Suppose your car was mired deeply in the mud and you wanted to use the method illustrated in the figure below to pull it out. то- - тот Tree Trunk (a) What force would you have to exert perpendicular to the center of a rope to produce a force of 13,500 N on the car if the angle is 0= 2.60°? (Enter the magnitude only.) N (b) Real ropes stretch under such forces. What force would be exerted on the car if the angle increases to 7.00° and you still apply the force found in part (a) to its center? (Enter the magnitude only.) N

Suppose your car was mired deeply in the mud and you wanted to use the method illustrated in the figure below to pull it out. то- - тот Tree Trunk (a) What force would you have to exert perpendicular to the center of a rope to produce a force of 13,500 N on the car if the angle is 0= 2.60°? (Enter the magnitude only.) N (b) Real ropes stretch under such forces. What force would be exerted on the car if the angle increases to 7.00° and you still apply the force found in part (a) to its center? (Enter the magnitude only.) N

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter10: Rotational Motion

Section: Chapter Questions

Problem 32P

See similar textbooks

Similar questions

A brass wire and a steel wire, both of the same length, are extended by 1.0 mm under the same force. Is the cross-sectional radius of the brass wire more, less, or equal to the cross-sectional radius of the steel wire? Explain. Youngs moduli for brass and steel are 1.0 1010 N/m2 and 2.0 1011 N/m2, respectively.
A steel cable 2.00 m in length and with cross-sectional radius 0.350 mm is used to suspend from the ceiling a 10.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.00 rad/s. What is the strain produced in the cable?
One end of a uniform 4.00-m-long rod of weight Fg is supported by a cable at an angle of = 37 with the rod. The other end rests against the wall, where it is held by friction as shown in Figure P12.23. The coefficient of static friction between the wall and the rod is s= 0.500. Determine tile minimum distance x from point A at which an additional object, also with the same weight Fg can be hung without causing the rod to slip at point A.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
An 1800-kg car, being lifted at a steady speed by a crane, hangs at the end of a cable whoseradius is 6.0 x 10 -3 m. The cable is 15 m in length and stretches by 8.0 x 10 -3 m because of theweight of the car. Determine a) the stress, b) the strain, and c) the Young’s modulus for thecable.
A 90 kg construction worker stands 2.0 m from the right end of a 6.0 m long, 600 kg steel beam as shown in the figure below. The left end of the beam is attached to a pivot point. The cable shown is made of steel with a radius of 2.0 mm. By how much does the cable stretch? (Give your answer in cm.)Young’s Modulus for steel is 2.00 x 1011 N/m2.
A student creates a beam bridge for a project, suspends masses from the bridge, and spans the bridge across two surfaces, as pictured below. What is the best approximation for the normal force applied on the bridge’s surface from PylonA? (A)About 0.8N (B)About 1.2N (C)About 1.4N (D)About 2.0N
An elastic rope is stretched between the tops of two identical posts. A man is to walk along the elastic rope. When the man is at the middle of the elastic rope, the tension in the elastic rope is 2220 N. Each half of the elastic rope makes an angle of 8.00with respect to the horizontal. Find the weight of the man.
Please Help with this problem: 1- You apply a force of 25 Newtons to a uniform cylinder of length 0.24 m and cross sectional area of 47 cm^2 in order to stretch the cylinder 2.5 cm. Find the Young's Modulus for the cylinder.
A farmer making grape juice fills a glass bottle to the brim and caps it tightly. The juice expands more than the glass when it warms up, in such a way that the volume increases by 0.2% (that is, ΔV/V0 =2×10−3) relative to the space available. Calculate the magnitude of the normal force exerted by the juice per square centimeter if its bulk modulus is 1.8×109 N/m2, assuming the bottle does not break. In view of your answer, do you think the bottle will survive?
A steel cable 1.70 m in length and with cross-sectional radius 0.380 mm is used to suspend from the ceiling a 20.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.50 rad/s. What is the strain produced in the cable? [Young's modulus of steel = 2.0×1011 N/m2]
In an isometric exercise a person places a hand on a scale and pushes vertically downward, keeping the forearm horizontal. This is possible because the triceps muscle applies an upward force M perpendicular to the arm, as the drawing indicates. The forearm weighs 24.0 N and has a center of gravity as indicated. The scale registers 103 N. Determine the magnitude of M. N