnitude of the buoyant force, in newtons. 3) Enter an expression for the tension in the string, in terms of the defined quantities and g. 4) Calculate the tension in the string, in newtons.