Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we multiplex on a 8 Mbps link if we want to fulfill user requirements with probability at least 0.9 using packet switching

Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we multiplex on a 8 Mbps link if we want to fulfill user requirements with probability at least 0.9 using packet switching

Principles of Information Systems (MindTap Course List)

12th Edition

ISBN:9781285867168

Author:Ralph Stair, George Reynolds

Publisher:Ralph Stair, George Reynolds

Chapter6: Telecommunications And Networks

Section: Chapter Questions

Problem 4SAT

See similar textbooks

Related questions

Q: Assume each user needs 500 kbps and only uses 25% of the bandwidth. In order to meet customer…

A: Information from a number of channels may be merged for transmission over a single channel using…

Q: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

A: Here we have given the solution for the question asked. You can find the solution in step 2.

Q: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

A: Consider following data: Rate of broadcast channel= Propagations delay between two node's=bit time's…

Q: Between two hosts A and B that are connected by a link with the bandwidth 1 Mbps and with a one-way…

A: Your solution is given below. Given :- Bandwidth is 1 Mbps RTT = 2 ms Tp = 1 ms = 1 * 10-3…

Q: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

A: ANSWER:-

Q: In a hot spot WLAN in a local coffee shop, it is seen that on average, the AP receives 40 packets…

A: Answer is given below-

Q: 3. Suppose several network users share a 1 Mbps link. Also, suppose each user requires 250 kbps when…

A: Suppose several network users share a 1 Mbps link. Also, suppose each user requires 250 kbps when…

Q: what is the total latency for a frame of size 5 million bits that is being sent on a link with 10…

A: Link Length = 2000 Km = 2000 * 103 m Light speed inside the link = 2 * 108m/s Frame size is 5…

Q: Determine the efficiency of a token ring with a data rate of 250Mbps, a ring latency of 120 µsec and…

A: Introduction : We have to calculate efficiency of the token ring

Q: Let's say each user has a 500 kbps need and is online for just 25% of the time. With packet…

A: Answer:-

Q: smission? Give a numerical example assuming a specific capacity of the link and an initial value of…

A: TCP manages congestion, both for the connection’s own benefit (to improve its throughput) and for…

Q: If each packet is 50KB and the transmission rate between sender and receiver is 1Gbps with a…

A: Transmission time = 50KB/1Gbps = 50*1024*10-9 = 51.2 *10-6 sec Propagation time = 20ms = 20000 *10-6…

Q: Suppose that there are three inter-media nodes between Host 1 and Host 2, and the transmission rate…

A: Given that, Transmission rate or Band width= 4.096 Mbps End to end circuit establishment time= 0.5…

Q: A factor in the delay of a store-and-forward packet-switching system is how long it takes to store…

A: Answer

Q: by a single link of rate R= 56kbps and the propagation speed along the link is 2* 10^8. a) If one…

A: The answer is

Q: Consider a 10 km long broadcast LAN has 10^10 bps bandwidth and uses CSMA/CD. The signal travels…

A: Below is the answer with calculation and explanation:

Q: How long does it take a packet of length 1,000 bytes to propagate over a link of distance 2,500 km,…

A: Solution: (1) Given, =>Packet length(L) = 1000 bytes =>Propagation speed(s) = 2.5*10^8 m/s…

Q: Question 4: Consider the figure below, with three links, each with the specified transmission rate…

A: Formulas: Transmission delay= Length of packet in bits / Transmission rate Propagation delay =…

Q: Assume that each user demands 500 kilobits per second and is only active 25% of the time. How many…

A: Explanation: The first step is to learn about statistical multiplexing gain. Switching systems in…

Q: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0:…

A: AS per BNED rules we are allowed to answer 1 question at a time . Solution Division of Time Multiple…

Q: P1: Consider the slotted ALOHA protocol. Suppose that there are N devices that want to transmit.…

A: Here we write about slotted aloha and get the desired answer and find maximum throughput.…

Q: Assume that each user requires 500 kbps and is only active 25% of the time. How many users can we…

A: Statistical multiplexing gain: Switching systems in communication networks accomplish statistical…

Q: ssume that 2 packets arrive simultaneously to a switch at which one other packet is halfway done…

A: The value 0.027 seconds is correct but the method is unclear. The other comment provides the correct…

Q: Suppose users share a 2 Mbps (i.e., 2×106 bits per second) link. Also suppose each user transmits…

A: The answer is..

Q: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

A: Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between…

Q: The distance between two microwave towers, with the link capacity 100 Mbps, is 24 Km and the speed…

A: Introduction

Q: Question 1 ) Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at…

A: Time Division Multiple Access allows each node to have a fixed time slot for channel access. Per…

Q: Consider a CSMA/CD network that transmits data at a rate of 400 x 106 bits per second. The maximum…

A: Introduction : Given ,A CSMA/CD network data rate = 400 x 106 bits /second.Tp = 20 microsecondsWe…

Q: Consider the figure below, which draws the analogy between store-and-forward link transmission and…

A: 1) When a car enter service at the tollbooth, it takes 1 second service time. 2) It takes 10 second…

Q: Suppose, there are N = 4 nodes using the slotted ALOHA protocol. The nodes are contending for a 6…

A: Summary: -Hence, we have discussed all the point.

Q: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0:…

A: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0: Node…

Q: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0:…

A: Answer:- Time Division Multiple_ Access allow access to channel by giving a fix time slot to each…

Q: Question 4: Consider the figure below, with three links, each with the specified transmission rate…

A: Formulas: Transmission delay= Length of packet in bits / Transmission rate Propagation delay =…

Q: the packet size is 8 Bits. There are 5 routes between the sending host and the receiving host. each…

Q: Consider two hosts, A and B, connected by a single link of bandwidth R bits per sec. Suppose that…

A: The answer is...

Q: at

A: repeater delay = 1us Tt >= 2*Tp + 2*delay Tp = 100/1.77*10^8 = 0.56us Tt >= 1.12+2 = 3.12us…

Q: Consider the figure below, with three links, each with the specified transmission rate and link…

A: According to the asked question, the solution is given below with a proper explanation.

Q: Suppose users share a 3 Mbps link. Also suppose each user requires 150 kbps when transmitting, but…

Q: In this problem you will be doing some elementary calculations of transmission and propagation…

A: In this problem you will be doing some elementary calculations oftransmission and propagation…

Q: Consider N users are connected to a wireless network that offers a maximum data rate of 400 Mbit/s…

A: a) Maximum Data Rate or Bandwidth =400 Mbits/s Maximum Data Rate or Bandwidth is viewed as the most…

Q: Calculate the propagation delay in miliseconds (ms) for the link between Dijbouti and Israel under…

A: Note:- Please send the question again if you want an answer to another question. We are only allowed…

Q: 1. A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps.What is the…

A: Throughput of PURE ALOHA is S = G X e-2G Here G is average number of frames generated during one…

Q: ich of the following scenarios is most likely to cause a premature timeout due knowledgement, i.e.…

A: b. Output link capacity exceeds packet arrival rate and the router has a very small buffer size

Q: If we know the capacity of the link (bandwidth) and the time to receive the first ACK (delay) fre…

A: The first packet was sent in 301ms =301/1000 =0.301second 1gb/s=1000000000 byte/sec

Q: Suppose users share a 2 Mbps link. Also suppose each user transmits continuously at 1 Mbps when…

A: Total transmission rate= 2Mbps Minimum transmission rate required by each user = 1Mbps So it will be…

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction to statistical multilpexing gain

VIEW

Step 2 Solution

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Assume that each user requires 500 kbps and is only active 25% of the time. How many users can we multiplex on an 8 Mbps link using packet switching to meet user requirements with a probability of at least 0.9? In this scenario, what is the statistical multiplexing gain?
Assume each user has a 500 kilobit per second demand and uses the network only 25% of the time. How many users with a probability of at least 0.9 can we multiplex onto an 8 Mbps connection using packet switching? What benefit does statistical multiplexing provide in this case?
Assume that each user demands 500 kilobits per second and is only active 25% of the time. How many people can we multiplex onto an 8 Mbps connection using packet switching with a probability of at least 0.9? What is the statistical multiplexing advantage in this scenario?
Assume that each user wants 500 kbps and is only active 25% of the time. How many users can we multiplex onto an 8 Mbps connection if we want to ensure that user needs are met with a probability of at least 0.9 utilizing packet switching? What is the statistical benefit of multiplexing in this instance?
Suppose 80 users share a packet switched 200Mbps link. Each user requires 10.0Mbps when transmitting, but each user transmits only 25 percent of the time. What is the probability that the link is congested? Provide four digits after the decimal point for the answer.
Let's pretend every user has a need for 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate with a probability of at least 0.90 on a connection capable of 8 Mbps? What benefit does statistical multiplexing have in this case?
Take into account that each user needs 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate on an 8 Mbps connection with a probability of at least 0.9? What is the statistical multiplexing benefit in this case?
Assume each user needs 500 kbps and only uses 25% of the bandwidth. In order to meet customer demands with a probability of 0.9 using packet switching, how many users can be multiplexed onto an 8 Mbps connection? Was multiplexing statistically beneficial here?
Suppose users share a 2 Mbps link. Also suppose each user transmits continuously at 1 Mbps when transmitting, but each user transmits only 20 percent of the time. a. When circuit switching is used, how many users can be supported? b. For the remainder of this problem, suppose packet switching is used. Why will there be essentially no queuing delay before the link if two or fewer users transmit at the same time? Why will there be a queuing delay if three users transmit at the same time? c. Find the probability that a given user is transmitting. d. Suppose now there are three users. Find the probability that at any given time, all three users are transmitting simultaneously. Find the fraction of time during which the queue grows.
In this scenario, each user accounts for 25% of network activity and requires 500 kilobits per second. How many people can we expect to be able to multiplex onto an 8 Mbps connection using packet switching? Explain the benefits of statistical multiplexing.
Suppose the host and destination are 30km apart over two links each of equal distance. The switching delay is 5 msec. The host is sending 1500 B packets over the first link at a rate of 1Mb/s and the second link at 2Mb/s. Assuming no queuing delay. The link consists of fiber optic cable with the speed of light = 3 * 10^8 m/s. How long does it take for the destination to receive one packet from the host? Provide your answer in ms to the nearest tenth with no label. Note: Correct and detailed answer will be Upvoted else downvoted. Thank you!
Consider a 10 km long broadcast LAN has 10^10 bps bandwidth and uses CSMA/CD. The signal travels along the wire at 2.5 x 10^8 m/s. What is the minimum packet size that can be used on this network? Correct answer will be appreciated , else downvoted.