STP and Etherchannel Consider the below topology, noting that all the switches have the same priority 32768: Bridge Name MAC Address SWA SWA 000c.8589.1694 G0/2 FO/1 SWB 000c.CFBB.6451 sWA SwC 0001.C7C7.BEDC GO/1 GO/2 SWD 0005.5E00.C94C FO/23 FO/1 GO/1 FO/3 SWD FO/1, FO/24 - FO/3 SWB GO/2 FO/2 FO/1, GO/2 FO/23 FO/2 FO/24 SwC Q1-a- STP is enabled on the switches. Which of the above switches will be considered as the primary and secondary root bridges for VLAN 1? Verify your answer.

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: Explanation: 1. ARP is used by network computers to determine the MAC address of the IP address…

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: NOTE: - Since it is a multi-part question, so as per the guidelines only first three parts are…

Q: In a Wireshark capture of the Ethernet II header contents of an ARP request, the destination address…

A: In a Wire-shark capture of the Ethernet II header contents of an ARP request, the destination…

Q: A 10-Mb/s Classic Ethernet transmits data packets obtained from the Network Layer. Assume for…

A: please check the step 2 for solution

Q: Use given Figure 1 to configure two-router network. All router a configurations must be assumed and…

A: Actually, IP stands for Internet Protocol.

Q: Nodes A and B are on the same 10 Mbps Ethernet segment, and the propagation delay between two nodes…

A: The Answer is in Below Steps

Q: B) You are given the topology in figure Q4 with the default network address (10.0.0.0/8). Use the…

A: Default network address: 10.0.0.0/8 The largest segment requires 4000 host addresses. So a mask of…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: Answer:- Given that: The distance between the nodes = 5 meters Transmission rate = 1Mbps = 106bps…

Q: Design a topology for Bonsai Ltd in Packet Tracer, given the following scenario: Four branches…

A: Explain the functions of PCs,Servers,Switches and Routers.

Q: Design a MAC protocol for an access network where N nodes generate data continuously at a constant…

A: 1st is thar each node transmit at constant rate x bit/sec

Q: 2) Logical Addressing: - Incorporate the following IPV4 private addressing scheme on the LANS - LAN…

A: ANSWER:-

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: answer :  According to above scenario, the point must be noted as, 1. each node transmit at constant…

Q: in a virtual network, there are three switches k1, k2 and k3. Source P need to communicate with…

A: Bundle Switching and Delays in Computer Network

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: the answer is

Q: Two PC’s are connected to a switch. The IP addresses of the PC’s are as displayed in the diagram. PC…

A: Actually, IP stands for Internet Protocol.

Q: Qno 9: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps.…

A: Given:- Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps.…

Q: Consider the Ethernet networks shown in the below exhibit to answer the following questions. Fao PCO…

A: Actually, network is a device which communicate with each other.

Q: to configure a two-router network. All router Use given Figure 1 configurations must be assumed and…

A: EXPLANATION Below is the program for the given question. Hope you understand it well. If you have…

Q: If there is a computer with the address 4A: 30: 10: 21: 10: 1A Sending a data frame to your…

A: Ethernet,The source address is 6bytes and destination address is also 6 bytes.The source address is…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: We noticed there are two forms of network connections: point-to-point connections, and connections…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: Solution : Based on the situation 1. each node transmit at constant rate x bit/sec 2. traffic is…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: MAC protocol : MAC protocol is the first protocol layer above the Physical Layer in ad hoc.…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A:

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: Explanation: As per the above scenario, the following points are to be noted as:- Each node…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: For the given access network, the following points are important: Each node transmits at a constant…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: Given: N nodes generate data continuously at a constant rate at x bits/sec during each node…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: The argument must be noted as, according to the above scenario,   At a constant rate of x bit/sec…

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: MAC protocol:- The sublayer of the MAC is the hardware that governs the connection of the hardware…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: AS PER OUR POLICY “Since you have posted a question with multiple sub-parts, we will solve the first…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: Distance: The distance (Distance) between 2 hosts A and B = twenty,000 km a) The distance…

Q: Consider a typical (dumb layer 2) switch. It receives a packet on one of its ports. How does it know…

A: Dear Student, In the beginning it will send the message to all the devices connected, then based the…

Q: VLSM Problem 1. Based on the number of hosts in the topology, you need to calculate the NIDS and…

A: 210.15.10.0 is a class C IP address where number of network bits is 24. So number of host bits is 8…

Q: .Observe the network diagram and fill in the data for Switch-1 MAC table LAYER 3: 192.168.10.1 LAYER…

A: A way to map each port to the mac address is called the mac address table.   An IP address is a…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: The distance (Distance between two host A and B=20,000km (a) distance(Distance) between two hosts A…

Q: Task 1. Create VLAN’s, enable switchport mode, and assigning VLAN’s interfaces on each switch.…

A: You can logically partition a Local Area Network (LAN) into distinct broadcast domains using a…

Q: Based on the following topology, Frame Relay Design with Sub-interfaces, write configuration scripts…

A:

Q: In an OSPF router how would you allot a Gigabit Ethernet interface a lower cost than a Fast Ethernet…

A: According to our company policy we can answer only one question if multiple questions are posted.…

Q: 2. Write the necessary commands to configure Inter VLAN communication (Router on a Stick) for the…

A: Below i have given steps;

Q: chooses K = 4? The result K = 4 corresponds to a delay of how many seconds on a 10 Mbps Ethernet?

A: The required answer is as follows

Q: Consider the network below and answer the following questions. switchA switchB server4 192.168.1.7…

A: Switch A: Ethernet Address Port 44:44:44:44:44:44 1 33:33:33:33:33:33 3

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: Given: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps.…

Q: Configure the following VLans having two switches: Switch 1: 1. VLan 40, Dept. HR 2. VLan 50, Dept.…

A: V LAN is a virtual LAN in this physically system can be placed anywhere but they are logically…

Q: A 100M-bit Ethernet has the following topology Hub The maximum length of each cable is 100m. The…

A: 64 bytes least bundle length is certainly not a self-assertive number. In a 10Base5 actual layer…

Q: O Analyze the table shown below find the subnet Mask and identify the type of address (network,…

A: Following to the answering guidelines, solving the first question completely.  A)  Here in the first…

Q: In this Question, you have been given the network address 13.0.0.0/8 to subnet and provid the IP…

A: Network Address Block Subnet Mask 255.0.0.0/8 255.128.0.0/9 255.192.0.0/10 255.224.0.0/11…

Q: Under the classful IP addressing system, how many class C address blocks are available? How many…

A: Given:

Q: Assume that there are only two stations, A and B, in a bus CSMA/CD network. The distance between the…

A: The solution to the both above mentioned question is given below as :---

Q: Answer the following questions with respect to "Link state Routing Protocol". 192.168.10.1…

A: Various paths available with cost:- A->C->F: cost=10 A->D->E->F: cost=4…