The circuit consist of a capacitor, inductor, resistor and voltage source in series, the standard units of respective elements are ordered as- Farad, Henry,Volts, Ohms Farad, Henry,Ohms,Volts O Farad,Ohms, Henry,Volts O Henry, Farad,Ohms,Volts

Q: Q3: Use long Division to prove x(n) given in each of the followings : (1) xcn) = [: -3 %3D z²- 2…

A: In this question we need to find a x(n) of the given signal.

Q: The maximum efficiency of a 100 kVA transformer having an iron loss of 900 W and a full load copper…

A: Given  Wfcu  = 1600 W  Wi     = 900 W  Sfl   = 100 kVA  Smax  = ?

Q: 3. Use the Routh-Hurwitz criterion to determine the range of gain, K, for which the system is…

A: In this question we need to find a range of K for system to be stable and value of K for system to…

Q: 1. For the voltage-divider bias configuration, using the approximate approach determine: a. IBQ b.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Explain the effect of base resistance and collector resistance on the circuit.

A: Effect of base resistance on the circuit: Base resistance plays a vital role in the protection of…

Q: Which of the following frequencies (in units of Hz) exist in the spectrum of a signal…

A:

Q: À 0.3-kg ball has a velocity of 20 m/s. How much work would be required to stop the ball? The work…

A: Given that, Mass of ball m=0.3 kg Initial velocity, u=20 m/s Final velocity, v=0 m/s

Q: 4. If you have a 24.0 V motorcycle battery that can make 3500 C of charge, and a 24.0 V car battery…

A: Given, For motorcycle, Voltage rating, Vm=24 V Charge made, Qm=3500 C   For Car, Voltage rating,…

Q: For discrete time signal x[n] defined as below, х[п]%3 {3, 0, 0, 0, 3}

A:

Q: PROBLEM 4 Consider TM waves in a long rectangular waveguide of width w and height h. a) Calculate…

A:

Q: Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:

A: Given: A circuit is having Inductive reactance, XL=1022 Ω Resistance, R=985 Ω

Q: H. W1: - Determine if the following system are causal or not a.y(n) = x(2n) b.y(n) = 3x(n) – 4 x(n –…

A:

Q: 3. Check whether the signal is periodic or not? x(t) = cos(4t) + 2sin(8t) a) Periodic with period…

A:

Q: CO calculate Vth,Rth,Il 1k Ohm 330 Ohm 6 V/1 kHz RL 220 Ohm 330 Ohm

A:

Q: What is the per unit impedance of a 50 MVA, 13.8 kV, 1% impedance transformer if the base is change…

A:

Q: Question 4: a)The barrier potential (v)at a PN – junction in a semiconductor diode is given by (0 +…

A:

Q: NICS Draw the y(t) signal if the signal x(t) shown below: x(t) 3 4. y(t) = x(-t + 5 ) %3! 5. y(t) =…

A: As per company guidelines we can solve only first three sub parts kindly post another parts…

Q: ww ww 24/60° (t -juse For the given circuit, find V; (+).

A:

Q: 4.a) Realize the given system in direct form-I y[n] = 0.5y[n-1] – 0.25y[n-2] +x[n]+ 0.4 x[n-1]

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other…

Q: Differentiate the total current of a series and parallel circuit through the application of…

A:

Q: [3] Let X(e") be DTFT of x[n]. When the magnitude and phase of X(e") are plotted as below, magnitude…

A:

Q: What is the mass of a proton?

A: Given: Proton

Q: 59 8.63 Use nodal analysis to find V, in the circuit in Fig. PS.63. 41, V. 10 Figure P8.63

A: In this question,   We need to determine the value of the voltage Vo as shown in the circuit using…

Q: E8.20 Use (a) mesh equations and (b) Thévenin's theorem to find V, in the network in the ANSWER:…

A:

Q: Find the current given a voltage of 120 V and a resistance of 43 Ω.

A:

Q: Electrical Engineering What is the logic function Va Vp o Vg Ve 어 Va 에 오

A: The solution is given below

Q: For the following ASM chart , Complete the design procedure.

A: We have ASM chart. We will follow the chart to design block diagram and controller.

Q: A galvanometer is rated to have a sensitivity of 80mA/cm.What will be the change in reading when the…

A: Given a galvanometer is rated to have a, Sensitivity = 80 mA/cm Current reading = 500 mA

Q: What will be the capacitive susceptance of the capacitor in the circuit given below? sine R 40 2 L…

A: The given circuit is:

Q: 8.51 Using nodal analysis, find I, in the circuit in Fig. P8.51. j1nキ 4/0 A 12/6 V 2/0 A Figure…

A: In this question,  We need to determine the current Io using the Norton theorem.  We are solving…

Q: A three-phase star-connected synchronous motor draws 70 A at 0.8 pf leading when connected from  a…

A: three-phase star-connected synchronous motorI=70 A Power factor, cosϕ=0.8 ϕ=36.86°Efficiency,…

Q: Q2-The circuit shown below shows the using of NAND gate as other logic gate, use these information…

A: We have to design xor gate using nand gate

Q: Up/Down State Machine Consider a state machine implementation of a two bit up/down counter The state…

A: As a self-reversing counter, the UP/DOWN counter might be utilized. It may also be used as a clock…

Q: 8.52 Use nodal analysis to find I, in the circuit in Fig. P8.52. -ji A 20: O 4/0 A O 6/0 v j2n 20…

A: The solution is given below

Q: * The different between a triac and a diac is A diac has a t wo gate terminal, but a triac does not.…

A: For the given Questions we have to select correct option or identify the True or False condition,…

Q: Question 5: A resistance arrangement of 50 is desired. Two resistances of 100.0±0.1 Q and two…

A: Let Two variables are x and y and the output is z. The uncertainty in x and y is ωx and ωy then the…

Q: find the current passing through the surface Z=1, 0<X<1, 0<Y<1 if H= Y^2*X ax-3*Z^3*y az 1.2 A 1.3A…

A: We need to find out current .

Q: Q1/ Explain in detail VOLTAGE DROP / RISE IN TRANSMISSION LINE With mathematical examples

A:

Q: 1. In the following circuit, what is the peak current, in amperes (A), through the secondary coil,…

A: The solution is given below

Q: P1. Show whether each of the following systems is linear/time invariant. a) y(t) = S(t) t>0 b) y(t)…

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other…

Q: ww ww 4/0" A () 12/6 v 2/0 A

A: Apply KCL at node V1I1=Io+I2+2∠0°12∠0°-V11=V11+V1-V21+2∠0°3V1-V2=10∠0°⇒V2=3V1-10 .....1KCL at node…

Q: What scale value would you use with analogWrite() to generate a average vlotage of 4V on PWM pin 9?

A: Given data, Required voltage to be generated is 4 V on pin 9

Q: What happens when the anode-to- cathode voltage exceeds the * ?forward-breakover voltage The device…

A: This is the concept of silicon controlled rectifier.

Q: In a circle of a radius 4 feet, what central angle corresponds to an arc length of 8 feet? A. 4…

A:

Q: Design a single stage CE VDB amplifier with an open circuit voltage gain of 45 dB. Also, use 2N3904…

A: We need to design a single-stage CE amplifier with an open circuit voltage gain of 45 dB using a…

Q: 1k Ohm 330 Ohm RL 6 V/1 kHz 220 Ohm 330 Ohm

A:

Q: 8.1: Choose the suitable choice for the following sentences, and explain/describe your choice with…

A: 1. Answer: another coil Explanation: a. the coil itself If a current flowing through coil and…

Q: approximatë Value de of Ipss of the given circuit below. VDD 20V 2.1ka Q1 V. v, - - 4.5V v, - 1.5 V…

A: In this question,  We need to choose the correct options What is the Current IDSS  ?

Q: 5- Determine the truth table of the digital circuit shown in the figure below and explain its…

A:

Q: A piece of silicon doped with Boron experiences an electric field equal to 0.1 V/um. Calculate the…

A: Given, Electric field, E=0.1 V/μm Mobility of electron, μn=1000 cm2/V.s Mobility of holes, μp=300…

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.