The figure below shows an end view of a single-turn square loop of metal wire in the center of and coaxial with a very long solenoid with a circular cross section. The solenoid is 15.0 cm long, has a radius r = 3.00 cm, and consists of 96 turns of wire. The length of each side of the square loop is { = 1.50 cm. (a) The current in the solenoid is 2.00 A. What is the magnetic flux through the square loop (in T: m2)? T.m2 (b) The current decreases from 2.00 A to zero in 2.00 s. What is the magnitude of the average induced emf in the square loop (in V) over this time?

The figure below shows an end view of a single-turn square loop of metal wire in the center of and coaxial with a very long solenoid with a circular cross section. The solenoid is 15.0 cm long, has a radius r = 3.00 cm, and consists of 96 turns of wire. The length of each side of the square loop is { = 1.50 cm. (a) The current in the solenoid is 2.00 A. What is the magnetic flux through the square loop (in T: m2)? T.m2 (b) The current decreases from 2.00 A to zero in 2.00 s. What is the magnitude of the average induced emf in the square loop (in V) over this time?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter22: Magnetic Forces And Magnetic Fields

Section: Chapter Questions

Problem 55P: A single-turn square loop of wire, 2.00 cm on each edge, carries a clockwise current of 0.200 A. The...

See similar textbooks

Similar questions

Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
(a) At what angle (is the torque on a current loop 90.0% of maximum? (b) 50.0% of maximum? (c) 10.0% of maximum?
Solenoid A has length L and N turns, solenoid B has length 2L and N turns, and solenoid C has length L/2 and 2N turns. If each solenoid carries the same current, rank the magnitudes of the magnetic fields in the centers of the solenoids from largest to smallest.
A solenoid is 40 cm long, has a diameter of 3.0 cm, and is wound with 500 turns. If the current through the windings is 4.0 A, what is the magnetic field at a point on the axis of the solenoid that is (a) at the center of the solenoid, (b) 10.0 cm from one end of the solenoid, and (c) 5.0 cm from one end of the solenoid? (d) Compare these answers with the infinite-solenoid case.
, (a) At what angle 0 is tlie torque on a current loop 90.0% of maximum? (b) 50.0% of maximum? (c) 10.0% of maximum?
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
Consider a solenoid that is very long compared with its radius. Of the following choices, what is the most effective way to increase the magnetic field in the interior of the solenoid? (a) double its length, keeping the number of turns per unit length constant (b) reduce its radius by half, keeping the number of turns per unit length constant (c) overwrap the entire solenoid with an additional layer of current-carrying wire
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the current flowing through a rectangular toroid when the energy in its magnetic field is 2.0 × 10-6 J?
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ23.9. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative.
A square loop whose sides are 6.0-cm long is made with copper wire of radius 1.0 mm. If a magnetic field perpendicular to the loop is changing at a rate of 5.0 mT/s, what is the current in the loop?