An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has an aspect ratio of 10 with a span of 36 m. Using the airfoil data as in Fig. 3, determine the lift and drag forces. Then determine the power required to overcome drag. Consider the airplane flying at an angle of attack equal to 2. wWw ww

An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has an aspect ratio of 10 with a span of 36 m. Using the airfoil data as in Fig. 3, determine the lift and drag forces. Then determine the power required to overcome drag. Consider the airplane flying at an angle of attack equal to 2. wWw ww

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.49P

See similar textbooks

Similar questions

Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance from the entrance to the point at which the hydrodynamic boundary layers meet.
An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The airfoil has an aspect ratio of 10 with a span of 36 m. Using the airfoil data as in Fig. 3, determine the lift and drag forces. Then determine the power required to overcome drag. Consider the airplane flying at an angle of attack equal to 2.
A flying wing weighing 20,000 N has a NACA 65‐418 airfoil section, an area of 30 m2, and an aspect ratio of 5.0. Determine the angle of attack for a sea‐level flight at 60 m/s. What is the lift‐to drag ratio? Assume that the nominal airfoil lift curve slope a0 = 0.106/deg̊, the profile drag CD0 = 0.0043 and e = 0.92.
Air at 20°C and 1 atm flows at 3 m/s past a sharp flat plate2 m wide and 1 m long. (a) What is the wall shear stress atthe end of the plate? (b) What is the air velocity at a point4.5 mm normal to the end of the plate? (c) What is the totalfriction drag on the plate?
Air flows at Ma = 2.5 past a half-wedge airfoil whoseangles are 4°, as in Fig. Compute the lift and dragcoefficient at α equal to (a) 0° and (b) 6°.
Consider an infinite wing with a NACA 1412 airfoil section and a chord length of 3 ft. The wing is at an angle of attack of 5° in an airflow velocity of 100 ft/s at standard sea-level conditions. Calculate the Reynold’s number, lift, drag, and moment about the quarter-chord per unit span. Cl = 0.67, Cmc/4 = -0.025 and Cd = 0.007Detailed solution pls
Consider an aircraft that has the maximum takeoff weight (MTOW) of 19500kg. The aircraft is required to cruise at 10500 m at Mach 0.6. a) Analysis and sizing of the wing (lift and drag calculations, aerofoil selection etc.) Wing area: 118588.94mm^2
Determine the velocity required for take off for an aircraft with the following characteristics.Aircraft mass: 7200 kgWingspan: 15 mWing shape: rectangularWing chord length: 1.8 mWing airfoil: NACA 4415Wing angle of attack: 7× 0.5 + 5 degreesHint: Check NACA charts for required parameters.
a)What is the impact of increasing Reynolds number on skin friction and pressure drags over an airfoil? What can be happened for separation in this case? b) What is an adverse pressure gradient and where does it occur on an airfoil (show that on a sketch)? c) Why lift-to-drag ratio is an important parameter for an aircraft? d)How can changing in altitude affect the aircraft power required, PR? Show thatmathematically and graphically?
The drag of an airfoil (Fig.) increases considerably ifyou turn the sharp edge around 180° to face the stream. Canyou explain this?
Consider an NACA 2412 airfoil with a 2-m chord in an airstream with avelocity of 50 m/s at standard sea level conditions. If the lift per unit spanis 1353 N/m, what is the angle of attack?
Task 2:An airplane with a NACA 662-215 airfoil cruises at 170 m/s at an altitude of 4550 m. The airfoil has an aspect ratio of 9 with a span of 30 m. Determine the lift and drag forces then determine the power required to overcome drag. Consider the airplane flying at an angle of attack equal to 2.