SP(S) Derive the transfer function of the feedback closed- loop Control System from the block diafrum shown in the figure Determine the Kc values that ensure stable operator of the Control System. 10-50-10 кно- 0.5 u S+3 S+10 usti -Z 1-5 #t ся

Q: 666 BOILING AND CONDENSATION 10-19 Water is boiled at atmospheric pressure by a horizon- tal…

A: Given, Diameter of Platinum plated rod = 10 mm Surface temperature of rod = 110°C

Q: Problem 3 A heat engines operates between a lake's surface water at a temperature of 300 K and water…

A: Given, The surface temperature, T1 = 300 K The temperature of the water, T2 = 285 K The power…

Q: 4. A solution is 2.00 mM analyte compound X and 3.50 mM internal standard compound S. Analysis of…

A: given = The concentration of Analyte (compound A) = 2 mM  The concentration of the internal standard…

Q: (1) Identify each of the following half-reactions as either an oxidation half-reaction or a…

A: 1) if an element gain electron, then it undergoes reduction and if its losses electrons it undergoes…

Q: Develop fuel ratic with: b) 50% e

A:

Q: In 1.5 liter of water at 25°C we try to dissolve the below compounds. How much will not dissolve…

A: (a) Write the reaction as follows: CaSO4 + H2O → CaSO4aq The solubility of CaSO4 is 260 mg/100 mL…

Q: From a source at 325k and yields a work out put of 72kj , rejecting 100 kilo Joules of heat to a…

A: Heat absorbed(Q₁) =260kJ at 325K Work output(W)= 72kJ Heat rejected to the reservoir(Q₂) = 100+ 88…

Q: Q/ carbon dioxide (CO2) is compressed in a piston cylinder assembly of PI 0.7 bar. T1 = 280 K to P2…

A: Given data: Initial pressure, P1 = 0.7 bar Initial temperature = 280 K Final pressure, P2 = 11 bar…

Q: A midsize steam-methane reforming plant is consuming methane at a rate of 125,000 mol/h and…

A:

Q: A standard 0.4-in. flange-tap orifice is installed in a straight horizontal length of standard 2-in.…

A: Given that- Diameter of pipe, D1 =2.067 inch= 0.0525 m Diameter of orific, D2=0.4 inch= 0.01016 m…

Q: Systems involving chemical reactions may be analyzed using: O a. O b. O C. O d. Extent of reaction…

A: The correct option is to be chosen.

Q: In a plug flow reactor, a gaseous feed of pure A (2 mol/L, 100 mol/min) decomposes to give a variety…

A: Write the reaction as follows: A→2.5 products   The concentration of pure A, CA0 = 2 mol/L The molar…

Q: Butane (C4H10)(C4H10) and dry air are fed to a combustion reactor at a steady rate of 45.9 mol/s45.9…

A: Given that, The molar flow rate of butane in the feed stream nC4H10,F = 45.9 mols The molar flow…

Q: One of the methods to increase oil recovery from reservoir is injection of Carbone Dioxide. Explain…

A: Oil recovery techniques fall into three categories: 1) Primary oil recovery: It is employed during…

Q: Question 7. For the Haber process described by the following reaction N2(g) + + 3 H₂(g) 3 2 NH3(g)…

A: The temperature at which the reaction becomes spontaneous is to be calculated.

Q: 220 CO2 + H₂, lied to control the CO mole fraction in _d P = 1 atm, compute the mole fraction 0500

A:

Q: Ethyl alcohol(C2​H5​OH)is burned with 70 percent excess air. The air is at 30∘C and70%relative…

A: Given that- Ethyl alcohol is burnt. Excess air= 70% Air temperature, T=300C Relative humidity,…

Q: 1. A solution of Histidine with a concentration C = 60.5 mg/L has an absorbance of 0.794 when the…

A: Write the Beers law as follows: A = εbC    ......1   Given, The absorbance, A = 0.794 The cell…

Q: Consider a following reactive system. Calculate the ratio of N₂ to C₂H4 in the feed? 350 mol C₂H.…

A: Given that2C2H4  →C4H8350 mol is given in the reactor

Q: In a solid-liquid extraction process operated according to the principle of continuous counter…

A: A mixture of solids, hexane and oil is to be extracted with the help of pure hexane in a…

Q: Estimate the diffusivity of acetic acid diffusing through air at 298 K at 2 atm using the Fuller-…

A:

Q: Calculate the heat required (in kJ,

A:

Q: One thousand liters of a 95 wt% glycerol-5% water solution is to be diluted to 60% glycerol by…

A: Given data: Volume of 95 % glycerol solution = 1000 L Internal diameter of pipe = 5 cm Time taken to…

Q: Can you explain if the answer to part b physically reasonable?

A: Given time of evaporation of the droplet(t0) is t0=CA(L)R22cDABln11-xAR Where CA(L) is molar density…

Q: Q4) Estimate the fugacity of isobutylene as a gas: (a) At 280°C and 20 bar (by using 2nd virial…

A: Given data: T = 280 0C OR 553 K P = 20 bar

Q: valve is 400◦C. The unthrottled

A:

Q: 27: A furnace installed at a cost of Rs. 24 Lakh is expected to serve its useful life of 5 years.…

A:

Q: Couldn't you use these equations

A: The molar flux of a species (A diffusing through non-diffusing B) is calculated using the following…

Q: E. coli is grown in a chemostat with a working volume of 1.0 litre. A medium containing 4 g litre¹…

A: Given data: Volume of chemostat = 1 L Initial concentration of substrate = 4 g/L Final concentration…

Q: : A continues fractionation column, operation at atmospheric pressure, is to be designed to separate…

A: Given details: In fractionation column , separation of CS2 and CCl4 is being carried out.the desired…

Q: FIGU P10-20 10-21 Water is boiled at sea level in a coffeemaker equipped with a 30-cm-long,…

A: Volume of water = 1 L Density of water is 1 kg/L Mass of water initially present when boiling starts…

Q: Gaseous butane (CH₂(CH₂), CH₂) will react with gaseous oxygen (O₂) to produce gaseous carbon dioxide…

A:

Q: 1. A cylindrical tank (see right figure) is sitting on a platform that in turn rests on absolutely…

A:

Q: Professor Modyn's steady state flow reactor is now fed acetylene (C2H2)(C2H2) at 2.000 mol/s.2.000…

A: Given that, The molar flow rate of acetylene in the feed stream nC2H2,F =  2 mols %excess dry air =…

Q: Enlist different production processes for the product Vinyl Acetate, and select the suitable…

A:

Q: Aqueous sulfuric acid (H₂SO₂) will react with solid sodium hydroxide (NaOH) to produce aqueous…

A: Given that, Reaction: H2SO4 + 2NaOH → Na2SO4 + 2H2O The mass of sulfuric acid mH2SO4 = 7.8 g The…

Q: 3. Double pipe heat exchanger: A double pipe heat exchanger is used to cool an oil stream from a…

A:

Q: A liquid containing 70 mol % benzene (A), 30 mol % toluene (B) is flash-vaporized at 1 std atm…

A: A mixture of benzene and toluene is flash vaporized at given T and P.

Q: Can you show this problem again but write out the steps and instead use 0.3m,0.3mm, 21C to 128C

A: Initial length = 0.3 m Change in length after heating = 0.3 mm Initial temperature = 21 0C Final…

Q: A tubular reactor for the isomerization of n-butane to isobutane is to be installed in a dedicated…

A:

Q: Two pound of an ideal gas undergoes an isentropic process from 65.3 psig and a volume of 0.8 ft³ to…

A: Given details: the process is isentropic . Mass of the gas,m=2 lb initial pressure,P1=65.3 psig…

Q: Combustion basics UNIVERSITY OF LEEDS Calculate the AFR for the combustion of methane with…

A: Write the reaction as follows: CH4+2O2+3.76N2 → CO2+2H2O+7.52N2   1 mole of CH4 reacts with 2 moles…

Q: Question 7. For the Haber process described by the following reaction N2(g) + 3 H2(g) 2 NH3(g) The…

A: For the Haber's Process,              N2(g) +3H2(g)→2NH3(g) we need to determine ∆S0 for the…

Q: The rate of the following reaction has been found to be first-order with respect to hydroxyl ions…

A:

Q: One way in which the useful metal copper is produced is by dissolving the mineral azurite, which…

A: Given reaction for production of metal copper is- Fe(s)+ CuSO4(aq)→Cu(s)+ FeSO4(aq)   Volume of…

Q: 3. Why are two different differential pressure gauges used to measure the pressure drop of the…

A: 3) Differential pressure gauges are widely used and have vast applications, particularly in the…

Q: A 2.200-g of quinone, C6H4O2, is burned in a bomb calorimeter whose total heat capacity is 7.854…

A: Given that m =2.2 g C=7.854 KJCT1  =23.44 CT2  =30.57 C

Q: A sealed container holds 0.025 moles of nitrogen (N₂) gas, at a pressure at 1.5 atmospheres and…

A: Given that- Moles of N2 gas=0.025 moles Pressure, P= 1.5 atm Temperature, T= 290 K Atomic mass of…

Q: 2. A culture is initially run in batch mode until the substrate is almost consumed. At this point…

A:

Q: 2. The liquid-level process shown in below Fig. is operating at steady state when the following…

A: