Sre 3. ( A Soil Specimen has the following characteristics: % passing No.4 sieve = 85 % passing No.200 sieve = 11 D60 = 2 mm D30 = 0.35 mm D₁0 = 70 μm L.L = 36% P.L = 31% Dε =2 μm 1. Classify the specimen according to the Unified Soil Classification System (USCS). Assign the group name and the group symbol. 2. Determine the soil activity. 3. Determine the soil Liquidity index and consistency index if we = 26%.

Sre 3. ( A Soil Specimen has the following characteristics: % passing No.4 sieve = 85 % passing No.200 sieve = 11 D60 = 2 mm D30 = 0.35 mm D₁0 = 70 μm L.L = 36% P.L = 31% Dε =2 μm 1. Classify the specimen according to the Unified Soil Classification System (USCS). Assign the group name and the group symbol. 2. Determine the soil activity. 3. Determine the soil Liquidity index and consistency index if we = 26%.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter4: Plasticity And Structure Of Soil

Section: Chapter Questions

Problem 4.6P: Refer to the soil in Problem 4.5. Using the Casagrande plasticity chart, graphically estimate the...

See similar textbooks

Similar questions

Refer to the soil in Problem 4.5. Using the Casagrande plasticity chart, graphically estimate the shrinkage limit of the soil as shown in Figure 4.22. 4.5 The following data were obtained by conducting liquid limit and plastic limit tests on a soil collected from the site. Liquid limit tests: Plastic limit test: PL = 19.3% a. Draw the flow curve and determine the liquid limit. b. Using the Casagrande plasticity chart (Figure 4.21), determine the soil type.
The following data were obtained by conducting liquid limit and plastic limit tests on a soil collected from the site. Liquid limit tests: Plastic limit test: PL = 19.3% a. Draw the flow curve and determine the liquid limit. b. Using the Casagrande plasticity chart (Figure 4.21), determine the soil type.
The total volume of a soil specimen is 80,000 mm^3 and has a mass of 152 g. the dry mass of the specimen is 122g, and the density of the soil is 2.65 Mg/m^3. Compute the following index properties: (a) e; (b) n; (c) S; (d) ρt; and (e) ρd. Include phase diagrams.
A soil specimen has a total volume of 70 cm3 and a total mass of 135.5g. After complete drying in an oven, the specimen has a mass of 122.0g. The Gs is 2.60. Determine the void ratio. Report your answer to three significant figures, and draw the full phase diagram.
Q 05: (CLO 3) For a given soil, the following are given in Table: Specific Gravity Gs, bulk unit weight γ), and moisture content (w). Use data from the table according to your registration number. (You can solve answer on paper and paste neat clear image in the answer). Student Registration Number Gs γ (kN/m3) moisture content (w) % 102 2.72 17.2 20 Determine: Dry unit weight Void ratio Porosity Degree of saturation
In a soil specimen, 70% of particles are passing through 4.75 mm sieve and 40% of particles are passing 0.075 mm sieve. Its uniformity coefficient is 8 and coefficient of curvature is 2. As per USCS, this soil is classified as: a.SP b.GP c.GW d.SW
A soil sample has a unit weight of 1.9 g/cc and w=12%. If Gs of solids is 2.65, determine the void ratio in percent. CHOICES: a.56.8 b.1.7 c.36 d.56
A soil sample has a unit weight of 1.9 g/cc and w=12%. If Gs of solids is 2.65, determine the porosity in percent.
A dry sand is placed in a container having a volume of 0.30cu.ft. The dry weight of sample is 31lb. Water is carefully added to the container so as not to disturb the condition of the sand. When the container is filled, the combined weight of soil llus water is 38.2 lb. a. Compute the void ratio in the container. b. Compute the specific gravity of the soil particle. c. Determine the dry unit weight.
10. The results of a Standard Proctoretest is tabulated as follows: (SEE PICTURE) Determine the maximum dry unit weight of compaction Determine the optimum moisture content Determine the void ratio at the optimum moisture content Gs = 2.70 Determine the degree of saturation at the optimum moisture content A field unit determination test for the soil, yielded the following data. Moisture content = 12% and moist unit weight = 106 pcf. Determine the relative compaction.
1. A sample of saturated clay was placed in a container and weighed. The weight was 6 N. The clay withcontainer was oven dried for 24 hours at 105C and weighed again as 5N. if the weight of the containeris 1 N, and specific gravity of soil solids is 2.70, determine the a) water content b) void ratio c) bulk unitweight d) dry unit weight, e) saturated unit weight f) submerged unit weight. This is the question of Soil Mechanics.
Coefficient Permeability of Soil A falling head permeability test is conducted on silty soil. The sample diameter is 10.0 cmand its length or thickness is 7.8 cm. The diameter of the standpipe is 6.0 mm. The head at thestart of the test is 47.8 cm. The test lasts 8.5 min and the head falls to 22.6 cm. Find thecoefficient of permeability of this soil in cm/s? Provide step by step solution.