The current is the result of the flow of.. . and the SI unit of current is theO A) the neutral atoms / ampereO B) the negative charges / ampereO C) the positive charges / ampereD) both positive and negative charges / ampereO E) none of them

Current is the rate of flow of charges with respect to time. Charges could be positive, negative or…

Answered: The current is the result of the flow…

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 28PE: What current flows through a 2.54-cm-diameter rod of pure silicon that is 20.0 cm long, when 1,00 ...

See similar textbooks

Similar questions

(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A 20-A fuse in a household electric circuit burns out. What catastrophe could occur if it is replaced by a 30-A fuse?
Check Your Understanding Verify that /V and e0/d have the same physical units.
Can a wire carry a current and still be neutral-that is, have a total charge of zero? Explain.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
Could a person on intravenous infusion (an IV) be microshock sensitive?
Check Your Understanding Copper wires use routinely used for extension cords and house wiring for several reasons. Copper has the highest electrical conductivity rating, and therefore the lowest resistivity rating, of all nonprecious metals. Also important is the tensile strength, where the tensile strength is a measure of the force required to pull an object to the point where it breaks. The tensile strength of a material is the maximumamount of tensile stress it can take before breaking. Copper has a high tensile strength, 2108Nm2 A thirdimportant characteristic is ductility. Ductility is a measure of a material’s ability to be drawn into wires and a measure of the flexibility of the material, and copper has a high ductility. Summarizing, for a conductor to be a suitable candidate for making wire, there are at least three important characteristics: low resistivity, high tensile strength, and high ductility. What other materials are used for wiring and what are the advantages and disadvantages?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain what current, resistance, and voltage are.
If you pick up and shake a piece of metal that has electrons in it free to move as a current, no electrons fall out. Yet if you heat the metal, electrons can be boiled off. Explain both of these facts as they relate to the amount and distribution of energy involved with shaking the object as compared with heating it.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . There are two basic methods for connecting more than one electrical device in a circuit. Name, describe, and give the advantages of each.
What current flows through a 2.54-cm-diameter rod of pure silicon that is 20.0 cm long, when 1,00 103 V is applied to it? (Such a rod may be used to make nuclear-particle detectors, for example.)
SPEAR, a storage ring about 72.0 m in diameter at the Stanford Linear Accelerator (closed in 2009), has a 20.0-A circulating beam of electrons that are moving at nearly the speed of light. (See Figure 20.39.) How many electrons are in the beam? Figure 20.39 Electrons circulating in the storage ring called SPEAR constitute a 20.0-A current. Because they travel close to the speed of light, each electron completes many orbits in each second.
Check Your Understanding Handheld calculators often use small solar cells to supply the energy required to complete the calculations needed to complete your next physics exam. The current needed to run your calculator can be as small as 0.30 mA. How long would it take for 1.00 C of charge to flow from the solar cells? Can solar cells be used, instead of batteries, to stall traditional internal combustion engines presently used in most cars and trucks?

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Inquiry into Physics

Physics

ISBN:

9781337515863

Author:

Ostdiek

Publisher:

Cengage

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Inquiry into Physics

Physics

ISBN:

9781337515863

Author:

Ostdiek

Publisher:

Cengage

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

SEE MORE TEXTBOOKS

The current is the result of the flow of . and the Sl unit of current is the. ..... A) the neutral atoms / ampere B) the negative charges / ampere C) the positive charges / ampere D) both positive and negative charges / ampere E) none of them