Answered: Subject: Electrical & Electronics…

Subject: Electrical & Electronics Engineering Course: Power Systems Question: In case of modeling a Long Transmission Line, what are the available procedures? Which one is the best and why? Explain.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Related questions

Q: What is the difference between balanced and unbalanced line transmission lines, show the difference…

Q: What is The effect of increasing VS in power transmission line performance study?

A: Let a power transmission system, where Vs is sending end voltage Vr is receiving end voltage I is…

Q: 1. What are the factors which governs the performance of transmission line? 2. How do you classify…

A: 1..>> The performance of the transmission line depends on parameters like :- Resistance of…

Q: Give four challenges and suggest solutions for those challenges in wireline operations.

A: 1)Crowded place:- In crowded place it is very difficult to do wiring as very small space is…

Q: What is the percentage voltage regulation of short transmission line if its sending end and reciving…

Q: The impedance seen from the relay side in a distance relay is 10 ohms. Given that the CT ratio is…

A: Given: CT ratio is 1000 : 1 PT ratio is 100,000 : 110 Line has a resistance of 1 milliohm per km and…

Q: Discuss factors that affect selection of the support systems for the transmission lines. What are…

A: To support conductors of transmission lines, various type of supporting structures are available…

Q: What are the causes of voltage drop and line losses in a transmission line?

A: Line voltage drop occurs due to two main reason given as: (1) voltage drop in line resistance (2)…

Q: . Why in medium and long transmission lines, regulation is greater than voltage drop?

A: There are three types of transmission lines on basis of the distance of transmission: Short…

Q: What is Financial Transmission right and how they are used

A: Finаnсiаl Trаnsmissiоn Right (FTR)- А Finаnсiаl Trаnsmissiоn Right (FTR) is а finаnсiаl…

Q: Q2: Consider a lumped - element circuit model for a transmission line to derive Transmission Line…

A: Derivation of the time domain Telegrapher's equation for equivalent circuit model of Transmission…

Q: A)Ibc =? find the load current=?…

A: A)Ibc =? find the load current=? B)Vca calculate the line voltage =? C)Calculate the total complex…

Q: If a transmission line has to be designed with an ultimate strength 6000 kg and a safety factor of…

Q: What is the necessary condition for matching transmission lines? In addition, what is a micro strip…

A: necessary condition for matching transmission line micro strip line

Q: a. There are three different transmission line models available, i.e. L-type, T-type and n- type…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: State the factors affecting the sag in a transmission line? What is the chief argument that favours…

A: The vertical distance between the point where the line joins the tower and the lowest point on the…

Q: How can you ensure the safety of workers and communities close to transmission power lines?

A: An overhead power line is a structure that transmits electrical energy across long distances in…

Q: What is the difference between balanced and unbalanced line transmission lines, show the difference…

Q: The transmission power is 30DBM.it looses 2DB per km. The noise level increase 1 DB per km .…

A: Given the Transmission power = 30 DBM It looses 2 DB per km and noise increases 1 DB per km SNR=…

Q: QUESTION: Explain or describe or define in your own words and your own understanding, without…

A: Bundled Conductors for transmission lines: Sometimes, for certain advantages, the transmission lines…

Q: Draw the equivalent circuit of long transmission line and derive the equations of sending end…

A: Types of Transmission line Long Transmission line Medium Transmission line Short Transmission…

Q: Give the reason of acharging current is exiting in a line even when line is open circuited at the…

A: In a transmission line, air acts as a dielectric medium between the conductors. When the voltage is…

Q: a)find IBC load current? b)VAB give line voltage? C)Calculate the total complex power on the…

A: find IBC load current? b)VAB give line voltage? C)Calculate the total complex power on the…

Q: Based on simple schematic diagram, briefly describes the criteria and characteristic of short and…

Q: What are the considerations in choosing the appropriate transmission line?

A: While choosing the transmission line 1) it should have less voltage drops. 2) it should be suitable…

Q: Explain Basic Trip Circuit in Transmission line? Also, Discuss the Fundamental Requirements of…

A: Protection refers necessary isolationof healthy system from faultysystem, so that fault can not…

Q: If a transmission line has to be designed with an ultimate strength 6000 kg and a safety factor of…

A: An important characteristics to be inspected while constructing an overhead transmission line is the…

Q: a List the factors affecting the sag of a transmission line. (write any three factors)

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: How does rise in voltage at the receiving end of an open circuited line depend upon the length of…

A: Given:-

Q: difference between short and long transmission line

Q: Overhead Transmission Lines are preferred for Transmission of Power for Long Distances, why? Note…

A: The explanation is as follows.

Q: 3. What are the causes of voltage drop and line losses in a transmission line?

A: Line voltage drop occurs due to Voltage drop in line resistance Voltage drop in line inductive…

Q: Transmission lines can be categorized on the basis of their length. Explain short transmission line…

A: Trans mission lines can be cateogerized into 3 types on the basis of their lengths 1. Short lines…

Q: What parameters determine the characteristic impedance of Lossless transmission

A: In this question we will write parameters which determine the characteristic impedance of Lossless…

Q: 2) Write down the specification and types of insulators used in transmission line

A: The electrical insulator is a device that provides the required insulation between the line…

Q: If a transmission line has to be designed with an ultimate strength 7000 kg and a safety factor of…

A: Given Length of span (l) =300 m T= tension in the conductor Wt. of conductor per meter (W) =2 kg…

Q: xplain or describe or define in your own words and your own understanding, without copying from the…

A: There are two configurations of the transmission line is available. single circuit configuration in…

Q: 916: The sending end and receiving end voltages of overhead line at 120 MWw load are equal at 110…

Q: of a bus bu

A: Given: The answer is shown as:

Q: Compare Equivalent- π and Nominal-π in transmission lines. What are their diffirences? When we use…

A: Aim- to compare equivalent π and nominal π

Q: Calculate the Reactance of the Line, Current flowing through the transmission line, Sending end…

Q: Write ‘T’ for True and ‘F’ for False: Constant A, B, C, D represents the voltage of a transmission

A: The explanation is as follows.

Q: Give an Introduction about the performance of different types of transmission lines used to transfer…

A: Transmission unit is the back bone in the field of electrical engineering(POWER SYSTEM). With the…

Q: Prove that the conductor cost for transmission line is inversely proportional to the square of the…

A: Power suppied by source is cosntant VIcosϕ = constsant I∝1vlosses are also constant (I2R = constant…

Q: What are the benefits of controlling of power flows on individual lines? What are the risks

A: In power system operation and planning, the term power flow, also known as load flow, is commonly…

Q: Ghana Grid Company (GRIDCo) designed a short transmission line using the A, B, C, D line constant of…

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

Subject: Electrical & Electronics Engineering

Course: Power Systems

Question: In case of modeling a Long Transmission Line, what are the available procedures? Which one is the best and why? Explain.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A small manufacturing plant is located 2 km down a transmission line, which has a series reactance of 0.5/km. The line resistance is negligible. The line voltage at the plant is 4800V(rms). and the plant consumes 120kW at 0.85 power factor lagging. Determine the voltage and power factor at the sending end of the transmission line by using (a) a complex power approach and (b) a circuit analysis approach.
Calculate the capacitance-to-neutral in F/m and the admittance-to-neutral in S/km for the three-phase line in Problem 4.18. Also calculate the line-charging current in kA/phase if the line is 110 km in length and is operated at 230 kV. Neglect the effect of the earth plane.
Approximately how many physical transmission interconnections are there between the United States and Canada? Across which states and provinces are the interconnections located?
Consider a long radial line terminated in its characteristic impedance Zc. Determine the following: (a) V1/I1, known as the driving point impedance. (b) | V2 |/V1|, known as the voltage gain, in terms of al. (c) | I2 |/| I1 |, known as the current gain, in terms of al. (d) The complex power gain, S21/S12, in terms of al. (e) The real power efficiency, (P21/P12)=, terms of al. Note: 1 refers to sending end and 2 refers to receiving end. (S21) is the complex power received at 2; S12 is sent from 1.
PowerWorid Simulator case Problem 3_60 duplicates Example 3.13 except that a resistance term of 0.06 per unit has been added to the transformer and 0.05 per unit to the transmission line. Since the system is no longer lossless, a field showing the real power losses has also been added to the oneline. With the LTC tap fixed at 1.05, plot the real power losses as the phase shift angle is varied from 10 to +10 degrees. What value of phase shift minimizes the system losses?
A 40-km, 220-kV, 60-Hz, three-phase overhead transmission line has a per-phase resistance of 0.15/km, a per-phase inductance of 1.3263 mH/km, and negligible shunt capacitance. Using the short line model, find the sending-end voltage, voltage regulation, sending-end power, and transmission line efficiency when the line is supplying a three-phase load of (a) 381 MVA at 0.8 power factor lagging and at 220 kV and (b) 381 MVA at 0.8 power factor leading and at 220 kV.
A three-phase power of 460 MW is transmitted to a substation located 500 km from the source of power. With VS=1. per unit, VR=0.9 per unit, =5000 km, Zc=500, and =36.87, determine a nominal voltage level for the lossless transmission line based on Eq. (5.4.29) of the text. Using this result, find the theoretical three-phase maximum power that can be transferred by the lossless transmission line.
What other challenges can be encountered in designing a transmission line? Enumerate at least 3 and how can these challenges be solved. What are the advantages of solar panels over transmission lines? Why can’t we still fully transition to solar panels?
What are the parameters need to consider for transmission line?Electircal parameters? Performance? Figure of merits?
1. What are the applications for stripline and microstrip transmission lines? 2. Give 2 examples of characteristic impedance application for each stripline and microstrip transmission lines.