The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflectioncoefficient is R=0.5.Thedistancebetween the voltage maximum and the load is0.15 lambda. What isthe imaginary partof the load impedance?

Answered: The 50 ohm transmission line…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.18P

See similar textbooks

Similar questions

For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and 50 ohm respectively. What will be the value of the characteristic impedance of the line?
The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm respectively. What will be the characteristic impedance of the transmission line?
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.
The magnitudes of the open circuit and short circuit input impedances of transmission line are 100 ohm and 50 ohm respectively. What will be the characteristic impedance of the line?
A 50ohm transmission line powered by a 3GHz source and terminated with a load impedance ZL=25-j60 ohms will be matched with the shorted parallel side. What should be the length, in m, of the parallel lateral line calculated using the Smith diagram ?
A transmission line of characteristic impedance 40 ohms and length 6.2λ is terminated by an unknown load impedance. The reflection coefficient, Γ, looking into the transmission line at the input is 0.45+j0.55 What is the unknown load impedance?
A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the characteristic impedance of the line is 50 ohm, them what will be the attenuation constant of the line in Neper (Np)/m?
A 50-ohm lossless transmission line has series inductance of 250 nH/m and shunt capacitance of 100 pF/m. What is the time delay per unit length (in ns/m) of this transmission line? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an interger).
A transmission line is not properly terminated thereby causing a a reflection coefficient magnitude of 0.5 where the reflected current is in phase with the incident current at the point of reflection. What is the impedance of the termination if the characteristic impedance of the line is 50 ohms?
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning