technician A says a hybrid vehicle uses two different power sources. Technician B says a hybrid vehicle may use eaither a gas engine or electric motor to drive the wheels. who is correct?

Q: A: Set three of the most important electrical generation stations, and give at least one advantage…

A: 1.Thermal power generation. This is the most widely used power generation method  Adv: 1.bulk power…

Q: Does varying the motor field current Ip vary the motor speed n? O Yes O No Does varying the motor…

A: In this question we need to verify the given statement is true or false.

Q: State assumptions to represent the multimachine equations with a single machine infinite bus system.

A: Multi-machine system can be written similar to a one-machine system by the following assumptions: 1.…

Q: Explain the construction, operation of single phase Induction type energy meter with necessary…

A: Construction of  Single phase induction type Energy Meter The basic working of Single phase…

Q: Set three of the most important electrical generation stations, and give at least one advantage and…

A: Nuclear power plant:   Nuclear power plant are the kinds of power plant that uses the nuclear…

Q: Disconnect the DC power supply, and then measured the equivalent resistance by using the AVO meter…

A:

Q: What is output voltage of 12V transformer used in Automatic Hand Sanitizer Machine???

A: Hand sanitizer- Proper hand sanitizer is 99.999% effective against bacterial and viruses. This must…

Q: ix. What is the purpose of surge tank in hydro electric plant?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is Per Unit system and why it is used in Power system calculations?

A: Various parameters of the power system is represented in the per-unit system

Q: 1. Circuit breakers should be included in the impedance diagram. (True/False)

A: SINGAL LINE DIAGRAM OF A POWER SYSTEM: A single line diagram is the representation of a power system…

Q: Determine the maximum number of convenience outlets of 2 plug for 15, 20, 25 and 30 circuit breaker

A: Circuit Breaker- Circuit breaker is a device which is used as a switch which breaks the circuit when…

Q: What is 11? (Do not include the unit) * Your answer

A: In this question we need to find a current I1

Q: 1. The number of devices required to perform the no-load test and the short-circuit test for…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: Explain hybrid operation of wind farms

A: Hybrid operation of wind farms: Any combination of wind energy with another additional form of power…

Q: Mention three reasons behind increasing the voltage to large values during the transmission stage in…

A: The explanation is as follows.

Q: A-) Explain with the help of diagrams the structure and operation of Hybrid (Magic) Tee

A: A tee in microwave use to connect a section of waveguide in series or parallel to the main…

Q: what is vehicle servicing

A: A motor vehicle service or tune-up is a series of maintenance procedures carried out at a set time…

Q: Preference setting is used for controlling what parameter of a generating system and who will take…

A: The real world demands the analysis and design of complex systems. It is possible with the clear…

Q: 3_Give examples of the use interlocked of induction motor.

A: Interlocking means locking the motors in such a way that the if one motor stops all other stops and…

Q: 5.9 Explain, with the aid of suitable diagrams, how incorrectly positioned Arushes can cause the…

A:

Q: With the aim of a schematic, explain the principle of high impedance busbar protection.

A: High impedance bus bar protection requires High impedance CT with high knee point voltage and the…

Q: 1) Explain the advantages of using per-unit in power system

A: Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: Explain the reasons for applying system grounding in electric power systems.

A:

Q: write with technical material, digrams and pictures about Domestic electrical installation system

A: Domestic electrical installation system:

Q: In solar module, minimum value of shunt resistance could be 300 Ohm. Select one: True False

A: In solar module, minimum value of shunt resistance could be 300 Ohm.  Select one: True False

Q: Describe briefly circling the block diagram of fixed speed wind energy systems.

A: The short terms involved in the figure above are; SCIG :  Squirrel cage induction generator PCC :…

Q: 5.3 A small power system consists of two buses connected by three transmission lines. Assuming that…

A: According to the guidelines solve first three subparts of question you can post other subparts in…

Q: How many 2x1 multiplexers will be required to construct 8x1 multiplexer?

A: In the given problem we have to construct an 8x1 multiplexer with the 2x1 multiplexer. There are two…

Q: Design a hybrid powertrain which can be run both at series and parallel hybrid operation modes.…

A: A hybrid Powertrain, which can run both in series and parallel hybrid operation modes that includes…

Q: Draw the block diagram and clearly explain the operation of diesel power station.

A: The block diagram is shown below:

Q: A passenger arriving in a new town wishes to go from the station to a hotel located 10km away on a…

A: Given that  Distance from station to hotel is 10 km  Distance travelled is 23 km  Time taken to…

Q: Research on "Power Outage Detection and Locating Methods", roguirod nribo ito

A: Power outage is also called as the cutting of power or the power out,the blackout of power, the…

Q: Which of the following is the busbar type where active power and busbar voltage are input data in…

A: type of bus quantities specified quantities unspecified Generator bus P, V Q, δ Load bus P, Q V,…

Q: Explain briefly the Lightning Strike Structural Procedures and what the external aircraft components…

A: The lightning flash originates with the formation of electrical charge in theair or, more commonly,…

Q: Draw the block diagram of the hybrid energy management system using solar panels, battery and grid.…

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: With a sketch of block diagram, describe the importance of smart grid in modern electric power…

A: Smart power grid integrate the various renewable energy resources such as wind farm,hydro electric…

Q: How do I convert the following per unit voltages to actual voltage

A: In this question base voltage given, and per unit voltage is given.....We have to find out actual…

Q: this is not incomplete, and please do not answer its functioning of parts answer should be on point…

A: It is asked to explain the isolated operation of wind farms.

Q: A three bus system has the following bus power and voltage specifications:

A:

Q: Consider a single line to ground fault at the neutral end of a Y-connected stator winding of a…

A: Single line to ground fault-: ER→ = I1→ Z1 + I2 →Z2 + I0→ Z0 + VR    where; VR→ = 0I1→ = I2→ = I0→…

Q: Draw the schematic diagram of Induction type energy meter and explain the construction of the same.(

A: To explain the induction type energy meter

Q: QUESTIONS:- 1- Conclusions from experience ? 2-write any five parts of a wind turbine ?

A: 1. Torque-Speed characteristics of wind turbine and the generator :

Q: Problem 4: Consider an interconnected 50-Hz power system that contains four turbine-generator units…

A: The solution can be achieved as follows.

Q: Protective relays used to prevent the fTaults in power system O True O False

A: The function of the protective relay is to detect the fault in the system and remove the faulty…

Q: 3. Explain the construction, operation of single phase Induction type energy meter with necessary…

A: An Energy Meter is an electrical measuring tool that is used to determine how much energy a load…

Q: A line has a rated current of 1,000 A. Assume that a relay (with a rated current of 5A) is connected…

A: In this question we need to find secondary pickup current in per unit .

Q: 41. What are the Salient Features of Indian Grid Codes for Wind Power Generation?

A: (41) The salient features of Indian Grid Codes for Wind power generation are: a. IEGC stands for…

Q: Changing faulty or worn-out electrical parts, such as motors and repairing loose connects or damaged…

A: TRUE