The chlorine demand test conducted in a laboratory for raw water samples is tabulated below.SampleChlorine dosage (mg/1)Residual chlorine (mg/1)0.20.150.40.31C0.60.480.80.601.00.55F1.20.241.4045H.1.606518085What is the breakpoint dosage and chlorine demand at dosage of 14 mg 1 respectively?

Answered: Image /qna-images/answer/63f941a1-3256-457d-827d-5721bad1d2d0.jpg

The chlorine demand test conducted in a laboratory for raw water samples is tabulated below Sample Chlorine dosage (mg/1) Residual chlorine (mg/1) 0.2 0.15 0.4 0.31 0.6 0.48 0.8 0.60 E 1.0 0.55 1.2 0.24 1.4 045 H. 16 065 18 085 What is the brecakpoint dosage and chlorine demand at dosage of 14 mg 1 tespectively?

The chlorine demand test conducted in a laboratory for raw water samples is tabulated below Sample Chlorine dosage (mg/1) Residual chlorine (mg/1) 0.2 0.15 0.4 0.31 0.6 0.48 0.8 0.60 E 1.0 0.55 1.2 0.24 1.4 045 H. 16 065 18 085 What is the brecakpoint dosage and chlorine demand at dosage of 14 mg 1 tespectively?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An orifice meter was calibrated by the manufacturer for air at 25℃ and 1atm. It is installed in an air sampling system where it operates at 33℃, 0.9atm and reads a ΔP of 4.8″H2O. The calibration curve has the relationship Qi=41×(ΔP)1/2in slpm(liters per minute at 25℃, 1atm). What is the true gas flow rate in slpm?
PLEASE PUT ALL THE DECIMAL PLACES. THANK YOU The average hourly water consumption per person is 2.5 Liters anf there are 264 people in the area. Determine the following. a. the minimum rate of flow in L/s in the spring b. Total Daily water demand in L/day c. The daily yield is sufficient to the water demand of the community if the rate of flow is 0.182 L/s d. the height of the cylinder in cm thatt the minimum discharge can fill within 300 secs. diameter of the cylinder is 10 cm.
Sanitary Engineering Potential of Hydrogen (pH) same question please help me: 1-What are alternative methods for determining the pH of aqueous samples?2- What are typical pH values of drinking water in Jordan? How do your datacompare with these values?3-Discuss the relationship between (a) pH and hydrogen ion concentration (b) pHand hydroxide ion concentration?
Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L to the permissible value of 2500 CFU/L. It is given that the velocity of flow through the pipe is 0.7 m/s and the rate constant is 0.25 per min.
Although gas station owners lock their tanks at night, a gas station owner was the victim of theft because his employee had a key to the tank. The owner of the gas station wants to bury the gasoline so deep that no vacuum pump will be able to extract it. He has hired a general contractor to dig the holes for the tanks. What is the minimum gasoline surface depth ℎ2 needed to prevent siphoning by any pump? Assume the specific gravity of gasoline is 0.733 and that the tank is not sealed. (You can ignore the drop rate of the gasoline level inside of the tank.) ℎ2= The gas station owner balks at the contractor's estimate. He neither has the funds nor approval from the city to dig that deeply. However, the contractor tels him that the best a thief could hope to have at his disposal is a 212‑mbar vacuum pump. Anything better would be enormously expensive. Given this information, how deep ℎ2 would the gasoline have to sit below the surface to keep it safe from thieves? ℎ2=
A stream flows through a small town where an industry dischargesits effluent into the stream. Upstream characteristics prior to industrial discharge are as follows: fow rate 1000 m3/d, BOD5 2.5 mg/L,nitrates 2.0 mg/L, and temperature 19°C. The industry dischargesat 50 m3/d. According to regulatory requirements, the maximumallowable values in the stream following any discharge are BOD5 30mg/L, nitrates 4.0 mg/L, and temperature differential of 4°C fromupstream conditions. Calculate the maximum allowable values forthe industrial discharge.
1. THERE IS A LEAK IN A HORIZONTAL 300 MMDIAMETER PIPELINE. UPSTREAM FROM THE LEAK TWOGAGES 600 METER APART SHOWED A DIFFERENCE OF140 ???. DOWNSTREAM FROM THE LEAK TWO GAGES600 METER APART SHOWED A DIFFERENCE OF 126??? . ASSUMING ? = 0.025. HOW MUCH WATER ISBEING LOST FROM THE PIPE. show answer in litre per sec
A 150 g/l solution of a chemical was discharged into a stream @ 0.01 L/sec. The quantity of same chemical already present in stream is = 5007 parts per billion. The concentration of chemical at sampling section was found to be 5 parts per million. Estimate the stream discharge.
Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L to the permissible value of 2500 CFU/L. It is given that the velocity of flow through the pipe is 0.7 m/s and the rate constant is 0.25.
Please do not give solution in image formate thanku. Q18. A groundwater basin of 144.7 km2 receives 126.7 cm of recharge on average each year. Groundwater loss from the basin in the form of evapotranspiration occurs at a mean rate of 62.9 cm/year (i.e. there is no groundwater discharge to the sea or rivers). Pumping draws groundwater from the basin at a rate of 0.65 m3/s. What is the rate of change in storage in GL/year? (note: 1 GL = 109 L)
Can I get a thorough step by step for this question? Each month the speedy dry-cleaning company buys 1.75 barrel (0.28 m') of dry-cleaning fluid. The amount of fluid lost to the atmosphere as emission is 210 kg/month and the remaining remains as residue to be disposed of. The density of the dry-cleaning fluid is 1.5940 g/mL. Draw a mass-balance diagram and estimate the monthly % of mass residue to be dosposed of.
Problem 5Suppose there is a river that has a flow rate of 3.00 m3/s with negligible concentration of sodium chloride and astream discharges into this river at a flow rate of 0.05 m3/s. The concentration of sodium chloride of the out flowafter mixing is to be 1.0 mg/L.1. What should be the inflow concentration of sodium chloride in the stream to maintain a steady statecondition? Consider a completely mixed system.2. Calculate the mass rate (kg/d) of the sodium chloride in the stream?