The density of mobile electrons in copper metal is 8.4 x 1028 m, Suppose that / 9.0 x 101 electrons/s are drifting through a copper wire. (This is a typical value for a simple circuit.) The diameter of the wire is 1.3 mm. In this case, about how many minutes would it take for a single electron in the electron sea to drift from one end to the other end of a wire 26 cm long? minutes

The density of mobile electrons in copper metal is 8.4 x 1028 m, Suppose that / 9.0 x 101 electrons/s are drifting through a copper wire. (This is a typical value for a simple circuit.) The diameter of the wire is 1.3 mm. In this case, about how many minutes would it take for a single electron in the electron sea to drift from one end to the other end of a wire 26 cm long? minutes

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 10CQ: Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew =...

See similar textbooks

Similar questions

Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
Two conducting wires A and B of the same length and radius are connected across the same potential difference. Conductor A has twice the resistivity of conductor B. What is the ratio of the power delivered to A to the power delivered to B? (a) 2 (b) 2 (c) 1 (d) 12 (e)12
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
A potential difference of 1.00 V is maintained across a 10.0- resistor for a period of 20.0 s. What total charge passes by a point in one of the wires connected to the resistor in this time interval? (a) 200 C (b) 20.0 C (c) 2.00 C (d) 0.005 00 C (e) 0.050 0 C
Explain why R=R0(1 + a?T) for the temperature variation of the resistance R of an object is not as accurate as P=P0(1 + a?T) which gives the temperature variation of resistivity P.
Review. When a straight wire is warmed, its resistance is given by R = R0,[1 + a(T T0)] according to Equation 27.20, where a is the temperature coefficient of resistivity. This expression needs to be modified if we include the change in dimensions of the wire due to thermal expansion. For a copper wire of radius 0.100 0 mm and length 2.000 m, find its resistance at 100.0C, including the effects of both thermal expansion and temperature variation of resistivity. Assume the coefficients are known to four significant figures.
If two resistors with resistances R1 and R2 are connected in parallel, then the total resistance R, measured in ohms (Ω), is given by 1/R =1/R1 + 1/R2. If R1 and R2 are increasing at rates of 0.3 Ω/s and 0.2 Ω/s, respectively, how fast (in Ω/s) is R changing when R1 = 80 Ω and R2 = 100 Ω?
where V1 = V2 = 2.00 V. How much work are the batteries in the circuit doing in every 10.0-s time interval?
Consider following circuit with R1 = 62 Ω, R2 = 11 Ω, R3 = 62 / 10 Ω, R4 = 11/10 Ω and and ξ=11 V i. Cross sections through two long conductors of the same length and material, with square crosssections of edge lengths are shown below. Conductor Y fits snugly within conductor X, Rank theresistance of X and Y?
A straight, cylindrical wire lying along the x axis has a length of 0.515 m and a diameter of 0.195 mm. It is made of a material described by Ohm's law with a resistivity of ? = 4.00 ✕ 10−8 Ω · m. Assume a potential of 4.00 V is maintained at the left end of the wire at x = 0. Also assume V = 0 at x = 0.515 m. (a) Find the magnitude (in V/m) and direction of the electric field in the wire. (b) Find the resistance of the wire (in Ω). (c) Find the magnitude (in A) and direction of the electric current in the wire. (d) Find the current density in the wire (in MA/m2). See image for the full question.
Two capacitors of capacitance 3C and 5C (where C = 0.11 F) are connected in series with a resistor of resistance R = 7.5 Ω. R = 7.5 ΩC = 0.11 F How long will it take the amount of charge in the circuit to drop by 75% in seconds?