The areas of cut of two irregular sections 60 m apart are 32 m^2 and 68 m^2 respectively. The base width is 8 m. with a sideslope of 1:1. Find the volume using end area method in cubic meter. (Type your answer in whole number, numerical value only, no need to include the units).

The areas of cut of two irregular sections 60 m apart are 32 m^2 and 68 m^2 respectively. The base width is 8 m. with a sideslope of 1:1. Find the volume using end area method in cubic meter. (Type your answer in whole number, numerical value only, no need to include the units).

Fundamentals Of Construction Estimating

4th Edition

ISBN:9781337399395

Author:Pratt, David J.

Publisher:Pratt, David J.

Chapter4: Measuring Site Work, Excavation, And Piling

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: (b) (i) Differentiate between two level section and side hill two level section with neat diagrans…

A: The major difference between between two level section and side hill two level section is that in…

Q: The cross-section notes shown below are for a ground excavation for a 8m wide roadway. STA 16+200…

Q: ASSIGNMENT 2 As shown in the figure below, lines NQ and PR are established perpendicular to line…

A: Given data:

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 23+8400…

Q: 2. The data tabulated represents earthwork quantities for a certain road extension project. STATION…

Q: Q2): The table below presents the calculated areas of closed contour lines (reservoir) taken by a…

A: Scale = 1:500 It has been asked in the question to determine the Total capacity of the reservoir…

Q: 5. A square piece of land 60x60 m is to be leveled down to 6m above elevation zero. To determine the…

A: A=29.8, B=27.3, C=25.2, D=28.3, E=26.5, F=24.3, G=26.9, H=23.3, I=24.2, J=21.3,K=22.6, L=20.5,…

Q: 1. A square piece of land 60m x 60m is to be leveled down to a level coinciding to elevation zero.…

A: Excavation depth = average elevation - zero Determine Volume of cut, V = grid area * average…

Q: Define the Effective Area Method (Meyerhoff, 1953) ?

A: When foundations are exposed to both moment and vertical loads, this is a common occurrence.…

Q: Q2) Using prismoidal formula to calculate total volume cut and fill when the ground area (50 m X 60…

A: Scale = Distance on the map Distance on the ground Area (sq.cm) Actual area (sq.m) 30 A1 = 750…

Q: 1. The cross section notes below are for a ground excavation for a 10 m wide roadway Determine the…

Q: Problem 1 Fill the table and use 25% expansion factor Fill Vol. Station Cut, ft? Fill, ft? Cut Vol.…

A: Volume =Avg Area ×LengthAvg Area =A1+A22Volume yd3=A1+A22 ×Length27 Fill (25%)=fill/1.25

Q: Compute the area of the following shape in (Dunam, Evlek, m2):

A: Join B to E and C to E. So that we can find area of ∆CDE, ∆BCE and ∆ABE and area of circular segment…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 12+2800…

Q: The cross-section notes shown below are for a ground excavation for a 8m wide roadway. STA 23+500…

Q: In the accompanying plot the boundary of the water surface of a reservoir is shown by irregular…

A: Calculating the mid section area: Area of section FG:…

Q: SITUATION 4- Hydrographic Survey- End Area Hethod The area bounded by the water line of a reservoir…

Q: The areas bounded by the water line of a reservoir is determined using a planimeter. The distances…

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 13+8300…

A: To Determine the cross sectional area at STA 13+8300.

Q: 3) The following figure shows the elevations of the grid leveling for some land. Compute the volume…

A: To find volume of cut and fill to grade the road ABCDE at 20.00 m Elevation.

Q: 4. In the accompanying sketch, determine the area included between the base line and the irregular…

Q: A traverse line was measured in three sections: 295.85 m at slope 8°45’, 149.58 m at 4°29’, and…

Q: 30 kN 50 kN B C D 1m 3 m 2 m Figure P-403

A: We have to solve the above given beam using integration method with slope intercept as per the solid…

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 17+800…

Q: Given the cross section notes of a route survey, compute the volume: a) by Prismoidal formula b)…

Q: Given the following cross-sectional notes below with side slopes of 1:1 and a same base of 10 m, Sta…

Q: Suppose the area bounded by the water line of a lake the contours 1, 2, 3, 4 and 5 are as follow

Q: 4. In the accompanying sketch, determine the area included between the base line and the irregular…

A: To Find Area included between the base line and the irregular boundary.

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 22+400…

Q: Problem no. 8: Given the following cross-sectional notes below with side slopes of 1:1 and a same…

Q: 23.01 From the given cross-section notes of an earthwork, it is required to determine the value of…

Q: a. Volume using end area method b. What is the cross sectional area in the midsection of the…

A: V = h1 ×A1 + A22 +h2A2+A32 +h3A3+A42 + h4A4+A52here h1=20 m A1=0 m2h2 = 40 m A2 = 208…

Q: A square piece of land 60 m x 60 m is to be levelled down to 8 m above elevation zero. To determine…

A: Volume : Volume is a scalar quantity that represents the amount of three-dimensional space enclosed…

Q: Find the volume of excavation required for the area shown in the figure. Each grid point (20 in…

A: Depth of the cut at every location is given find the average depth of cut…

Q: The areas enclosed by contours in a lake and a hill situated side by side in a plot of land are as…

A: Given are the contour areas for hill and lake. We need to say, whether material is is just…

Q: P1. Volume Computation using Contour Method The great Lake Buwis was surveyed by Engr. Guanzon. The…

A: Contour method 2D residual stresses are measured using the contour approach. A flat surface is used…

Q: A square piece of land 60x60 m is to be leveled down to 6m above elevation zero. To determine the…

A: A=29.8, B=27.3, C=25.2, D=28.3, E=26.5, F=24.3, G=26.9, H=23.3, I=24.2, J=21.3,K=22.6, L=20.5,…

Q: Compute the area given the following cross section notes: Base for cut = 9m and for fill =8 m. Side…

Q: At station 10+020 a rectangular trench was measured and found to be 4.20 m wide by 1.2 m deep. At…

Q: Q.1) Answer one only A) A rectangular plot (ABCD) forms the plane of a pit excavated for road work.…

Q: Problem 2: The cross-section notes shown below are for ground excavation for a 10-m wide roadway.…

A: Given - St 16+100 ⇒ 8.2L+2.15L·0+3.5·13.65R+5.8(x coordinates) (y coordinates) ⇒Given Width ⇒ 10 m…

Q: Q2). Calculate volume of cut and fill, the elevation of natural ground shown on all nodes and design…

Q: Q2): The table below presents the calculated areas of closed contour lines (reservoir) taken by a…

A: Prismoidal method is for odd number of reading but if we have to calculate for even number then odd…

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 20+700…

Q: 1. A square piece of land 60m x 60m is to be leveled down to a level coinciding to elevation zero.…

A: Given data:- Size of a square piece of land =60m×60m Elevation is zero Below diagram is given;

Q: Q4) Calculate the area between the irregular boundary shown in the figure below and the chain line…

A: Haii as per Bartleby policy I can solve only first question if you want solution to the second…

Q: If the area of mid section is 345.98 sq. m and the individual areas A1, A2 are 123.31 and 157.31…

A: to find the volume of pyramid here we have to use prismoidal formula

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 24+600…

Q: True or false 1. When there is an imbalance in the volume cuts ans fills in construction projects.…

A: As per company guidelines, we are supposed to answer only first 3 subparts. Kindly repost other…

Concept explainers

Volumes

Volume usually is the dimensional quantity that involves the evaluation of any three-dimensional figure enfolded inside a closed space. The SI unit (International System of Units) of volume is m3 and the dimensional unit of volume is [L3]. For estimation of the volume of any figure, various formulae are used. Another application of volume includes the reference in the sound levels, the higher the sound intensity, the louder the sound heard, and hence, the larger the volume. The SI unit of sound volume is decibels (dB).

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The areas of cut of two irregular sections 60 m apart are 32 m2 and 68 m2 respectively. The base width is 8 m. with a side slope of 1:1. Find the volume using end area method.
The areas of cut of two irregular sections 60 m apart are 32 m2 and 68 m2 respectively. The base width is 8 m. with a sideslope of 1:1. Find the volume using end area method.
The areas is cut of 2 irregular sections 35m apart are 34 sq.mtrs and 56 sq.mtrs the base width is 10m. Find the volume of cutting using prismoidal rule having a side slope of 1 horizontal to that of 1 vertical. Discuss, how you derive your answer on the question above.
Line AB = 250m long and was paced five times by the surveyor and recorded as follows: Another line CD was paced four times again with the following results: Please determine the actual length of line CD. (show full solution)
What is the volume of the cut (m3) using the prismoidal correction formula?
A square piece of land 60x60 m is to be leveled down to 6m above elevation zero. To determine the volume of earth be removed by the Borrow-Pit Method the land is divided into 9 squares whose corners are arranged as follows with the corresponding elevations, in meters, above elevation zero. Find the volume of cut in cu.m by u8nit area basis.A=29.8, B=27.3, C=25.2, D=28.3, E=26.5, F=24.3, G=26.9, H=23.3, I=24.2, J=21.3, K=22.6, L=20.5, M=21.1, N=18.5, O=17.8, P=20.5
Q/The following Figure shows an irregular area drawn on a plan on a plan to a scale of 1:500. Calculate the area of the top of the embankment by the following methods: (a) Counting squares (b) Simpson's and trapezoidal rules
Excavation, removal and dumping of earth are one of the frequent works in engineering survey. The junctions of the square grid shown below were levelled to determine the volume of excavation necessary in the construction of basement floor. The reduced levels of the grid points are as shown. The grid distance between points are 20m and the required formation level is to be at 95.0 m. Determine the volume to be cut or fill using Grid formula
The following offsets 8m apart, were measured from traverse line to an irregular boundary; 0.0, 2.3m, 5.5m, 7.9m, 8.6m, 7.3m, 3.1m and 0.0m. (a) calculate the area between the traverse line and irregular boundary using Simpson's rule. (b) Calculate the volume of excavation assuming the section of area calculated in (a) begins from chainage 4+200 to 4+600
A traverse line was measured in three sections: 295.85 m at slope 8°45’, 149.58 m at 4°29’, and 373.48 m at slope 4°23’. Determine the horizontal length of the line. Draw the figure and show the complete solution. Provide a recheck of the answers.
Answer the subquestions: A. A slope measurement of 545.38 m is made between points A and B. The elevation of A is 424.25 m and that of B is 459.06 m. Determine the horizontal distance between two points. B. A traverse line was measured in three sections: 295.85 m at slope 8°45’, 149.58 m at 4°29’, and 373.48 m at slope 4°23’. Determine the horizontal length of the line. Note: Draw the figure and show the complete solution. Provide a recheck of the answers.
The areas in cut of two points of level sections that are 75m apart are 36sqm and 72sqm. Side slope is 3H:2V and base width is 10m. Determine the Volume of excavation using the PRISMOIDAL METHOD and correct the computed volume using the formula for PRISMOIDAL corrections. Please answer in 3 decimal places and provide figure