Answered: Suppose that a rectangular toroid has…

Suppose that a rectangular toroid has 1, 400 windings and a self-inductance of 0.040 H. If h = 0.13 m, what is the ratio of its outer radius to inner radius? R2 da

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 58PE: A device is turned on and 3.00 A flows through it 0.100 ms later. What is the self-inductance of the...

See similar textbooks

Related questions

Q: An inductor has a diameter of 6.0cm,20.0cm long and 500.0 turns . Compute the : a)self inductance…

A: a) The required self inductance is, L=μ0N2Al =4π×10-75002π0.06220.20 =4.44 mH

Q: A co-efficient coupling of 0.58 linked the two inductors with a mutual inductance of 25 uH. What is…

A: Coupling factor is given by : k = M/√L1L2 Where M = Mutual inductance L1= inductance of one…

Q: Arrange the following soleholds according to increasing inductance. Here N is the number of turns, A…

A: Given Solenoidwhere N is the number of turns. A is the cross-sectional area and L is the length of…

Q: A solenoid of length 8 x 10²m and cross sectional area 5 x 10-5 m²2 contains 6500 turns per meter…

A: Length , l = 8 x 10-2 m Area , A = 5 x 10-5 m2 number of turns , n = 6500 To find = self…

Q: The resistance of a coil is 52 0. When the frequency is 80 Hz, the voltage on the coil is 72,3°…

Q: A coil of resistance 15Ω and inductance 0.6H is connected to a 120V D.C. line. At what rate will…

A: (a) The expression for the current flowing through the inductor in RL circuit is written as, Here,…

Q: An emf of 0.50 V is induced across a coil when the current through it changes uniformly from 0.20 A…

A: solution is given by

Q: 6. a. Calculate the inductance of a solenoid containing 300 turns if the length of the solenoid is…

A: Given data- turns n=300, length l=25 cm=0.25 m, cross sectional area A=4×10-4 m2 Inductance of a…

Q: A coil produces an emf of 1.50 V when the current in it changes from -12.0 mA to +32.0 mA in 4.00…

A: According to the laws of electromagnetic induction, the induced emf is given by e = L d Id t where,…

Q: Tarik winds a small paper tube uniformly with 175 turns of thin wire to form a solenoid. The tube's…

Q: Tia needs to produce a solenoid that has an inductance of 3.33 ?H She constructs the solenoid by…

Q: A solenoid has an inductance of 0.179-mH with 53 turns of wire. Suppose the cross-sectional area of…

A: Given DataL1=0.179mHN1=53A1A2=A12l2=2l1N2=2N1

Q: A coiled telephone cord forms a spiral with 60.0 turns, a diameter of 1.30 cm, and an unstretched…

A: Write the expression for the inductance of the solenoid.

Q: Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If ℎ=0.10m,…

A: Given Number of turn N =2000 Self inductance L =0.04 H h =0.1 m

Q: 4.30 2 3. In the circuit the emf e 19.5 volts and the inductance L 107 mH. What will be the energy…

A: Given: The emf of the battery is 19.5 V. The inductance of the inductor is 107 mH. The time interval…

Q: It is possible to make your own inductor by winding wirearound a cylinder, such as a pencil. Assume…

Q: 4.30 2 3. In the circuit the emf ɛ = 190 volts and the inductance L= 34.6 mH. What will be the…

Q: A solenoid with 525 turns has a length of 5.50 cm and a cross-sectional area of 2.50 x 10 9 m2. Find…

Q: Calculate the self-inductance of a 10.0 cm long, 4.00 cm diameter solenoid that has 200 coils.

A: The expression for find self-inductance of the coil is L=μ0N2Al=μ0N2πr2l

Q: A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0…

A: The expression for the self inductance of solenoid, L=μ0N2Al (I)…

Q: Tia needs to produce a solenoid that has an inductance of 2.53 µH. She constructs the solenoid by…

A: In the given question, We have to determine the value of required length.

Q: A thin wire is tightly wrapped around a dowel (a wooden cylinder of radius 5.49 cm, length 0.28 m)…

A: Given that: Radius of the cylinder, r= 5.49 cm = 0.0549 mLength, l= 0.28 mNumber of turns in each…

Q: 8) The resistanoe of a coil is 540. When the frequency is 80 Hz, the voltage on the coil is 75,3…

Q: A coil with a self-inductance of 2.0 H carries a current that varies with time according to…

Q: A 298 turn solenoid has a radilus of 4.95 cm and a length of 19.5 cm. (a) Find the inductance of the…

A: Formula of inductance of solenoid is as follows: L=μ0N2Al…

Q: (Electrodynamıcs) Find the self-inductance of a torroidal coil wath rectangular cross section (inner…

A: Given:- The magnetic field inside the toroid is given as B=μ0NI2πs Find:- The self-inductance of a…

Q: A solenoid is made from a wire wound around a tube 36.0 cm long having a diameter of 8.00 cm. If…

Q: 1 A circuit shown consistsof threeSiis of inductanceś 1.0 H each and a 1.0 pF capacitance. At an…

Q: An ideal solenoid has a length of 25 mm. If the windings are compressed so that the length is…

A: Inductance: Inductance of a coil is defined as the emf induced in the coil when the current in a…

Q: 4. An inductor has an inductance of 0.16 mH. Calculate the number of turns per unit length of this…

Q: Tarik winds a small paper tube uniformly with 173 turns of thin wire to form a solenoid. The tube's…

A: Given data : Number of turns, N = 173 Diameter of the tube, D = 7.95 mm =…

Q: A solenoid with 465 turns has a length of 7.50 cm and a cross sectional area of 2.70×10^-9 m^2. Find…

A: Number of turns (N) = 465Length (L) = 7.50 cm = 0.075 m Area of cross section (A) = 2.7×10-9…

Q: 5. The solenoid in the circuit is made of tightly wound 1200 turns of wire on a 50.0 cm long…

A: Given : Number of turns equal to 1200

Q: A 300-turn solenoid has a radius of 5.00 cm and a length of20.0 cm. Find (a) the inductance of the…

A: The expression for the inductance of the solenoid is given by,

Q: Figure Q3(a) Calculate the inductance of the coil shown in Figure Q3(b), which has a cylindrical…

A: Given Number of turns of the coil N= 200 Length l =200mm = 0.2 meters Diameter d=5mm Then radius…

Q: Suppose you wish to make a solenoid whose self-inductance is 1.8 mH. The inductor is to have a…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Suppose that a rectangular toroid has 1, 400 windings and a self-inductance of 0.040 H. If h = 0.13 m,
what is the ratio of its outer radius to inner radius?
R2-
da
R2
R1
Submit Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the inductance?
What is the resonant frequency of a 0.500 mH inductor connected to a 40.0 (F capacitor?
It you want a characteristic RL time constant of 1.00 s, and you have a 500 (resistor, what value of self-inductance is needed?
A device is turned on and 3.00 A flows through it 0.100 ms later. What is the self-inductance of the device if an induced 150 V emf opposes this?
A 600-turn solenoid is 0.55 m long and 4.2 cm in diameter. Inside the solenoid, a small (1.1 cm × 1.4 cm), single-turn rectangular coil is fixed in place with its face perpendicular to the long axis of the solenoid. What is the mutual inductance of this system?
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and capacitors ranging from 1.00 pF to 0.100 F. What is the range of resonant frequencies than can be achieved from combinations of a single inductor and a single capacitor?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
After the switch is dosed in the LC circuit shown in Figure CQ32.8, the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible? Figure CQ32.8 Conceptual Question 8 and Problems 52, 54, and. 15.
What capacitance should be used to produce a 2.00 M(reactance at 60.0 Hz?
Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
An LC circuit consists of a 3.00 mH inductor and a 5.00 (F capacitor. (a) Find its impedance at 60.00 Hz and 10.0 kHz. (b) Compare these values of Z with those found in Example 23.12 in which there was also a resistor.
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.