The 2013 Toyota Camry has an empty weight of 3190 lbf, a frontal area of 22.06 ft2, and a drag coefficient of 0.28. Its rolling resistance is Crr ≈ 0.035. Estimate the maximum velocity, in mi/h, this car can attain when rolling freely at sea level down a 4° slope.

The 2013 Toyota Camry has an empty weight of 3190 lbf, a frontal area of 22.06 ft2, and a drag coefficient of 0.28. Its rolling resistance is Crr ≈ 0.035. Estimate the maximum velocity, in mi/h, this car can attain when rolling freely at sea level down a 4° slope.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.29P: Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance...

See similar textbooks

Related questions

Q: An aircraft has span efficiency factor = 0.7831, minimum drag coefficient = 0.025, wing area = 175…

Q: Calculate the power required to overcome the drag. How much power does a 27 km / h head wind blow?

A: Given Data: The mass of the car is, m=2000 kg. The coefficient of drag is, Cd=0.3. The area of the…

Q: Name some applications in which a large drag is desired.

A: Drag force is a force acting on a body (moving or stationary)which is present in a moving or…

Q: 4.19 Calculate the drag coefficient for a wedge with a 20° half-angle at Mach 4. Assume the base…

Q: Assume the stabilizer of an airplane is a flat plate. If the transition /critical RN 750,000, what…

A: Given:- RN=750000 Chord=0.81m v=44.7 m/s2 Rectangular span:=1.73m To find:- Drag

Q: A shuttlecock is launched from the ground with an initial speed of 37.3135 m/s at an angle of 7.8471…

Q: 10.1 After getting gas, you forget your mug of coffee on the roof of the car. As you drive away from…

A: Given: m = 0.4 kg mu = 0.3 a = 1.4 m/s2 A = 0.01 m2

Q: A shuttlecock is launched from the ground with an initial speed of 34.6092 m/s at an angle of 5.462…

A: Given When drag force becomes equal to weight net force is zero Final velocity can be determined as

Q: Air at free-stream velocity of 9 m/s flows over a thin flat plate of length 3 m and width 1.5 m. A…

Q: 6. During a winter day, wind at 70 km/h, 5°C, and 1 atm is blowing parallel to a 4-m-high and 15…

Q: The rectangular wings of a microlight aircraft have a combined spanwise length of 9.144 m and…

A: Given Length = 9.144 m Width = 0.9144 m Drag coefficient = 0.01 Lift coefficient = 0.03 Velocity =…

Q: An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has…

A: Given data as per question Velocity = 150 m/s Altitude = 6000 m Aspect ratio =10 Span length =36 m…

Q: M1 = 2.6 5° %3D C A symmetric diamond-wedge airfoil is in an external flow at Mach number M1 = 2.6…

A: Given /c =tantc=tan450m1=2.6v=1.4from θ-β-M…

Q: A shuttlecock is launched from the ground with an initial speed of 33.3163 m/s at an angle of 8.1977…

Q: Using shock-expansion theory, calculate the lift and drag coefficients for a flat plate at a 5°…

A: Upper pressure ratio is calculated using P-M expansion theory. Lower pressure ratio is calculated…

Q: Wind at 20°C and 1 atm blows at 75 km/h past a flagpole18 m high and 20 cm in diameter. The drag…

A: Given data

Q: (See Fluids in the News article "Why Winglets?) It is estimated that by installing appropriately…

A: The drag coefficient (often abbreviated as) is a dimensionless variable used in fluid dynamics to…

Q: An aircraft has span efficiency factor = 0.7831, minimum drag coefficient = 0.025, wing area = 175…

Q: An airplane has a mass of 19,550 kg, a wingspan of 20 m,and an average wing chord of 3 m. When…

A: Given: The mass of an airplane is m=19550 kg. The density of the air is ρ=0.5 kg/m3. The wingspan of…

Q: Kindly give me both right solutions with clear calculations The drag polar of a glider is given by…

Q: Consider an infinite wing with an NACA 1412 airfoil section and a chord length of 1 m. The wing is…

Q: 13) An inflated toy balloon is about 8g, with a cross-sectional area of 0.023 m'. It falls in air…

Q: 16. The flow in a compressor cascade test has an angle of 60° at inlet and of 30° at outlet. The…

A: Givenα1=60°α2=30°sD=0.8

Q: Skydiver Luke jumps with his parachute of diameter D = 12 m out of an airplane. The combined mass of…

Q: To measure the drag of an upright person, without violatinghuman subject protocols, a life-sized…

A: Write the given data: pair=1.2 kg/m3L=6 mN=80 rpmP=60 kW=60000W1000 W1 kW

Q: Consider a flat plate at zero angle of attack in an airflow at standard sea level conditions (p∞ =…

A: Given data: Sea level conditions: P∞=1.01×105 N/m2, T∞=288K, μ∞=1.7894×10-5 kg/(m.s) Also for air…

Q: Two steel spheres of diameters d, and d₂ where d₂ = 2d₁, are dropped from rest at the free surface…

Q: Assume the stabilizer of an airplane is a flat plate. If the transition /critical RN 750,000, what…

A: Given data as per the question RN=750000v=44.7 mschord length =0.81 mrectangular stabilize having…

Q: A flagpole 16 m high has the shape of a cylinder 100 mm in diameter. The air temperature is 30°C and…

A: Please first draw the free body diagram and proceed further

Q: from

Q: A liquid (? = 850 kg/?3; ? = 1.7 × 10−1 Pa ∙ s) flows tangentially past a flat plate. If the free…

A: 2 Length of the plate, L=10 mWidth of the plate, w=3 mLiquid density, ρ=850 kg/m3Liquid viscosity,…

Q: Consider the same Lockheed F-104 supersonic fighter shown, with the same flight conditions of Mach 2…

Q: A shuttlecock is launched from the ground with an initial speed of 36.9838 m/s at an angle of 9.9728…

A: given information: The initial speed of shuttle cock (u) = 36.9838 m/s angle made by initial…

Q: b) Figure Q1(b) shows a smooth flat plate that is 150 mm wide and 500 mm long placed longitudinally…

A: Drag force: The drag force is the force acting opposite to the direction of fluid flow. Due to its…

Q: Determine the velocity required for take off for an aircraft with the following characteristics.…

A: Given that, Mass of aircraft, m=7200 kg,Wingspan=15 m,Wing shape=Rectangular,Wing chord length=1.8…

Q: The airfoil section of the wing of the British Spitfire of World War II fame is an NACA 2213 at the…

Question

The 2013 Toyota Camry has an empty weight of 3190 lbf, a frontal area of 22.06 ft², and a drag coefficient of 0.28. Its rolling resistance is C_rr ≈ 0.035. Estimate the maximum velocity, in mi/h, this car can attain when rolling freely at sea level down a 4° slope.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance from the entrance to the point at which the hydrodynamic boundary layers meet.
The drag of an airfoil (Fig.) increases considerably ifyou turn the sharp edge around 180° to face the stream. Canyou explain this?
Name some applications in which a large drag is desired.
The 2013 Toyota Camry has an empty weight of 3190 lbf,a frontal area of 22.06 ft2, and a drag coefficient of 0.28. Itsrolling resistance is Crr ≈ 0.035. Estimate the maximumvelocity, in mi/h, this car can attain when rolling freely atsea level down a 4° slope.
A shuttlecock is launched from the ground with an initial speed of 36.9838 m/s at an angle of 9.9728 degrees with respect to the horizontal. The shuttlecock experiences air resistance with a drag coefficient of 0.1967 in an environment where the air density is 0.7584 kg/m3. If the shuttlecock has a radius of 3.4 cm and a mass of 5.2 grams, what is the maximum height reached by the shuttlecock? Assume that the experiment is done near the surface of the earth.
For those who think electric cars are sissy, Keio University inJapan has tested a 22-ft-long prototype whose eight electricmotors generate a total of 590 horsepower. The “Kaz” cruisesat 180 mi/h (see Popular Science, August 2001, p. 15). If thedrag coefficient is 0.35 and the frontal area is 26 ft2, what percentageof this power is expended against sea-level air drag?
Air equivalent to one of a standard height of 4000 m flows at 450 mi/h over a wing with a thickness of 18 cm, a chord of 1.5 m, and a wingspan of 12 m. What is the appropriate value of the Reynolds number to correlate lift and drag on this wing?
The so-called Rocket Man, Yves Rossy, fl ew across the Alps in2008, wearing a rocket-propelled wing-suit with the followingdata: thrust = 200 lbf, altitude = 8,200 ft, and wingspan = 8 ft(http://en.wikipedia.org/wiki/Yves_Rossy). Further assume awing area of 12 ft2, total weight of 280 lbf, CDq = 0.08 for thewing, and a drag area of 1.7 ft2 for Rocket Man. Estimate themaximum velocity possible for this condition, in mi/h.
Icebergs can be driven at substantial speeds by the wind.Let the iceberg be idealized as a large, flat cylinder, D >> L,with one-eighth of its bulk exposed, as in Fig.. Letthe seawater be at rest. If the upper and lower drag forcesdepend on relative velocities between the iceberg and thefluid, derive an approximate expression for the steady icebergspeed V when driven by wind velocity U.
Air at 20°C and 1 atm flows at 3 m/s past a sharp flat plate2 m wide and 1 m long. (a) What is the wall shear stress atthe end of the plate? (b) What is the air velocity at a point4.5 mm normal to the end of the plate? (c) What is the totalfriction drag on the plate?
The main cross-cable between towers of a coastal suspensionbridge is 60 cm in diameter and 90 m long. Estimatethe total drag force on this cable in crosswinds of 50 mi/h.Are these laminar flow conditions?
The drag coefficient of a car at the design conditions of 1 atm, 70°F, and 60 mi/h is to be determined experimentally in a large wind tunnel in a full-scale test. The frontal area of the car is 22.26 ft2. If the force acting on the car in the flow direction is measured to be 68 lbf, determine the drag coefficient of this car.