The circuit shown in Fig. Qhas input x(t) = 3u(t) V where u(t) represents the unit step function. Find the current in the circuit given the following initial conditions: initial current through the inductor, i(0-) = 3 A initial voltage across the capacitor, v(0-) = 2 V

The circuit shown in Fig. Qhas input x(t) = 3u(t) V where u(t) represents the unit step function. Find the current in the circuit given the following initial conditions: initial current through the inductor, i(0-) = 3 A initial voltage across the capacitor, v(0-) = 2 V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The switch in the circuit shown has been open for a long time. At t=0, the switch closes. 1. Derive…

A: (1) Write the integrodifferential expression for the given circuit.

Q: An experiment was performed on your system and it was recorded that the oscillations decayed…

A: Because damping resists and thus slow the back and forth motion, the period and frequency of a…

Q: Question 2. In an invasive blood pressure measurement set-up, the catheter tip is covered with…

A: Given that :Step Pressure = 20 mm Hgy(t) = Ke-ξωnt cos(1-ξ2 ωnt)a) ωd=ωn1-ξn ξ=1The glove is…

Q: In the circuit shown, find the value of R for which the steady-state energy stored in the inductor…

Q: 3. Determine whether or not the LTI systems with the following impulse responses are causal and…

A: 3) A causal system (otherwise called a physical or nonanticipative framework) is a system where the…

Q: 10 Design an Op Amp circuit which gives an output voltage V, = -3 + 5 S Sin 50t dt + 7dV¼ dt %3D

Q: Assume that the switch has been in its previous position for a very long time, solve for I, for t>0…

Q: We have seen that in a series RLC circuit, Kirchoff's voltage law (VR+VL+Vc = Vs, where Vs is the…

Q: Q4/A: The switch in the circuit shown below has been closed for a long time, and it is opened at t…

Q: Consider the following second-order system: U(s) Second Order Y(s) Step System Response The step…

A: Given data:

Q: The switch in the circuit of Fig. Q5 is closed for a long time and then opened instantaneously at t…

Q: 2) The circuit shown below is at steady state before the switch closes. t = 0 in) Find the 2nd order…

Q: Source-Free Series RLC Circuit Solve for the roots s1 and s2, and determine whether the circuit is…

Q: A series RLC circuit has a C= 0.25 µF and L=1H. Find the roots of the characteristic equation for R,…

A: Consider a series RLC circuit derived by a constant emf source of V and current flowing in the…

Q: 5. Find the differential equation for iL(t) in the circuit below. Is the solution underdamped,…

A: A second order RLC circuit with a current source is given in the question. We need to find the…

Q: For the following circuit, it vi 2 H if the input is v;(t) = 2u(t), find the output vo in the…

Q: Find the characteristic equation and its roots for the circuit shown. 10 20 10 µF 1 mF + H

A: To find the Characteristics equation and roots, First, we need to find the impedance in s domain.…

Q: 2. The input to the circuit shown below is the voltage vi(t). The output is the voltage vo(t). The…

A: In this question, Inputs voltage and output voltage are given. We need to determine the value of…

Q: A single loop RLC electrical circuit can be modelled as a second order system in terms of current.…

A: We will apply laplace transform for converting differential equation to s domain. We will compare…

Q: If the switch in Fig. opens at t-0, find v(t) for t 20 and initial energy stored in the capacitor. t…

Q: Analyze the circuit below. Assume the circuit has reached steady state before t 0. a.) Find the…

A: In the given circuit, the current source 4ut becomes active for time t≥0 second, i.e.,…

Q: If the general solution of the differential equation having 7 arbitrary constants, then the order of…

A: The arbitrary constants in the general solution of the differential equation is equal to the order…

Q: 5- The error response of a control system is given as e(t) = 2e¬"sin (6t + 50°). Find the damping…

Q: Plot the root-locus for the OLTF G(s) 10k(s+1) s2+8s+10 b/Also , calculate the gain for a damping…

Q: Q6) Find the Natural Response v(t) of the Parallel RLC circuit given below. (a) Given v(t) = 12 V at…

Q: 6. a. Draw an RLC circuit with a 0.3 N resistor, 0.1 H inductor, and 5 F capacitor connected in…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: Find the complete response of the capacitor v(t) for t > 0 for the circuit. Assume the circuit is at…

Q: Consider the given circuit where vs(t) = 12[1+u(t)]V. a) Find the initial conditions i(0-) and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 13.6 The initial charge on the capacitor in the circuit shown is zero. a) Find the s-domain Thévenin…

Q: 7.37. A linear time-invariant discrete-time system is excited by the input x[n] = 8[n] + 2u[n – 1].…

Q: Q2: If the switch in Fig. opens at t=0, find v(t) for t > 0 and initial energy stored in the…

A: To find the voltage expression across the capacitor and initial energy stored in capacitor

Q: 2. For the circuit below, the switch is open for all t0. Find the second- order differential…

A: Given the circuit, as shown below: The switch is open for all t<0 and closed for closed for all…

Q: 5. The switch in the circuit has been closed for a long time, and is opened at -0. Find v(t) for t2…

Q: Q3. The switch in the circuit shown below has been closed for a long time and is opened at t=0.…

A: Transient response

Q: A series RLC circuit has R= 2000, L = 0.1 H, and a capacitor C = 10 uF. If a 200 V dc source is…

Q: Given: A system is linear time invariant with the following information • Zeros: –3 ± j4 • Poles: –1…

A: From the basics of Laplace transform

Q: Assume that the circuit in the image has been connected for a very long time. (a) As time…

Q: = 2. The input to the circuit shown below is the voltage vi(t). The output is the voltage v.(t). The…

Q: R www Vc For the given circuit above, the circuit values are as follows; L- 330 mH, C= 50 µF and R =…

Q: minimize f(x) = ;nx{ + x3+xi subject to X1 > 0. Determine the solution to this problem for the cases…

A: The partial differential equation Pp+Qq=R, where P, Q, and R are functions of x, y, and z, is known…

Q: A System given by the differential equation 5x(1) + x(1) = u(1). %3D y (t) =x(t) The corresponding…

Q: 6. a. Draw an RLC circuit with a 0.3 N resistor, 0.1 H inductor, and 5 F capacitor connected in…

A: Node: The meeting point of more than two branches in a circuit is referred as a node. KCL: According…

Q: Assume that the switch has been in its previous position for a very long time, solve for , for t>0…

A: We know that in steady-state conditions, the inductor acts as short-circuit and the capacitor as an…

Q: Q3. The switch in the circuit shown below has been closed for a long time and is opened at t=0.…

A: Transient analysis

Q: 5. If R = 10 Ω, L = 5 H, and C = 2 mF, find a, b, and the roots of the characteristic equation. What…

Q: The resistance, inductance, and capacitance in a parallel RLC circuit are 1900 Ω , 250 mH , and 9 nF…

A: As per bartleby expert policy only first three subparts are to be answered. Kindly repost remaining…

Q: H.W.: a) A parallel RLC circuit contains a resistor R 2 2 and an inductor L 4 H. Select the value of…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Question

The circuit shown in Fig. Q has input x(t) = 3u(t) V where u(t) represents the
unit step function. Find the current in the circuit given the following initial
conditions:
initial current through the inductor, i(0-) = 3 A
initial voltage across the capacitor, v(0-) = 2 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given data

VIEW

S-domain circuit

VIEW

Finding I(t)

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuit on the left. DC voltage u1(t ≥ 0) = U is applied at time t = 0. Both meshes must include the input voltage. At time t = 0, the capacitors are free of energy. The following applies: τ = R*C. Derive the 2nd order differential equation for the capacitor voltage u2(t).
A causal linear time-invariant continuous-time system has impulse response h(t) = e-t +sin(t) , t >= 0 Compute the output response for all t>=0 when the input is the unit-step function u(t).
Determine the natural response of the given parallel RLC circuit below that is Vc(t) at t ≥ 0 seconds. Specifically, solve for Vc(1)
For the circuit below determine: a) vc(0+), iL(0+) b) dvc(0+)/dt , vc(∞) c) Is the circuit Underdamped, Critically Damped or Overdamped?d) Determine the expression for the voltage across the capacitor for t > 0.
Circuit analysis 2 In the circuit shown below, the value of ic (t) for t <0 is equal to which of the following?
A system has a damping ratio of 0.5, a natural frequency of 100 rad/s, and a dc gain of 1. Find the response of the systems to a unit step input.( from the canonical form solve for the response of the system) G(s)=Blank 1
The impulse response of a continuous-time LTI system is given byh(t) = u(t) −u(t − 5) where u(t) is the unit step function.a) Find and plot the output y(t) of the system to the input signal x(t) = u(t) using the convolution integral.b) Determine stability and causality of the system.
4. An RL circuit has R = 2Ω and L = 4 H. The time needed for the inductor current to reach 40 percent of its steady-state value is? 5. In the circuit of Fig, the capacitor voltage just before t = 0 is
The switch in the figure below has been position A for a long time and moved to position B at t = 0. Solve for VC(s). (Use the s-domain equivalent circuit in the analysis studies.)
For the circuit shown, just after t = 0s, the current through the inductor is IL(0+) = 0A and the voltage across the capacitor is Vc(0+) = 0V. a)Prove that the natural response of Vc(t) will beoverdampedb) Find the roots of the characteristic equation that governs the transient behavior of Vc(t)
use the differential equation approach to find Vo(t) for t > 0
The circuit shown below has been in that situation for a long time. At t=0, part of the circuit is cut down from the dashed line. Determine vC1(t) for t > 0.