The construction of a water pistol is shown in the figure below. The cylinder with cross-sectional area A, is filled with water and when the piston is pushed (bypulling the trigger), water is forced out the tube with cross-sectional area A,. The radius of the cylinder and tube are, respectively, 1.50 cm and 1.20 mm, and thecenter of the tube is a height h3.00 cm above the center of the cylinder. (Assume atmospheric pressure is 1.013 x 10° Pa.)A2A(a) If the pistol is fired horizontally at a height of 1.20 m, determine the time interval (in s) required for water to travel from the nozzle to the ground. Neglectair resistance.S(b) If the desired range of the stream is 7.90 m, with what speed v, (in m/s) must the stream leave the nozzle?m/s(c)At what speed v, (in m/s) must the plunger be moved to achieve the desired range?m/s(d) What is the pressure (in Pa) at the nozzle?Ра(e) Find the pressure (in Pa) needed in the cylinder.Ра(f)Calculate the force (in N) that must be exerted on the trigger to achieve the desired range. (The force that must be exerted is due to pressure over andabove atmospheric pressure. Enter the magnitude.)N

Name: The construction of a water pistol is shown in the figure below. The
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: The construction of a water pistol is shown in the figure below. The cylinder with cross-sectional area A, is filled with water and when the piston is pushed (bypulling the trigger), water is forced out the tube with cross-sectional area A,. The rad