Take w1(n) = 2 sin(πn/10), and w2(n) = 1.5 cos(πn/10). What is the period of w? Find the amplitude and phase of w,given by w(n) =w1(n)−2w2(n)
Q: -Calculate the average power of the discrete-time wave shown in fig a? * O O O-1 01 O Oº La la la la…
A:
Q: Suppose that the modulating signal m (t) is sinusoid of the form m (t) = 10 COS ( 2π(10^3)t) and the…
A: As per the honor code we are supposed to answer only the 1st three subparts of the question. Plaese…
Q: An alternating voltage is given by v = 40 sin (200t – 0.5) volts. Find (a) the amplitude, (b) the…
A: Given : v = 40 sin (200nt - 0.5) volts We need to determine: (a) the amplitude (b) the peak-to-peak…
Q: Problem 2.4b: Sketch double sided and single sided amplitude and phase spectra of the following.…
A:
Q: Discussion: 1. Find the instantaneous frequency of the following waveforms: S1(t) = Accos[100nt +…
A: Here the instanteneous frequencies have been identified.
Q: Procedure: 1. Set the function signal generator to generate square wave at f = 650 Hz and Vs p.p = 8…
A: Supply frequency, fs= 650 Hz Peak to peak supply voltage, Vpp=8V Peak voltage, Vp=82 =4V
Q: Discussion: 1. Find the instantaneous frequency of the following waveforms: s, (t) = A.cos [100nt +…
A:
Q: A standing wave has the following wave-function: y(x,t) = 0.2 sin(2Tox) cos(12rt), where x and y are…
A: consider the given question;
Q: a shift from the x-axis is detected, determine the aximum amplitude in the positive cycle. for the…
A:
Q: A telephone cable has the following primary constants per loop -KM R=30 0, L-20 mH, C 0.06 F and…
A: Characteristic impedance- ZC=R+jωLG+jωC Ω where , ZC=Characteristic impedance R…
Q: The periodic input voltage source (Vg) is provided below. Given that Vm-30 V and T=10TT us, find the…
A:
Q: The AC voltage is given by a phasor 3.4 L 57 (where 3.4 is the amplitude and 57 is the phase angle…
A:
Q: If a shift from the x-axis is detected, determine the maximum amplitude in the positive cycle. for…
A:
Q: If the sequence x(n) =[k,0,1,2], compute the amplitude spectrum, phase spectrum and power spectrum…
A: matlab code used to plot the plots for the spectrums asked above.
Q: # 1: For the voltage v(t)=12 cos(50t+10°), find: 1. The amplitude (Maximum value) 2. The Root Mean…
A:
Q: Use an analytical method to determine if the signal x(n) is periodic; if so, find the fundamental…
A: A periodic signal is a signal which repeats itself after a particular time interval. This time…
Q: Given that Gs) - 4/s+0.9+0.3s+2.5), caloulate the phase in radians for a trequency of 0.2 radis to 3…
A:
Q: A given voltage signal f(t) = 4 cos² (20nt + 23º) – 6 cos (30nt + 68°) across 42. 1- Plot the…
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…
Q: A standing wave has the following wave-function: y(x,t) = 0.2 sin(3tx) cos(12rt) where x and y are…
A: Given: yx,t=0.2sin3πxcos12πtL=2 m
Q: Q.3/ Answer the following: A- An alternating voltage is given by V= 220 sin 314t volt. Find: (1) the…
A: Given : In the above question we have mentioned the alternating voltage V =220 sin(314t)…
Q: Q10: A given periodic signal (in volts), f(t) = 4 sin 8xt +2 cos 12nt Volts developed across…
A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…
Q: 1. Find the phase relationship between the following waveforms: a) v = 2 cos(wt - 30), i = 5 sin(wt…
A: Note: Since you have not specified any question to be answered, as per our honor code, we are…
Q: 7. For the signal, x(t)= log(cos(a*pi*t+d)) for a = 25 Hz, what is the time period of the signal, if…
A:
Q: Find Z₁ for maximum average power transfer and the maximum average power transferred. 1 Ω 1Ω…
A:
Q: Q15: A given voltage signal f(t) = 4cos²20rt+2cos30nt across 102. (a) Determine PSD of f(t). (b)…
A: We need to find out the power and power spectral density of given signal
Q: The graph below of g(x) is a transformation of the graph of f(x) = cos(x). The graph does not have a…
A: Transformation of the graph of any function is the shifting of graph from its original position…
Q: An alternating voltage is given by v = 25 sin (200t – 0.5) volts. Find (a) the amplitude, (b) the…
A:
Q: Exercises: 1. Generate sine/cosine waveforms of multiple frequencies, say xl=sin(2*pi*fi*n) +…
A: We need to generate sine/cosine waveforms of multiple frequencies say x1=sin(2πf1n)+sin(2πf2n),…
Q: If a shift from the x-axis is detected, determine the maximum amplitude in the positive cycle. for…
A:
Q: Q3) a) What is the power of the signal below? x(t) = 5 cos(10t + π/2) TIP: use the trigonometric…
A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.
Q: Given the sinusoidal voltage v(t) = 600 cos (400t-60°) V, find: a) The maximum voltage value b) The…
A: V(t)=600cos(400πt-60°)
Q: Consider the voltage source in a circuit is given by: v(t)=30sin(wt) +50sin(3wt)+10050sin(5wt),…
A: Complex waveforms: This waveforms contains addition of sine waves of different frequency…
Q: Determine the output wave-form for the network in the figure below then calculate the average and…
A: The given circuit has two diodes with different on-state voltage drop. During the positive half…
Q: A given voltage signal f(t) = 4 cos2 (20nt + 23°) – 6 cos (30nt + 68°) across 4N. 1- Plot the…
A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…
Q: Ex. 782. See Fig 782. A=39 ms, B=117 ms, C=17 V, D=-95 V. Find the a) dc voltage, b) rms voltage,…
A:
Q: QUESTION 10 The circult shown ie exoited by the sawtooth wave, niso shown. The sewtooth can be…
A: Inductors and capacitors are frequency-dependent elements. Its actual value remains the same but its…
Q: An airfield rectangular wavelength of inside dimensions 7cm X 3.5 cm operates at dominant mode of…
A: Given dimensions, 7 cm×3.5 cm
Q: Q3)A - (1) Sketch the amplitude spectrum and psd of the waveform shown in figure (2). Include at…
A: Given: Consider only one cycle of signal: So, for 0<t<1μs x(t)=103t Time period = 1μs…
Q: Find the amplitude, phase, period and frequency from v(t) = 12 cos (50t + 10°). Amplitude = Phase, p…
A: Given the amplitude, phase, angular frequency , period, frequency of the given signal V(t) = 12…
Q: Q5: A given periodic signal (in volts), f(t) = 4 sin 8at + 2 cos 12nt is developed across 12…
A: Since we are allowed to solve only up to three sub parts of a question, kindly upload the remaining…
Q: Given a voltage v = 50 cos(200nt + 60°) V. Find (a) its amplitude, (b) its phase angle in degrees,…
A: The solution is given below
Q: fitifvolt) 10 t(ms) 12 a/2 Q-If the above periodic signal is passed through a LPF that only passes…
A: Given: Carrier signal = 10coswct Hence Ac = 10V modulation index (m) = 0.5 To find: The power…
Q: Q.3/ Answer the following: A- An alternating voltage is given by V = 220 sin 314t volt. Find: (1)…
A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…
Q: If the sequence x(n) =[k,0,1,2], compute the amplitude spectrum, phase spectrum and power spectrum…
A: matlab code used to plot the plots for the spectrums asked above.
Q: Q3) a) What is the power of the signal below? x(t) = 5 cos(10t + π/2) TIP: use the trigonometric…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: Find the rms value of the periodic waveform of the figure below over one full cycle. Av (V) 1 cycle…
A: Average Value of a signal: It's that steady state equivalent of a time varying signal which would…
Q: Find the amplitude, phase, period and frequency from v (t) = 12 cos (50t + 10°). Amplitude = Phase,…
A: Standard form of the signal is V(t)= Vm cos(wt+phase angle) We will compare the given signal with…
Q: 8.1 Given i(t) = 5 cos (400t – 120°) A, determine the period of the current and the frequency in…
A: Given, Current, it=5 cos400t-120° A
Take w1(n) = 2 sin(πn/10), and w2(n) = 1.5 cos(πn/10). What is the period of w? Find the amplitude and phase of w,given by
w(n) =w1(n)−2w2(n)
Step by step
Solved in 2 steps with 1 images
- The rms antenna current for an AM transmitter increases by 15% over the unmodulated value when sinusoidal modulation applied. Find the depth of modulation. Use 4 decimal places for the final answer.Consider the sinusoids x1[n] = 2 sin(πn +2π/3) ,x2[n] = 3 cos(3πn + 3π/2) −∞ < n < ∞, From their frequencies determine if these signals are periodic, and if so, determine their corresponding periods.Q.3/ Answer the following: A- Analternating voltage is given by V =220 sin 314t volt. Find: (1) the amplitude, the peak-to-peak value, (2) the r.m.s. voltage (3) the periodic time, the instantaneous value of voltage when 7 = 6 ms, (4) Draw the waveform, write the phase difference.
- A 10-MHz sinusoidal carrier wave of amplitude 10 mV is modulated by a 5 kHz sinusoidal audio signal wave of amplitude 6 mV. : 1-Calculate m, Ps, Efficiency.I1= 100sin (750t+45) AI2=50sin (500t-30) AU=200sin (750t-90) VPlot the waves of the three of current and voltage, whose equations are as above, on a single graph. Take π=3 and find the frequencies.Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π(10^3)t) and the carrier signal C(t) is sinusoid ofthe form C(t) = 4 COS ( 2π(10^6)t + Ɵ) 15. Which type of AM wave can be used ina. Broadcasting b. TV16. According to the previous results which type of AM is the best in respect toa. Power transmitted b. band widthJustify your answers17. Draw the block diagram for both DSBSC and DSBFC with all parameters.
- (a) Determine the standing wave ratio ‘s’ shown in the figure below. Note that the dielectric is air. (b) Find the input impedance. (c)⍵L=10Ω. Find Is. (d) What value of C will produce a maximum value for |Is| at ⍵=1Grad/sec? For this value of C, calculate the average power: (e) supplied by the source (f) delivered to ZL=40+j30Ω.A carrier wave has an amplitude of 3.4 volts, a frequency of 10 MHz, and +π/2 radian phase angle. Select the correct carrier wave equation. a. c(t) = 10 cos(2π*3.4*t -1.57) b. c(t) = 3.4 cos(2π*10E6*t + 1.57) c. c(t) = 3.4 cos(2π*10*t + π/2) d. None of the above are correc4.2 A wave of sinusoidal nature has an angular velocity of 314.16 rad/s and has a particle displacement of 22.825 m after 6 ms.4.2.1 Draw the wave on the graphing paper below. Clearly show the calculations and indicate/highlight the amplitude, period of one of the cycles and the point of displacement described above.
- An alternating voltage is given by v = 20 sin (100πt – π/2) volts. Find (a) the amplitude, (b) thepeak-to-peak value, (c) the r.m.s. value, (d) the periodic time, (e) the frequency, and (f) type ofcircuit if voltage is 200 sin 100πt.A sinusoidal wave is given by v(t)=10*cos(177*t+1.5)[V]. Determine: a) The peak amplitude b) the peak-to-peak value c) the angular frequency w0 in [rad/s]find time, frequency, power in dB, vpp, average power