t=0 12Y 3F Yo 42

Q: Find the transfer function

A: Open Loop System-  A system which is controllable in which input of the system does not depends on t...

Q: Form the norton urcuit a. b. calculate IN Calculote RN Note : N is norton

A:

Q: P2- A two wire distributor 500 m long is loaded as shown below. The maximum nce drop allowed is 5% o...

A:

Q: 13) The fixed-bias configuration of Fig. G had an operating point defined by VGSQ = -2 V and IDQ = 5...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: 1. If the static electric force is 172.5 N, what is the distance between both charges • Q= 4.65x10^-...

A:

Q: For the circuit shown, if R1 > R2, then which of the following is true? R, R2 AV You cannot tell fro...

A: Given circuit:

Q: Problem #1: A 6-pole, 3-phase, Y-connected, 60-Hz alternator has 12 slots per pole and 4 conductors ...

A: In this question 3 phase alternator is given....We have to find out pitch factor , distribution fact...

Q: 9. Using the below general expression for geometric mean radius, prove that the inductive geometric ...

A:

Q: (c) The desired frequency response of low pass filter is 13; sus %3D 0; Determine ha(n) for M-7 usin...

A:

Q: 2- find the B.W of the TDM system have (12 voice Chanel) with message frequency fm=3.5 KHz

A: Given data, Number of channel N=12 Message frequency fm=3.5 kHz

Q: 9) Why calibration of instrument is important?

A: The measurement devices are used to measure electrical quantities. The true value and the measured v...

Q: 2. Find the z-transform of 0<n< N – 1 x[n]: %3D otherwise

A: The solution is given below 

Q: 2. Three charges as shown in the figure below. What is the electric force experienced by charge B? •...

A:

Q: 5. Three charge spheres are at the position shown in the figure. Charge A (4.67x10°C) is located at ...

A: (5) (a) The net electrical force between two charges is given as: F=kQ1Q2r2 All are positive charges...

Q: In the ASCII letter capital B, what are the hexadecimal and decimal representations?

A: Decimal equivalent of ASCII letter capital B = (66)10 Hexadecimal equivalent of ASCII letter capital...

Q: /sci: te f + COM R1 1kQ C1 2.5µF.

A: Given: R1=1kΩC1=2.5μF

Q: A 0.33- uF capacitor is in parallel with a 0.15 uF and a 220,000-pF capacitor. What is the total cap...

A:

Q: A point charge, QA = 1µC is at A(0, 0, 1), and QB = -1µC is at B(0, 0,-1). Find E,, E, and E, at P(2...

A:

Q: Explain the successive approximation type ADC with neat schematic diagram

A: Brief description : In the above given question they want to know the explanation for successive app...

Q: In the circuit shown below, V, is a sine wave with o DC bies, amplitude of SV, and frequency of 60HZ...

A: The circuit can be analysed by replacing the diode with its equivalent voltage drop.

Q: What is the amount of carrier swing necessary to produce an 80% modulation for the audio portion of ...

A: Given, Modulation index is 0.8 . Carrier swing needs to be calculated for audio portion of tv band. ...

Q: If the Vt = 230240°, determine the equivalent impedance submission bin "Solution" after the exam. In...

A:

Q: 9. Consider 12 2 10 Ω a O 18 V 3Ω a. Find and draw the Thévenin equivalent circuit b. Find and draw ...

A: In this question,  We need to draw the Thevenin equivalent circuit and Norton equivalent circuit.  A...

Q: *. 2 6-5-4-3–2-1 567

A:

Q: Commercial second order instruments have a damping ratio between 0.6 and 0.7. Justify

A: In measurement, the damping ratio describes how rapidly the oscillation decay from one bounce to the...

Q: Find the transfer function o

A: Open Loop System-  A system which is controllable in which input of the system does not depends on t...

Q: The surfaces p= 3 and 5, o = 100° and 130°, and z = 3 and 4.5 identify a closed surface. (a) Find th...

A: Closed surface- Closed surface has no edges but does have an inside and an outside. Examples are a s...

Q: The oloctric crrent i (in A) in a certain circuit in given by i-38cos (A(+0.40) where i in the tme i...

A:

Q: Part 1 After using the UT33B multimeter to check the voltage of the batteries and the resistance of...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: -Vcc Rc Rs Vout Vin RBZ CE- Vs .RE Fig-1- C.E E.

A: In ac analysis  capacitors  are short circuited and DC sources are grounded 

Q: 2. Find the inverse z-transform of X(2) = : 1z|> 0.1 -0.1

A:

Q: (18, 9, 9, 18) and a = (4, –4, 2, -2). Find the vector Let u = Ed component of u along a and the vec...

A:

Q: Find the distortion factor, for a single-phase half- wave bridge inverter with dc source Vs = 1 kV. ...

A: Given a single phase half wave bridge inverter with DC source, Vs=1 kV  

Q: signal transmitted from point A to point B. We know that the signal is normalized, meaning that –1 <...

A: From the given spectrum, we can observe that maximum frequency of message signal was 10KHz .

Q: What is the capacity factor?

A: Given data: Adam's Bay wind site Wind turbine G80-2000 Pout= 2000kw k=2.05 c=8.35 m/s h=10 m Site ro...

Q: A 2.5 kVA, 200v/40V single-phase transformer has the primary resistance and reactance of 3 and 12 n,...

A: Electrical machines can be either generator , transformers or motors. They can be either Ac machines...

Q: (23. Determine the magnitude and phase angle of the source voltage in Figure 14.48a. 22. Determine t...

A:

Q: くN

A:

Q: D. D2 Vo Vr1 -VR2 Discuss the above circuit with sinusoidal input of peek to peek voltage 10 V, Vr1 ...

A: In this question, Peak to peak input voltage is 10V. Assume forward bias voltage drop of Si diode is...

Q: Determine the relationship between capacitance, charge, and voltage

A:

Q: In an abc sequence of balanced source voltages, line voltage Vab Select the correct response: a. Lea...

A:

Q: J1 J2 Xsc2 R1 4 Key = A 4700 Key = A Tektronix V1 =25 V C1 :1000µF R2 1kQ

A: If switch J2 is closed then C1 and R2 are in parallel. Now if J1 is closed then initially capacitor ...

Q: 10K 10K 5K 5K Vo SK 10K 10K Derive the expression for the output voltage and the find the magnitude ...

A:

Q: Check the correct statements. * APU supplies DC power to DC bus 1 IDG1 and 2 are placed in parallel,...

A: Given statements about the APU APU supplies DC power to DC bus 1 IDG1 and 2 are placed in parallel,...

Q: Approximately how many bits are used by word data types?

A: A word data type  contains 2 bytes  One byte data type contains 8 bits

Q: 1 G1 s+ 1 1 G2 s+ 4 s + 3 G3 s+ 5 1. Three subsystems with the transfer functions G1, G2, G3 are con...

A: In this question we have to find the equivalent tranfer function if they are connected in series and...

Q: Problem 2.8 Given the circuit shown in Fig. P2.8, find a.) the value of ia; b.) the value of ib; c.)...

A:

Q: Explain how a transparent latch works and what it might be used for

A: WORKING OF TRANSPARENT LATCH: The data or the D-latch is an easy addition to a SR-latch that is gate...

Q: C. Perform the indicated operations (b) 13– 4i || 4+ 3i l:

A:

Q: A generator rated 75MVA is delivering 0.8pu power to a motor through a transmission line of reactanc...

A: