tate results in: CA cosh I

Q: Q3/ The bulk volume of the core sample is 150 cm³ and its porosity 18%. The pore compressibility of…

A:

Q: Explain in your own words the phase change process at latm condition la 1kg of ice at -30°C to 1kg…

A:

Q: 4.1 Water enters a 2.00-m³ tank at a rate of 6.00 kg/s and is withdrawn at a rate of 3.00 kg/s. The…

A:

Q: 65. The temperature of an ideal gas remains constant at 250 °K while the absolute pressure changes…

A:

Q: Styrene is manufactured by catalytic dehydrogenation of ethylbenzene followed by vacuum distillation…

A: Given data: T = 77 0C P = 100 torr or 13.33 kPa

Q: One of the methods to increase oil recovery from reservoir is injection of Carbone Dioxide. Explain…

A: Oil recovery techniques fall into three categories: 1) Primary oil recovery: It is employed during…

Q: Derive the adsorption isotherm for a system containing CO and O2 in equilibrium with a metal…

A: we need to determine the adsorption isotherm for a system containing CO and O2 in equilibrium with a…

Q: In 1 L2 = In 1: = L2 1 α-1 1 α-1 X1 S X2 1x +_X_dx 1X In X1 - a in (1-x1) X2 (1-X2)

A: The amount of residue left in the boiler can also be calculated using the given equation: ln L1L2 =…

Q: 3. Double pipe heat exchanger: A double pipe heat exchanger is used to cool an oil stream from a…

A:

Q: 4- Consider a wall (20x40) cm [k=12 w/m °C is heated by convection on one side and cooled by…

A:

Q: A volatile molecule (Mw =60 g/mol) is located in a box at 60 °C. It is measured there was a mass…

A: Given data: Molecular weight of volatile molecule = 60 g/mol Mass flow rate through the hole = 1…

Q: A sealed container holds 0.025 moles of nitrogen (N₂) gas, at a pressure at 1.5 atmospheres and…

A: Given that- Moles of N2 gas=0.025 moles Pressure, P= 1.5 atm Temperature, T= 290 K Atomic mass of…

Q: In the reaction shown below, the standard Gibbs energy of formation and standard enthalpy of…

A:

Q: An acetone and water liquid mixture is fed to an evaporator to be partially vapourized. The initial…

A: A mixture of acetone and water is to be partially vaporized.

Q: Propane gas (assume ideal) at 1 bar and 308.15 K is compressed to a final state of 135 bar and…

A: Given, The initial temperature, Ti = 308.15 K The initial pressure, Pi = 1 bar The final…

Q: ropylene oxide (C3H8O) is produced by reacting propylene (C3H6) with oxygen and hydrogen. A side…

A: A mixture of propylene, hydrogen, oxygen, and carbon dioxide is fed to a continuous reactor.

Q: 2. A culture is initially run in batch mode until the substrate is almost consumed. At this point…

A:

Q: 1. The elementary gas-phase reaction A+B+2C is carried out in a packed-bed reactor. The entering…

A: Write the reaction as follows: A +B→ 2C   (a) Write the mole balance as follows: -rA = FA0dXdV…

Q: What is the primary function of the aeration step in water treatment?

A:

Q: what's the answer in m^3?

A: The answer is, V =0.001334 lt  We have to convert the value to m3.

Q: A continues fractionation column, operation at atmospheric pressure, is to be designed to separate a…

A: A mixture of CS2 and CCl4 is to be separated into distillate and bottom product with the help of…

Q: For SO2 at 600 K and 300 bar, estimate the fugacity and of G R /RT by using 2nd virial equation

A: Given data: T = 600 K P = 300 bar

Q: 2) The absolute pressure within a 45.0-liter gas cylinder should not exceed 58.0 atm. Suppose the…

A: Write the SRK equation as follows: P = RTV-b-aVV+b        .......1 Where, a = 0.42748RTc2Pc1+m1-Tr2m…

Q: A liquid radioisotope with 2.7 µCi is being injected to a mouse. After 30 days, the remaining…

A:

Q: What is the derivative of d rho U / d rho ] S.   Rho = 1/ V   dU = TdS - P dV

A: It is required to calculate the derivative of d rho Ud rhoS Where rho = 1/V As per the given…

Q: draw a Pxy chart for material ethanol and phenol in the temperature T=70°C

A: Given mixture has two components. They are Ethanol (A) and Phenol(B). The temperature of the…

Q: 44, Cp closed, well-insulated rigid tank initially contains 3.80 kg of CO₂ (MW = ork in the amount…

A: The system is insulated so whatever the work supplied on system is used to raise the internal energy…

Q: Assuming in the last question, your calculated standard Gibbs energy of the oxidation reaction…

A: Given that :∆G = -70.2 kJ/molT=25 C =298.15 k

Q: 4.4 Draw and label the given streams and derive expression for the indicated quantities in terms of…

A: NOTE:- “Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: How can you remove particulates in flue gas (give 2 examples each for dry and wet methods)?

A: To describe Methods of removal of particulates in flue gas ( 2 examples each of dry and wet methods)…

Q: 5. A Carnot heat engine receives 650 kJ of heat from a source of unknown temperature and rejects 250…

A:

Q: what is the intracellular concentration of M-OPO32? F

A:

Q: You measure the mixing ratio of a gas to contain 15% ammonia and rest air. The required collection…

A: Ammonia is to be absorbed from the ammonia-air mixture with the help of a scrubbing liquid.

Q: A binary system can be described by the regular solution model. The enthalpy of mixing is given by…

A: Given, The enthalpy of the mixture, ∆Hmix = X1X2600X1+4000X2 The mole fraction of componenet-1, X1 =…

Q: Identify the following polymer processing techniques as either: (i) Continuous (able to operate for…

A: Dear User! As per our authoring guidelines, we have answered the first of the questions posted here.…

Q: CHEMISTRY FOR ENGINEERS  (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG…

A: Given that- Mass of ozone (O3) in stratosphere is 3 billion kilogram so as m=3 billion kg    =3×109…

Q: From

A: This is an absorption operation where solubility difference plays a major role. Solute grows form…

Q: ammonia absorption

A:

Q: In the following phase diagram of mixture A+B, the azeotrope is formed because: Temperature, T 0…

A: Select the correct answer from given azeotrope diagram.

Q: Consider a shell-and-tube heat exchanger constructed from a 0.0254 m OD tube to cool 7.93 kg/s of a…

A:

Q: The growth of plants in a greenhouse depends on the intensity of the lighting (as controlled by an…

A: The given relationship between plant growth rate P and light intensity L is given by…

Q: from stoichiometry equation we can say that we have 8 molecules of water PH2OP = NH2ONTotal =…

A: Volume of fuel = 600 L or 0.6 m3 Density of fuel = 0.684 kg/m3 Note: Density of heptane is given…

Q: 3. Three Carnot engines each having a power output of 1MW have heat supplied at a temperature of 450…

A: Given details: Power output of each engine=1 MW Temperature at which heat is supplied i..e Source…

Q: Air at 1 atm and 400 K and with a velocity of U∞o = 10 m/s flows across a compact heat exchanger…

A:

Q: A gas that behaves ideally has a density of 1.92 g dm^3 assuming air behaves as an ideal gas,…

A: Given data: Density of gas = 1.92 g/dm3

Q: QUESTION 9 Regarding the following reaction at constant temperature, calculate the ratio of Kx at…

A: Write the reaction as follows: H2COg ↔COg +H2g   Equilibrium constant is defined as the ratio of…

Q: Explain Principle, Merits and Demerits of Quadrupole Mass Analyzer? Please answer at your own easy…

A: The quadrupole mass analyzer or the quadrupole mass filter is a mass analyzer that is used in mass…

Q: Chemical Engineering Formaldehyde (CH2O), industrially with methanol (CH3OH) catalytic cell It is…

A: Given reactions are- CH3OH+12O2→CH2O+ H2O     .. (1)  CH2O+12 O2→CO+ H2O          ..(2)  Basis feed…

Q: A fuel gas containing 80% ethane and 20% oxygen is burnt with 200% excess dry air. Eighty percent of…

A: Basis: 100 kmol fuel gas The number of moles of ethane C2H6 in the fuel gas nC2H6,f = 80 kmol The…

Q: Q/ carbon dioxide (CO2) is compressed in a piston cylinder assembly of PI 0.7 bar. T1 = 280 K to P2…

A: Given data: Initial pressure, P1 = 0.7 bar Initial temperature = 280 K Final pressure, P2 = 11 bar…