The figure shows the cross section of an un-symmetric wide flange beam (W-shape). It is composed of three rectangles, the dimensions of which are shown on the figure (the units are mm). Calculate the area moment of inertia of this cross section with respect to centroidal axes parallel and perpendicular to the bottom side AB.

The figure shows the cross section of an un-symmetric wide flange beam (W-shape). It is composed of three rectangles, the dimensions of which are shown on the figure (the units are mm). Calculate the area moment of inertia of this cross section with respect to centroidal axes parallel and perpendicular to the bottom side AB.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.17P: A W867 section is joined to a C1020 section to form a structural member that has the cross section...

See similar textbooks

Similar questions

A W867 section is joined to a C1020 section to form a structural member that has the cross section shown. Calculate Ix and Iy for this cross section. (See Probs. 9.13 and 9.16 for the properties of the structural sections.)
Determine the principal moments of inertia for the beam’s cross-sectionalthe area is shown in Figure with respect to an axis passing through the centroid C.
Determine the Moment of inertia for the singly-symmetrical cross-section shown in figure
Determine the moment of inertia of the cross-sectional area of the beam below, inrelation to a horizontal axis that passes through the centroid C of the figure. Disregard thedimensions of the weld corners in A and B for these calculations. Consider the x-axispassing at the base of the beam.
For the L5 x 3 x 1/2-in. angle cross section shown, use Mohr’s circle to determine (a) the moments of inertia and the product of inertia with respect to new centroidal axes obtained by rotating the x and y axes 30° clockwise, (b) the orientation of the principal axes through the centroid and the corresponding values of the moments of inertia.
6) A C-section is made up of three rectangles as shown in Figure. Find (i) The centroid of a section (ii) The moment of inertia of the section about X-X axis passing through its centroid.
A T-beam with drawn x and y axis is shown in the picture. Determine the moments of inertia of the beam.
The figure shows the cross section of a standard L100 X 80 X 10 mm structural steel, unequal angle section. Compute the maximum and minimum moment of inertia along the principal axis passing thru the centroid of the section.
Thank you in advance Sandwich Section (3 Face Plates) has the following dimensions. Use the Face Sheets only in your calculations, t1 = 0.9, t2 = 8.6, t3 = 1.1, t4 = 0.70 Total = 11.3, and W = 14” Calculate the Moment of Inertia, Ix-x for the Cross Section based on the 3 face sheets, only: NA = __________in. Ix-x = ___________________ in4 (4 digits)
The shaded area has the following properties: Ix=1.26x10^6 mm^4, Iy=6.55x10^5 mm^4, Pxy=-1.02x10^5 mm^4 Determine the maximum moment of inertia and the minimum moment of inertia
A simply supported beam L meters long carries a uniformly distributed load of 21KN/m over its entire length and has the cross section shown . Find the moment of inertia of the given section in____ x106. All given dimensions are in mm.
In the Figure below, determine the moment of inertia of the illustrated region