The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor isR- 5.20 0, and a 2.50-T magnetic field is directed perpendicutarty downward, into the page. Lett-1.20 m.(a) Calculate the applied force required to move the bar to the right at a constant speed of 1.70 m/s.N (to the right)(b) M what rate is energy delivered to the resistor?

Given, Resistance=5.2ohm Magnetic field=2.5T Length=1.20m Velocity=1.7m/s

The figure below shows a top view of a bar that can slide on two frictioniess rails. The resistor is A-5.20 0, and a 2.50-T magnetic feld is directed perpendicularly downward, into the page. Let t 1.20 m. (a) Calculate the applied force required to move the bar to the right at a constant speed of 1.70 m/s. N (to the right) (b) M what rate is energy delivered to the resistor?

The figure below shows a top view of a bar that can slide on two frictioniess rails. The resistor is A-5.20 0, and a 2.50-T magnetic feld is directed perpendicularly downward, into the page. Let t 1.20 m. (a) Calculate the applied force required to move the bar to the right at a constant speed of 1.70 m/s. N (to the right) (b) M what rate is energy delivered to the resistor?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter32: Faraday’s Law Of Induction

Section: Chapter Questions

Problem 71PQ: Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor,...

See similar textbooks

Similar questions

12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
Sketch a plot of the magnitude of the magnetic field as a function of position r for a coax (Fig. P31.27).
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
Is the work required to accelerate a rod from rest to a speed v in a magnetic field greater than the final kinetic energy of the rod? Why?
Sodium ions (Na+) move at 0.851 m/s through a blood-stream in the arm of a person standing near a large magnet. The magnetic field has a strength of 0.254 T and makes an angle of 51.0 with the motion of the sodium ions. The arm contains 100 cm3 of blood with a concentration of 3.00 1020 Na+ ions per cubic centimeter. If no other ions were present in the arm, what would be the magnetic force on the arm?
A toroid with a square cross section 3.0cm3.0cm has an inner radius of 25.0 cm. It is wound with 500 turns of wire, and it carries a current of 2.0 A. What is the strength of the magnetic field at the center of the square cross section?
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?