Consider the Ethernet networks shown in the below exhibit to answer the following questions. Fao PCO Fa/1 Fa0/0 Fao Etho Do Fa s1 Fa0/1 RI Fa0 Fa0/0 Fa/1 R2 PC1 Fa0/1 Fa0/ S2 PC2 The network interface settings of POs are: Logical Address Physical Address PCO 192.168.2.2 0060.5032.9A15 PC1 192.168.2.3 0001.6363.6BAA pc2 192.168.3.2 DOEO.F9A1.0864 PC3 192.168.0.2 0001.0935.08C3 The network interface settings of routers are Logical Address Physical Address R1-Fa0/0 192.168.0.1 0004.9A31.0501 R1-Fa0/1 192.168.1.1 p004.9A31.0502 R1-Eth0/0/0 192.168.2.1 0060.2F70.0D9B R2-Fa0/0 192.168.1.2 0002.1641.6301 R2-Fa0/1 192.168.3.1 po02.1641.6302 Suppose that the switching table in the S1 contains the following contents Fa0/1 Fa0/2 Fa0/3 Fa0/4 Open Fa0/5 Fa0/6 Fa0/7 Fa0/8 Open Open Open Open

Consider the Ethernet networks shown in the below exhibit to answer the following questions. Fao PCO Fa/1 Fa0/0 Fao Etho Do Fa s1 Fa0/1 RI Fa0 Fa0/0 Fa/1 R2 PC1 Fa0/1 Fa0/ S2 PC2 The network interface settings of POs are: Logical Address Physical Address PCO 192.168.2.2 0060.5032.9A15 PC1 192.168.2.3 0001.6363.6BAA pc2 192.168.3.2 DOEO.F9A1.0864 PC3 192.168.0.2 0001.0935.08C3 The network interface settings of routers are Logical Address Physical Address R1-Fa0/0 192.168.0.1 0004.9A31.0501 R1-Fa0/1 192.168.1.1 p004.9A31.0502 R1-Eth0/0/0 192.168.2.1 0060.2F70.0D9B R2-Fa0/0 192.168.1.2 0002.1641.6301 R2-Fa0/1 192.168.3.1 po02.1641.6302 Suppose that the switching table in the S1 contains the following contents Fa0/1 Fa0/2 Fa0/3 Fa0/4 Open Fa0/5 Fa0/6 Fa0/7 Fa0/8 Open Open Open Open

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 5VE

See similar textbooks

Similar questions

Assume a shared connection of 1 Mbps (for example, an Ethernet bus). How long does it take (in microseconds) to transmit a 1000-bit frame over this connection?
Assume there is a 1 Mbps shared connection (e.g. Ethernet bus). How long (in microseconds) does it take to send a 1000-bit frame over this link?
As another example, consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation
Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node D to node A. Give the source and destination Ethernet addresses, as well as the source and destination addresses of the IP datagram encapsulated within the Ethernet frame at points (5), (4), (2), and (1) in the figure above.
A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below: Suppose switch table is empty and switch receives a frame with source MAC address of H1 (MAC-H1) and destination MAC address of H2 (MAC-H2). What actions will be performed by the switch in this case?
Consider an ethernet with length of the cable is 1800 meter and speed of the signal cable is 3 x 10^8 m/s, transmission time is 45 microsec, the (%) of time channel remains idle. (Upto 2 decimal place) Correct answer get upvote. Incorrect get downvote
29. Match the following : List - I List - IIa. Call control protocol i. Interface between Base Transceiver Station (BTS) and Base Station Controller (BSC)b. A-bis ii. Spread spectrumc. BSMAP iii. Connection managementd. CDMA iv. Works between Mobile Switching Centre (MSC) and Base Station Subsystem (BSS)Code:a b c d a. iii iv i ii b. iii i iv ii c. i ii iii iv d. iv iii ii i
If there is a computer with the address 4A: 30: 10: 21: 10: 1A Sending a data frame to your Computer, specify the Destination Address and Source Address on the Ethernet frame, if the communication is done as i. Unicast. ii. Multicast. iii. Broadcast Table Fill in the following. Type of Communication Destination Address Source Address Unicast Multicast Broadcast
1. Mention the protocols over which the protocol is encapsulated, to which layer ARP belongs. 2. What is the Target's Hardware Address = a8:9f:ec:bb:78:f0 in the frame and what is the Destination Address = a8:9f:ec:bb:78:f0 in the ARP request packet? Why? 3. Mention the protocol over which the ICMP protocol is encapsulated. - Explain a little in the answers
Computer Science A 10-Mb/s Classic Ethernet transmits data packets obtained from the Network Layer. Assume for simplicity that the obtained data packets are directly placed into the MAC Ethernet frame, i.e. that no extra bytes are added in the LLC sub-layer.
Given a Class C subnet Mask 255.255.255.192. what will be the subnet address and host number for a machine with IP address 197.1.2.67. Select one: a. second subnet and host 2 b. Third subnet and host number 3 c. second subnet and host 4 d. First subnet and host number 3 e. None f. Second subnet and host number 3
Consider a computer “A” which is connected in a LAN transmission technology. Computer “A” transfers data from one computer to another computer using the address “3C:D9:2B:CB:AA:FC”. Identify which part of this address is specific to the Network Interface Card? Choose an answer A 2B:CB:AA B CB:AA:FC C 3C:D9:2B D D9:2B:CB