Answered: Specify The C.O.P. of the cycle…

Specify The C.O.P. of the cycle refrigeration vapor compression a simple R-717. Temperature evaporation is -20 °C and the temperature of the condenser is 30 °C

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 4RQ: A typical temperature relationship between a high-efficiency condenser and the ambient temperature...

See similar textbooks

Related questions

Q: Water enters the condenser at 20 ̊C and leaves at 35 ̊C. What is the LMTD if the condenser…

A: Condenser temperature Th=40°CCold fluid tempreture (water at inlet and exit)Tc1=20°C ,and…

Q: Please draw the diagram of the components of the vapor compression refrigeration cycle and briefly…

Q: The capacity of a refrigeration plant is 60 kW and its design parameters are: -Evaporation…

A: The heat extracted from the cold reservoir (i.e., inside a refrigerator) divided by the work W done…

Q: Calculate the vaccum efficienty of a condenser from the following data, Vaccum at steam inlet to…

A: The answer is in the next step

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

A: Given: The suction pressure, Ps = 35 psia = 241.316 kPa The condenser pressure, Pd = 172 psia =…

Q: temperature application, a two stage operation is desirable which employs refrigerant 22 system that…

A: 1 2

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A: It is required to determine specific enthalpy at state 1

Q: Draw the schematic and p-h diagram for the problem below: A two-stage cascade refrigeration system…

Q: ideal engine that has one stage of regenerative cycle; condenser pressure is 10kPaa and extraction…

Q: A standard ammonia vapour compression cycle developing 20 tons of refrigeration operates with a…

A: RC=20 tonRC= 20×3.5=70 KwTL=-14 ° CTH=32 °C

Q: A two-stage cascade refrigeration system uses ammonia as the working substance. The evaporator is at…

Q: 6 Cond 6 Pc Wk Pi 3 7 3. Pe Evap Wk

A: Two stage compression with dry type shell coil cooler concept :- In case of refrigerant plant is…

Q: A refrigeration system is used to cool water in the evaporator at 7.5 kg/s from 30°℃ to 4°C.Find the…

A: Given data: m˙=7.5 kg/sT1=30°CT2=4°CCOP=5 Need to determine the required compressor power.

Q: 02. The Li-Br water absorption cycle operate at the following temperature: generator temperature =…

A: Generator Temperature, Tg = 90℃ = 363KCondenser Temperature, Tc = 35 ℃ = 308KAbsorber Temperature,…

Q: A cascade refrigeration system serves a 75 ton evaporator at 119.4 KPa. The system uses direct…

Q: Calculate the power required by a system of one compressor serving two evaporators. One evaporator…

A: At 10oC ; Saturation Pressure , P = 680.9 kPa Specific Enthalpy , h = 408.6 kJ/kg At 10oC ;…

Q: From the knowledge you have learned in the simple vapour compression cycle and multi-pressure…

Q: A cascade refrigeration system serves a 75 ton evaporator at 119.4 KPa. The system uses direct…

Q: 9. Water temperature rise of 18 °C in water cooled condenser equivalent in K, R and °F.

Q: In all liquid refrigerant lines, the pressure at the bottom of a vertical rise isgreater than the…

A: Given Data : h=7.5 ft h=90 in Pressure at every point in the vertical pipe (P)=0.5144 lbin2

Q: A vacuum refrigeration system consists of a large insulated flash chamber kept at a low pressure by…

A: A thermodynamic device which is used to remove the heat from the hot refrigerant vapour untill it…

Q: Steam at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative…

Q: A manufacturing company is intending to use its water cooled condenser for its proposed cold storage…

A: Given, Twaterin=30°C Twaterout=40°C Tcondensation=35°C We know, Energy Balance equation…

Q: there is an update in the previous question - A Carnot refrigeration cycle absorbs heat at 250 K…

A: Data given- T1 = 250 K T2 = 300 K Q1 = 1130 kJ/min Or Q1 = (1130/60 )kJ/s

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

Q: Systen capacities 20 TR, 30 TR and 10 TR with individual expansion valves and individual…

Q: 5. For a vapour compression refrigeration system using R-22 as refrigerant, condenser outlet…

Q: A cascade refrigeration system serves a 75 ton evaporator at 119.4 KPa. The system uses direct…

Q: oper vapor compression refrigeration cycle. The evaporator and condenser pressures are 200 kPa and…

Q: A two-stage cascade refrigeration system uses ammonia as refrigerant. The mass flow rate in the…

A: Given data as per question mass flow rate in the high-pressure loop = 0.10 kg/s The condenser…

Q: (a) In a refrigerating plant using R12 the vapour leaves the evaporator dry saturated at 1.826 bar…

A: Note: As per policy, we can solve the first three subparts. Please resubmit the remaining parts.…

Q: Draw the schematic and p-h diagram for the problem below: A two-stage cascade refrigeration system…

A: According to the information we have a two-stage cascade refrigeration system that uses ammonia as…

Q: During a fall season a heat pump is operating on a heating mode to maintain a large convention hall…

A: A pump is a mechanical device that transmits energy from a low temperature reservoir to a high…

Q: 13. A food storage locker requires a refrigeration system of 2500 kJ/min capacity at an evaporator…

A: Refrigeration is a device used to produce cooling by dissipating heat in the form of fluid or…

Q: standard ammonia vapour compression cycle developing 20 tons of refrigeration operates with a…

A: GivenTc=32°CPc=12.382barTe=-14°CPe=2.4637bar

Q: a standard vapor compression refrigeration system uses ammonia as refrigerant the amount of the…

Q: Waters enters the condenser at 20°C and leaves at 35°C. what is the log mean temperature difference…

A: GivenTC1=20oCTC2=35oCTh1=Th2=45oC

Q: 8 Calculate the COP value for the vapor compression refrigeration cycle where Th=10C and Tc=-20C.

Q: A deaerator heater supplies 150 L/min of deaerated feedwater into a booster pump at 115°C pumping…

A: Given data: Pg=100 kPaT=115°ChLs=0.6 mhi=1 mHR=5.8 m Need to determine the minimum height of water…

Q: A refrigerant 22 , four-cylinder, 85 mm x 70 mm compressor operating at 28 rev/sec, condensing temp…

A: Given: To find: a) volumetric efficiency b) compression efficiency

Q: Q6/ A single compressor system using 134a has a three evaporators of 5, 15 and 20 tons capacities.…

A: Consider the diagram shown below for the refrigeration cycle,

Q: Q1/ Refrigeration unit using R-134a as shown in figure below contains two compressors and two…

A: In this question, there is a mention of combined refrigeration cycle. This has to be solved using…

Q: Space storage food requires system cooling capacity 15 ton refrigeration operates in the the…

Q: A refrigeration system using refrigerant 12 is to have a refrigerating capacity of 80 kW. The cycle…

A: To determine the volume flow rate

Q: I have answer of the question but i have not understand the process of the solution.Would please…

A: Understand that the from the P-H curve that the process 1 to 2 is compression of the refrigerant,…

Q: Steam at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative…

A: Given that, Entering temperature of steam, T=550 °C,Entering presure of steam, P=10 MPa,Condenser…

Q: Problem 6 The The refrigeration system using R-22 as refrigerant consists of 3 evaporators of…

A: INTRODUCTION: Refrigeration is the technique of maintaining a low temperature in comparison to the…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

Question

Specify The C.O.P. of the cycle refrigeration vapor compression a simple R-717. Temperature evaporation is -20 °C and the temperature of the condenser is 30 °C (C.O.P is found using enthalpy)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A typical temperature relationship between a high-efficiency condenser and the ambient temperature is A. 10F. B. 20F. C. 30F. D. 40F.
Four methods for controlling head pressure in an air-cooled condenser are ______, ______, _______, and
What can the service technician do to keep the refrigeration system operating at peak efficiency?
The subcooling temperature in a condenser can be measured by taking the difference between the A. suction pressure converted to temperature and the boiling refrigerant. B. boiling temperature and the condensing temperature. C. condensing temperature and the leaving-refrigerant temperature. D). condensing temperature and the entering-refrigerant temperature.
The condensing pressure is 260 psig and the condenser outlet temperature is 108F for R-22. By how many degrees is the liquid subcooled in the condenser? A. 12F B. 42F C. 7F D. 14F
The typical difference in temperature between the cooling tower water supplied to the condenser and the out-door wet-bulb temperature is _____F.
How is condenser high efficiency obtained?
An R-404A system is operating with a -50F evaporator and the condenser is operating at 115F. What is the compression ratio of this system? A. 16.9 to 1 B. 17.8 to 1 C. 19.1 to 1 D. 21.33 to 1
Cold storage uses R134a, the evaporator temperature is -7C and the condenser temperature is 32C. The cooling load is 5.3103 kJ/min. The cycle is ideal. Determine: 1. Mass flowrate of the refrigerant. 2. Coefficient of Performance (COP). - If the water condenser is used that enter at 24C and exit at 30C. determine the water flowrate.
A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa evaporator, condenser while 1240 is at kPa. R-717 is saturated, calculate the theoretical power required If the refrigerant is to operate the compressor. Compressor Power% 3D
Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation temperature is -10° C and the condenser temperature is 40 ° C. COP =
Find C.O.P from the simple vapor refrigeration cycle R-717. evaporation temperature is -5 ° C and condenser temperature is 40 ° C. COP =